2025 Audi SQ8 Engine Parts

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: MAHLE / CLEVITE 67830.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2025 Audi SQ8 — ELRING 390813.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

This group shows a single part: PIONEER 610215.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

9 Oil parts for the 2025 Audi SQ8 come from 3 brands — PENTOSIN, LIQUI MOLY and VAICO. The "Popular" part is PENTOSIN 8042206.

This group includes PENTOSIN 8042206, PENTOSIN 8044206 and LIQUI MOLY 22120 and the remaining parts above.

This table covers the drain plugs in the oil pan. Read more

2 Oil Drain Plug parts for the 2025 Audi SQ8 come from REIN.

This group includes REIN HWP1014 and REIN HWU1014.

This table covers the caps on the oil filler neck. Read more

This group shows a single part: MOTORAD MO153.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

8 Oil Filter parts for the 2025 Audi SQ8 come from 8 brands — CHAMP / LUBER-FINER, ULTRA-POWER, HENGST and 5 other brands. The "Popular" part is HENGST E914HD398.

The Economy section lists 2 options from CHAMP / LUBER-FINER and ULTRA-POWER — the catalog's value-priced group. CHAMP / LUBER-FINER P1074 is listed in this group.

In the Standard Replacement grade, HENGST, WIX, ACDELCO and 3 other brands supply 6 parts: built to original-equipment specification. A representative part number is HENGST E914HD398.

Listed part numbers: HENGST E914HD398, CHAMP / LUBER-FINER P1074 and ULTRA-POWER WL10438, plus the other parts above.

This table covers the Oil Filter covers. Read more

One part is listed for the 2025 Audi SQ8 — MOTORAD MO374.

This table covers the Oil Filter housings. Read more

One part is listed for the 2025 Audi SQ8 — REIN HEU0119.

This table covers the Oil Level Sensor Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

This group shows a single part: AJUSA 01899000.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Valve Stem Seal parts for the 2025 Audi SQ8 come from MAHLE / CLEVITE.

This group includes MAHLE / CLEVITE SS45940A and MAHLE / CLEVITE SS46126.

This table covers the oil-control solenoids that command the cam phasers. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

This group shows a single part: VNE 4022007.