2018 Jeep Renegade Steering Parts

This table covers the steering knuckles that carry the hub, caliper and ball joints. Read more

14 Knuckle parts for the 2018 Jeep Renegade come from 3 brands — MOPAR, DORMAN and APWI. The "Popular" part is DORMAN 686323.

In the Daily Driver grade, MOPAR supplies 5 parts: grouped for everyday commuting duty. A representative part number is MOPAR 4787958AA.

The Economy section lists 4 options from DORMAN and APWI — the catalog's value-priced group. DORMAN 686323 is listed in this group.

5 further parts sit outside the graded sections, with the same engine-level match.

This table covers the steering gear assemblies that turn the tie rods. Typical signs include fluid at a torn boot, a growl when you turn, or play that the inner tie rods do not explain. Flush the old power-steering fluid with the rack — grit in the old fluid is the usual cause of a repeat leak. Read more

7 Rack and Pinion parts for the 2018 Jeep Renegade come from 6 brands — TERREPOWER, EDELMANN, LARES and 3 other brands. The "Popular" part is EDELMANN 57143. 5 parts fit every engine; the other 2 are engine-specific.

The New section lists 6 options from EDELMANN, LARES, MOPAR and 3 other brands — brand-new units rather than rebuilt ones. EDELMANN 57143 is listed in this group.

The Remanufactured section lists 1 option from TERREPOWER — factory-rebuilt units with new wear components. TERREPOWER 2020126 is listed in this group.

This group includes EDELMANN 57143, LARES 23975 and MOPAR 68263318AA and the remaining parts above.

This table covers the rubber boots that seal the inner tie-rod joints on the rack. Read more

One part is listed for the 2018 Jeep Renegade — MOPAR 68275051AA.

This table covers the steering columns. Read more

This group shows a single part: MOPAR 68632882AA.

This table covers the brackets that mount the Steering Column. Typical signs include a cracked mount, a rattle, or a bracket that no longer holds alignment. Confirm position in the notes. Many brackets look alike and bolt to different corners. Read more

This group shows a single part: MOPAR 68247386AA.

This table covers the seals at the Steering Column Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

MOPAR supplies both parts for the 2018 Jeep Renegade. All of them fit every engine offered in the 2018 Renegade.

Listed part numbers: MOPAR 4787974AA and MOPAR 68246947AB.

This table covers the Steering Gear Heat shields. Typical signs include a bent shield rubbing a rotor, or rust-through that leaves the backing open. A rubbing shield will eat a new rotor. Straighten or replace it before the wheel goes back on. Read more

2 Steering Gear Heat Shield parts for the 2018 Jeep Renegade come from MOPAR. 1 part fits every engine; the other 1 is engine-specific.

Listed part numbers: MOPAR 68246519AA and MOPAR 68323954AD.

This table covers the Steering shafts. Read more

This group shows a single part: MOPAR 68270836AA.

This table covers the inner and outer tie-rod ends that steer each front knuckle. Typical signs include play on center, a feathered front tire, or a boot that has split and packed with grit. Replace inner and outer ends together on a high-mileage axle, then get an alignment. Read more

25 Tie Rod End parts are listed for the 2018 Jeep Renegade, from MEVOTECH, DELPHI, MOOG and 4 other brands. DELPHI TA3391 carries the "Popular" badge. 20 parts fit every engine; the other 5 are engine-specific.

The Daily Driver section: 14 options from DELPHI, MEVOTECH, MOOG and 2 other brands. DELPHI TA3391 is listed in this group.

Economy: 9 parts, from MEVOTECH, DORMAN and QUICK STEER. A representative part number is MEVOTECH GS25642.

The Premium section lists 2 options from MEVOTECH — a step above OE specification in materials, tolerances or warranty terms. MEVOTECH TXMS25642 is listed in this group.