2008 Faw F1 Engine Parts

Engine:
1000cc L3

The 2008 Faw F1 has 7 engine parts with verified fitment on this page — 5 part types and 2 brands, covering the 1000cc L3 engine. Each part includes a manufacturer part number and application notes.

On the 2008 Faw F1, the engine covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components. Most of the listed parts are Crankshaft Seal (2 parts), Oil Filter (2 parts) and Cylinder Head Gasket (1 part). The other 2 part types cover the remaining 2 parts.

Crankshaft Seal

Brand Part Number Markets Notes Buy
ELRING 576320
🇲🇽 MX
with Dust Lip
Fitment notes — ELRING 576320
with Dust Lip
Front
View on
Amazon
ELRING 092170
🇲🇽 MX
Transmission Side
View on
Amazon

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.

Cylinder Head Gasket

Brand Part Number Markets Notes Buy
ELRING 529680
🇲🇽 MX
1.35mm Thickness
View on
Amazon

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.

Oil Filter

Economy

Brand Part Number Markets Notes Buy
VARIOUS MFR PG4476
🇲🇽 MX
Spin-On
View on
Amazon

Standard Replacement

Brand Part Number Markets Notes Buy
VARIOUS MFR PG4476EX
🇲🇽 MX
Extended LifeSpin-On
View on
Amazon

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive.

Valve Cover Gasket

Brand Part Number Markets Notes Buy
ELRING 578428
🇲🇽 MX
View on
Amazon

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.

Valve Stem Seal

Brand Part Number Markets Notes Buy
ELRING 069550
🇲🇽 MX
View on
Amazon

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.

Buying Engine Parts for a 2008 Faw F1

On this vehicle, the engine covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components.

  • Confirm you have the 1000cc L3 engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Crankshaft Seal and Oil Filter .

Frequently Asked Questions

How many engine parts fit the 2008 Faw F1?

Our catalog currently lists 7 engine parts for the 2008 Faw F1 across 5 subcategories and 2 brands, covering the 1000cc L3 engine. Each part is matched to the engine(s) it fits.

What are the signs of engine problems on a 2008 Faw F1?

Common symptoms include oil spots under the vehicle, blue or white exhaust smoke, ticking from the valvetrain, or coolant mysteriously disappearing. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2008 Faw F1 was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 2008 Faw F1?

Every part on this page is matched to the 1000cc L3 engine. Then engine hard parts are unforgiving of guesswork — confirm the casting or engine code before ordering, because one model year can hide two different blocks. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 2008 Faw F1

Engine Parts for Other Faw F1 Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.