2002 Acura CL Ignition Parts

This table covers the sensors that report camshaft position to the ECU. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

17 Camshaft Position Sensor parts for the 2002 Acura CL come from 16 brands — STANDARD MOTOR PRODUCTS, FAMOUS BRAND, BWD/NIEHOFF and 13 other brands. The "Popular" part is FAMOUS BRAND CSA1338.

The Economy section lists 10 options from FAMOUS BRAND, BWD/NIEHOFF, DORMAN and 7 other brands — the catalog's value-priced group. FAMOUS BRAND CSA1338 is listed in this group.

In the Standard Replacement grade, ASTEMO / HITACHI, DELPHI, STANDARD MOTOR PRODUCTS and 4 other brands supply 7 parts: built to original-equipment specification. A representative part number is ASTEMO / HITACHI CPS0039.

This table covers the seals at the Camshaft Position Sensor. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2002 Acura CL — MAHLE / CLEVITE 76757.

This table covers the sensors that report crankshaft position and engine speed. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

14 Crankshaft Position Sensor parts for the 2002 Acura CL come from 13 brands — STANDARD MOTOR PRODUCTS, BWD/NIEHOFF, DORMAN and 10 other brands. The "Popular" part is ASTEMO / HITACHI CPS0045.

The Economy section: 8 options from BWD/NIEHOFF, DORMAN, FAMOUS BRAND and 5 other brands. BWD/NIEHOFF CSS853 is listed in this group.

Standard Replacement: 6 parts, from ASTEMO / HITACHI, DELPHI, STANDARD MOTOR PRODUCTS and 3 other brands. A representative part number is ASTEMO / HITACHI CPS0045.

This table covers the seals at the Crankshaft Position Sensor. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2002 Acura CL — FEL-PRO 72301.

This table covers the coils that fire each spark plug. Typical signs include a misfire that follows one cylinder, a snap in damp weather, or a coil that is swollen or cracked. Swap a suspect coil with a neighbor to confirm, then replace boots that tore on the way off. Read more

23 Ignition Coil parts for the 2002 Acura CL come from 19 brands — STANDARD MOTOR PRODUCTS, WALKER PRODUCTS, FVP and 16 other brands. The "Popular" part is FVP UF242F.

The Economy section: 10 options from FVP, SKP, ULTRA-POWER and 7 other brands. FVP UF242F is listed in this group.

The Full Service Kit section lists 1 option from WALKER PRODUCTS — grouped under the catalog's "Full Service Kit" designation — the notes column spells out what sets them apart. WALKER PRODUCTS 92192012 is listed in this group.

In the Premium grade, STANDARD MOTOR PRODUCTS and DELPHI supply 3 parts: a step above OE specification in materials, tolerances or warranty terms. A representative part number is DELPHI GN10168.

Standard Replacement: 9 parts, from WALKER PRODUCTS, ACKOJA, BECK/ARNLEY and 5 other brands. A representative part number is WALKER PRODUCTS 9212012.

This table covers the lock cylinders in the ignition switch. Read more

2 Ignition Lock Cylinder parts for the 2002 Acura CL come from 2 brands — STANDARD MOTOR PRODUCTS and WELLS.

Part numbers include STANDARD MOTOR PRODUCTS US508 and WELLS 4H1319.

This table covers the spark plugs for this engine. Typical signs include misfire under load, rough idle, or a flashing check-engine light. Verify the gap even on pre-gapped plugs, and replace coil boots that come off a high-mileage engine. Read more

29 Spark Plug parts are listed for the 2002 Acura CL, from NGK, DENSO, BOSCH and 2 other brands. NGK 2262 carries the "Popular" badge. Grades run from Copper / Nickel through Ruthenium (maximum durability & ignitability); Iridium (lasts up to 4x longer than Copper / Nickel) is the most populated section, led by NGK, DENSO, BOSCH and 1 other brand.

This table covers the silicone and rubber boots that insulate the coil-to-plug spark path. Typical signs include a misfire in the rain, carbon tracking on the boot, or a snap when you pop the coil off. Replace boots as a set on a high-mileage engine; one cracked boot will take the coil with it. Read more

5 Spark Plug / Ignition Coil Boot parts for the 2002 Acura CL come from 4 brands — STANDARD MOTOR PRODUCTS, WALKER PRODUCTS, ACDELCO and 1 other brand. The "Popular" part is STANDARD MOTOR PRODUCTS SPP155E.

The Economy section: 2 options from STANDARD MOTOR PRODUCTS and WALKER PRODUCTS. STANDARD MOTOR PRODUCTS 19581 is listed in this group.

Standard Replacement: 3 parts, from STANDARD MOTOR PRODUCTS, ACDELCO and NGK. A representative part number is STANDARD MOTOR PRODUCTS SPP155E.

Part numbers include STANDARD MOTOR PRODUCTS SPP155E, STANDARD MOTOR PRODUCTS 19581 and WALKER PRODUCTS 900P2123, among others listed above.

This table covers the seals at the Spark Plug Tube. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Spark Plug Tube Seal parts for the 2002 Acura CL come from 3 brands — BECK/ARNLEY, ELRING and MAHLE / CLEVITE.

This group includes BECK/ARNLEY 0396579, ELRING 389210 and MAHLE / CLEVITE GS33778.