1960 Humber Super Snipe Automatic Transmission Parts

Engine:
3.0L L6

3 Automatic transmission parts are listed for the 1960 Humber Super Snipe, in 3 part types, covering the 3.0L L6 engine. Each one has a brand, a manufacturer part number and notes that say where it fits.

The automatic transmission on the 1960 Humber Super Snipe covers the automatic gearbox and its supporting cast — filters, coolers, solenoids, mounts and torque-converter parts. All 3 listed parts are O-Rings & Seals (1 part), Output Shaft Seal (1 part) and Repair Sleeve (1 part).

O-Rings & Seals

Brand Part Number Markets Notes Buy
SCHAEFFLER SS2611
🇺🇸 US
Rearwith 1.563 In Shaft
Fitment notes — SCHAEFFLER SS2611
Rearwith 1.563 In Shaft12.7 mm Width
View on
Amazon

This table covers the O-rings and seals at this joint.

Output Shaft Seal

Brand Part Number Markets Notes Buy
SKF 15620
🇺🇸 US
Rear
View on
Amazon

This table covers the seals at the Output Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.

Repair Sleeve

Brand Part Number Markets Notes Buy
SCHAEFFLER SR3482
🇺🇸 US
Rearwith 1.563 In Shaft
View on
Amazon

This table covers the wear sleeves used to restore a grooved seal surface.

Buying Automatic Transmission Parts for a 1960 Humber Super Snipe

On this vehicle, the automatic transmission covers the automatic gearbox and its supporting cast — filters, coolers, solenoids, mounts and torque-converter parts.

  • Confirm you have the 3.0L L6 engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, replace the filter and pan gasket with every fluid service, and flush the cooler lines when replacing a failed unit.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: O-Rings & Seals and Output Shaft Seal .

Frequently Asked Questions

How many automatic transmission parts fit the 1960 Humber Super Snipe?

Our catalog currently lists 3 automatic transmission parts for the 1960 Humber Super Snipe across 3 subcategories and 2 brands, covering the 3.0L L6 engine. Each part is matched to the engine(s) it fits.

What are the signs of automatic transmission problems on a 1960 Humber Super Snipe?

Common symptoms include delayed or harsh engagement, slipping under load, fluid that smells burnt, or shuddering at light throttle around 40 mph. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, replace the filter and pan gasket with every fluid service, and flush the cooler lines when replacing a failed unit.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1960 Humber Super Snipe was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 1960 Humber Super Snipe?

Every part on this page is matched to the 3.0L L6 engine. Then use exactly the fluid specification in the notes — automatic transmissions are the least forgiving component on the vehicle about fluid choice. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 1960 Humber Super Snipe

Automatic Transmission Parts for Other Humber Super Snipe Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.