This page lists one drivetrain part for the 1963 Fiat 1200: an Axle Shaft Bearing from CENTRIC, matched to the 1.2L L4 — the only engine offered in the 1963 Fiat 1200.
On the 1963 Fiat 1200, the drivetrain system moves power from transmission to wheels through axles, CV joints, driveshafts, differentials and wheel-end hardware.
The part number opens a page with every vehicle that part fits.
Axle Shaft Bearing
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| CENTRIC | 41190002E | 🇺🇸 US | C-TEK | View on Amazon |
This table covers the Axle Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly.
This group shows a single part: CENTRIC 41190002E.
Buying Drivetrain Parts for a 1963 Fiat 1200
On this vehicle, the drivetrain system moves power from transmission to wheels through axles, CV joints, driveshafts, differentials and wheel-end hardware.
- Confirm you have the 1.2L L4 engine — every part on this page is matched to it.
- Read the notes on each row for position, trim and spec qualifiers before you order.
- Where labor overlaps, replace the differential or transfer-case fluid with any axle or seal job while everything is already open.
- Cross-reference the manufacturer part number against your old part or a service-manual listing.
Start with the largest groups on this page: Axle Shaft Bearing .
Frequently Asked Questions
How many drivetrain parts fit the 1963 Fiat 1200?
This page lists one drivetrain part for the 1963 Fiat 1200: an Axle Shaft Bearing from CENTRIC, covering the 1.2L L4 engine.
What are the signs of drivetrain problems on a 1963 Fiat 1200?
Common symptoms include clicking in tight turns, a clunk when shifting between drive and reverse, vibration that builds with speed, or gear oil on the inside of a wheel. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.
What should I replace at the same time?
Where labor overlaps, replace the differential or transfer-case fluid with any axle or seal job while everything is already open.
What do the market flags (US, CA, MX) on each part mean?
They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1963 Fiat 1200 was originally sold in the US, the safest choice is a part marked for the US market.
How do I make sure a part fits my 1963 Fiat 1200?
Every part on this page is matched to the 1.2L L4 engine. Then a torn CV boot caught early is a cheap boot kit; caught late it is a whole axle — inspect before deciding which to buy. The notes column carries position and trim qualifiers where they apply.
Other Parts for the 1963 Fiat 1200
Drivetrain Parts for Other Fiat 1200 Years
Switch vehicle or jump to a subcategory
Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.