2009 Faw F1 Electrical Parts

Engine:
1000cc L3

This page lists one electrical part for the 2009 Faw F1: a Tachometer Sensor from DORMAN, matched to the 1000cc L3 — the only engine offered in the 2009 Faw F1.

On the 2009 Faw F1, the electrical system covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors.

Tachometer Sensor

Brand Part Number Markets Notes Buy
DORMAN 5055506
🇲🇽 MX
Except Magnum 430HPwithout Eaton Transmission
View on
Amazon

This table covers the Tachometer sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors.

Buying Electrical Parts for a 2009 Faw F1

On this vehicle, the electrical system covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors.

  • Confirm you have the 1000cc L3 engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Tachometer Sensor .

Frequently Asked Questions

How many electrical parts fit the 2009 Faw F1?

This page lists one electrical part for the 2009 Faw F1: a Tachometer Sensor from DORMAN, covering the 1000cc L3 engine.

What are the signs of electrical problems on a 2009 Faw F1?

Common symptoms include slow cranking on cold mornings, a battery light that flickers, dim lights at idle, or a check-engine code pointing at a sensor circuit. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2009 Faw F1 was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 2009 Faw F1?

Every part on this page is matched to the 1000cc L3 engine. Then test before replacing — a failed alternator and a bad ground can look identical, and sensors are frequently condemned for wiring faults. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 2009 Faw F1

Electrical Parts for Other Faw F1 Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.