1952 Fargo FO1 Pickup Cooling System Parts

This table covers the engine coolants and antifreeze formulations specified for this cooling system. Typical signs include a rising temperature gauge, rusty or sludged coolant, or a heater that blows cold. Use the chemistry named in the notes. Mixing silicate, OAT and HOAT formulas can gel in the radiator. Read more

16 Coolant / Antifreeze parts for the 1952 Fargo FO1 Pickup come from 4 brands — PEAK, PRESTONE, FVP and 1 other brand. The "Popular" part is FVP MV5050GAL.

In the Compatible With All Colors grade, PRESTONE supplies 1 part: grouped under the catalog's "Compatible With All Colors" designation — the notes column spells out what sets them apart. A representative part number is PRESTONE AF3055.

The Economy section lists 4 options from FVP, PRESTONE, PEAK and 1 other brand — the catalog's value-priced group. FVP MV5050GAL is listed in this group.

In the Heavy Duty grade, PRESTONE supplies 1 part: rated for severe service. A representative part number is PRESTONE AFC12100.

In the Premium grade, PRESTONE and PEAK supply 4 parts: a step above OE specification in materials, tolerances or warranty terms. A representative part number is PRESTONE AF2100.

In the Standard Replacement grade, PEAK, PRESTONE and FVP supply 6 parts: built to original-equipment specification. A representative part number is PRESTONE AF3300.

This table covers the upper, lower and connecting hoses between radiator, engine and reservoir. Typical signs include swelling, cracks, a soft spot, or a leak at a clamp. Replace adjacent aged hoses while the system is drained — they share the same heat cycle. Read more

6 Radiator Hose parts are listed for the 1952 Fargo FO1 Pickup, from ACDELCO and GATES. ACDELCO 31637 carries the "Popular" badge.

Economy: 4 parts, from ACDELCO and GATES. A representative part number is ACDELCO 31637.

The Standard Replacement section: 2 options from ACDELCO and GATES. ACDELCO 20001S is listed in this group.

Listed part numbers: ACDELCO 31637, GATES 25478 and ACDELCO 31740, plus the other parts above.

This table covers the thermostats that open the coolant circuit at the specified temperature. Typical signs include slow warm-up, a gauge that climbs in traffic, or heat that never quite arrives. Replace the housing gasket with the thermostat and bleed the system so a trapped air pocket does not cook the new part. Read more

GATES supplies the 3 Thermostat parts for the 1952 Fargo FO1 Pickup.

This group includes GATES 33036, GATES 33038 and GATES 33039.

This table covers the seals at the thermostat housing and water outlet. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Thermostat / Thermostat Housing / Water Outlet Seal parts for the 1952 Fargo FO1 Pickup come from 4 brands — FEL-PRO, GATES, MAHLE / CLEVITE and 1 other brand.

Part numbers include FEL-PRO 35063, GATES 33625 and MAHLE / CLEVITE C24109, among others listed above.

This table covers the pumps that circulate coolant through the block and radiator. Typical signs include coolant at the weep hole, pulley play, or a growl from the front of the engine. Replace the thermostat and refill with the specified coolant whenever the pump comes off. Read more

One part is listed for the 1952 Fargo FO1 Pickup — GATES 42554.

This table covers the gaskets between the water pump and the block or housing. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: VICTOR REINZ 711407900.