2020 GMC Yukon Steering Parts

This table covers the Coupling boots. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

3 Coupling Boot parts are listed for the 2020 GMC Yukon, from GM GENUINE and DORMAN.

Part numbers include DORMAN 425000, GM GENUINE 19436338 and GM GENUINE 19177403.

This table covers the steering knuckles that carry the hub, caliper and ball joints. Read more

GM GENUINE supplies the 4 Knuckle parts for the 2020 GMC Yukon.

This group includes GM GENUINE 22842314, GM GENUINE 22842315 and GM GENUINE 23242660 and the remaining parts above.

This table covers the Power Steering Assist Motor modules. Typical signs include a cluster of unrelated faults, a no-communication code, or a module that will not sleep. Confirm power, ground and programming compatibility in the notes. Modules are rarely plug-and-play across years. Read more

GM GENUINE supplies both parts for the 2020 GMC Yukon.

This group includes GM GENUINE 84774205 and GM GENUINE 19420216.

This table covers the steering gear assemblies that turn the tie rods. Typical signs include fluid at a torn boot, a growl when you turn, or play that the inner tie rods do not explain. Flush the old power-steering fluid with the rack — grit in the old fluid is the usual cause of a repeat leak. Read more

4 Rack and Pinion parts are listed for the 2020 GMC Yukon, from GM GENUINE, AAE and TERREPOWER.

In the New grade, GM GENUINE supplies 1 part: brand-new units rather than rebuilt ones. A representative part number is GM GENUINE 86553014.

In the Remanufactured grade, AAE, GM GENUINE and TERREPOWER supply 3 parts: factory-rebuilt units with new wear components. A representative part number is AAE ER4132.

Part numbers include GM GENUINE 86553014, AAE ER4132 and GM GENUINE 19417065, among others listed above.

This table covers the rubber boots that seal the inner tie-rod joints on the rack. Read more

2 Rack and Pinion Bellow parts for the 2020 GMC Yukon come from GM GENUINE.

This group includes GM GENUINE 22834081 and GM GENUINE 86570735.

This table covers the Rack and Pinion Belt kits. Read more

This group shows a single part: EDELMANN 9600.

This table covers the Rack and Pinion bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

One part is listed for the 2020 GMC Yukon — GM GENUINE 84234960.

This table covers the steering columns. Read more

GM GENUINE supplies both parts for the 2020 GMC Yukon.

This group includes GM GENUINE 84634676 and GM GENUINE 23381949.

This table covers the seals at the Steering Column / Firewall. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2020 GMC Yukon — GM GENUINE 25815601.

This table covers the Steering Column bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 2020 GMC Yukon — GM GENUINE 26001827.

This table covers the Steering Column Bolt screws. Typical signs include a rounded head, a seeping bleeder, or a fastener that will not hold torque. Do not force a new screw into a stripped hole — repair the thread first. Read more

GM GENUINE supplies both parts for the 2020 GMC Yukon.

Listed part numbers: GM GENUINE 11547345 and GM GENUINE 11569993.

This table covers the brackets that mount the Steering Column. Typical signs include a cracked mount, a rattle, or a bracket that no longer holds alignment. Confirm position in the notes. Many brackets look alike and bolt to different corners. Read more

One part is listed for the 2020 GMC Yukon — GM GENUINE 84176593.

This table covers the Steering Column control modules. Read more

This group shows a single part: GM GENUINE 22834648.

This table covers the Steering Column Lock actuators. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

One part is listed for the 2020 GMC Yukon — GM GENUINE 23303625.

This table covers the Steering Column Pivot pins. Read more

2 Steering Column Pivot Pin parts for the 2020 GMC Yukon come from GM GENUINE.

Part numbers include GM GENUINE 26036521 and GM GENUINE 84643905.

This table covers the Steering Column springs. Typical signs include a sagging corner, a broken coil, or a clunk from the spring pocket. Replace springs in axle pairs and inspect the seats. Read more

This group shows a single part: GM GENUINE 26055299.

This table covers the Steering Column Switch housings. Read more

This group shows a single part: GM GENUINE 26086181.

This table covers the Steering Gear bolts. Read more

One part is listed for the 2020 GMC Yukon — GM GENUINE 11569939.

This table covers the Steering Gear housings. Read more

One part is listed for the 2020 GMC Yukon — GM GENUINE 22834076.

This table covers the Steering shafts. Read more

5 Steering Shaft parts are listed for the 2020 GMC Yukon, from DORMAN, GM GENUINE and SKP. DORMAN 425183 carries the "Popular" badge.

Part numbers include DORMAN 425183, DORMAN 425120 and GM GENUINE 85104192, among others listed above.

This table covers the Steering Shaft Lock rings. Read more

This group shows a single part: GM GENUINE 26090892.

This table covers the Steering Wheel Nut rings. Read more

This group shows a single part: GM GENUINE 11609658.

This table covers the Steering Wheel position sensors. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

3 Steering Wheel Position Sensor parts are listed for the 2020 GMC Yukon, from GM GENUINE, STANDARD MOTOR PRODUCTS and WELLS.

Listed part numbers: GM GENUINE 13590209, STANDARD MOTOR PRODUCTS SWS112 and WELLS 5S13868.

This table covers the inner and outer tie-rod ends that steer each front knuckle. Typical signs include play on center, a feathered front tire, or a boot that has split and packed with grit. Replace inner and outer ends together on a high-mileage axle, then get an alignment. Read more

24 Tie Rod End parts for the 2020 GMC Yukon come from 10 brands — MEVOTECH, DORMAN, GM GENUINE and 7 other brands. The "Popular" part is GM GENUINE 22834082.

In the Daily Driver grade, GM GENUINE, MEVOTECH, MOOG and 4 other brands supply 14 parts: grouped for everyday commuting duty. A representative part number is GM GENUINE 22834082.

The Economy section lists 7 options from MEVOTECH, DORMAN, QUICK STEER and 1 other brand — the catalog's value-priced group. MEVOTECH GS50770 is listed in this group.

In the Heavy Duty grade, DORMAN supplies 2 parts: rated for severe service. A representative part number is DORMAN TO90275RD.

In the Premium grade, MEVOTECH supplies 1 part: a step above OE specification in materials, tolerances or warranty terms. A representative part number is MEVOTECH TXMS50630.

This table covers the Tie Rod nuts. Read more

2 Tie Rod Nut parts for the 2020 GMC Yukon come from GM GENUINE.

Listed part numbers: GM GENUINE 11609283 and GM GENUINE 11562065.