2008 Kenworth T170 Electrical Parts

Engine:
6.7L L6 DIESEL Turbocharged

The 2008 Kenworth T170 has 4 electrical parts with verified fitment on this page — 2 part types and 2 brands, covering the 6.7L L6 DIESEL Turbocharged engine. Each part includes a manufacturer part number and application notes.

On the 2008 Kenworth T170, the electrical system covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors. All 4 listed parts are Speed Sensor (3 parts) and Alternator / Generator (1 part).

Alternator / Generator

Brand Part Number Markets Notes Buy
TERREPOWER 90014516
🇺🇸 US 🇨🇦 CA
RemanufacturedDoes Not Include Pulley
Fitment notes — TERREPOWER 90014516
RemanufacturedDoes Not Include Pulley
170 AmpsDelco1 Quad Pad Mount36SI HPwith Remote SensePACCAR Engine
View on
Amazon

This table covers the alternators that charge the battery and run the electrical load. Typical signs include dim lights at idle, a battery lamp, or a growl from the charging pulley. Load-test the battery and inspect the belt and grounds — a bad ground mimics a failed alternator.

Speed Sensor

Brand Part Number Markets Notes Buy
DORMAN 5055407
🇺🇸 US 🇨🇦 CA
with Eaton Transmissionwith External Tone Ring
Fitment notes — DORMAN 5055407
with Eaton Transmissionwith External Tone Ringwith 2 Pin ConnectorVehicle Speed
View on
Amazon
DORMAN 5055408
🇺🇸 US 🇨🇦 CA
with Eaton Transmissionwith External Tone Ring
Fitment notes — DORMAN 5055408
with Eaton Transmissionwith External Tone Ringwith 4 Pin ConnectorVehicle Speed
View on
Amazon
DORMAN 5055406
🇺🇸 US 🇨🇦 CA
with Eaton Transmissionwith Internal Tone Ring
Fitment notes — DORMAN 5055406
with Eaton Transmissionwith Internal Tone RingMounts In Tailshaft HousingVehicle Speed
View on
Amazon

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor.

Buying Electrical Parts for a 2008 Kenworth T170

On this vehicle, the electrical system covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors.

  • Confirm you have the 6.7L L6 DIESEL Turbocharged engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Speed Sensor and Alternator / Generator .

Frequently Asked Questions

How many electrical parts fit the 2008 Kenworth T170?

Our catalog currently lists 4 electrical parts for the 2008 Kenworth T170 across 2 subcategories and 2 brands, covering the 6.7L L6 DIESEL Turbocharged engine. Each part is matched to the engine(s) it fits.

What are the signs of electrical problems on a 2008 Kenworth T170?

Common symptoms include slow cranking on cold mornings, a battery light that flickers, dim lights at idle, or a check-engine code pointing at a sensor circuit. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2008 Kenworth T170 was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 2008 Kenworth T170?

Every part on this page is matched to the 6.7L L6 DIESEL Turbocharged engine. Then test before replacing — a failed alternator and a bad ground can look identical, and sensors are frequently condemned for wiring faults. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 2008 Kenworth T170

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.