2008 Kia Rondo Engine Parts

This table covers the chains that drive the balance shafts. Read more

This group shows a single part: PREFERRED COMPONENTS INC C774.

This table covers the Balance Shaft Chain tensioners. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

One part is listed for the 2008 Kia Rondo — PREFERRED COMPONENTS INC T66222.

This table covers the Camshaft plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

3 Camshaft Plug parts for the 2008 Kia Rondo come from 3 brands — FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

Listed part numbers: FEL-PRO CP75023, MAHLE / CLEVITE 67728 and VICTOR REINZ 711237400.

This table covers the wear sleeves used to restore a Camshaft seal surface. Read more

4 Camshaft Repair Sleeve parts are listed for the 2008 Kia Rondo, from NATIONAL, SCHAEFFLER, TIMKEN and 1 other brand.

Part numbers include NATIONAL 99114, SCHAEFFLER SR3463 and TIMKEN KWK99114, among others listed above.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

18 Camshaft Seal parts are listed for the 2008 Kia Rondo, from BCA, FEL-PRO, NATIONAL and 9 other brands. BCA NS223010 carries the "Popular" badge.

This table covers the Circular / Semi-Circular plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

One part is listed for the 2008 Kia Rondo — APEX ACP203.

This table covers the connecting rods between each piston and the crankshaft. Read more

This group shows a single part: TOPLINE CRHY11.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

10 Connecting Rod Bearing parts for the 2008 Kia Rondo come from 5 brands — KING ENGINE BEARINGS, ENGINETECH, TOPLINE and 2 other brands. The "Popular" part is ENGINETECH BB1041.

The High Performance section lists 1 option from KING ENGINE BEARINGS — engineered beyond original-equipment specification. KING ENGINE BEARINGS CR4634XP is listed in this group.

In the Standard Replacement grade, KING ENGINE BEARINGS, ENGINETECH, TOPLINE and 2 other brands supply 6 parts: built to original-equipment specification. A representative part number is ENGINETECH BB1041.

3 further parts sit outside the graded sections, with the same engine-level match.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

12 Conversion / Lower Gasket Set parts for the 2008 Kia Rondo come from 7 brands — FEL-PRO, AJUSA, APEX and 4 other brands. The "Popular" part is FEL-PRO CS263331.

This table covers the crankshafts that turn piston motion into rotation. Read more

This group shows a single part: TOPLINE CSHY11.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

12 Crankshaft Main Bearing parts are listed for the 2008 Kia Rondo, from TOPLINE, KING ENGINE BEARINGS, ENGINETECH and 2 other brands. ENGINETECH BC1030 carries the "Popular" badge.

High Performance: 1 part, from KING ENGINE BEARINGS. A representative part number is KING ENGINE BEARINGS MB5771XP.

The Standard Replacement section: 6 options from TOPLINE, ENGINETECH, KING ENGINE BEARINGS and 2 other brands. ENGINETECH BC1030 is listed in this group.

5 ungrouped parts are not assigned to a grade, with the same engine-level match.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

8 Crankshaft Repair Sleeve parts are listed for the 2008 Kia Rondo, from WJB / INMOTION PARTS, BCA, NATIONAL and 1 other brand.

Part numbers include BCA NS99166, BCA NS99145 and NATIONAL 99166, among others listed above.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

43 Crankshaft Seal parts are listed for the 2008 Kia Rondo, from VICTOR REINZ, FEL-PRO, NATIONAL and 13 other brands. BCA NS224200 carries the "Popular" badge. The notes list position, dimensions and spec qualifiers wherever the manufacturer distinguishes between variants.

This table covers the bolts that clamp the cylinder head to the block. Read more

12 Cylinder Head Bolt parts for the 2008 Kia Rondo come from 7 brands — AJUSA, ENGINETECH, FEL-PRO and 4 other brands. The "Popular" part is AJUSA 81045900.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

18 Cylinder Head Gasket parts for the 2008 Kia Rondo come from 8 brands — AJUSA, FEL-PRO, APEX and 5 other brands. The "Popular" part is AJUSA 10198000.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

16 Cylinder Head Gasket Set parts for the 2008 Kia Rondo come from 7 brands — ENGINETECH, FEL-PRO, APEX and 4 other brands. The "Popular" part is APEX AHS2092.

This table covers the Cylinder Head Spacer shims. Read more

This group shows a single part: SBI 2302206.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

KAT'S HEATERS supplies the 4 Engine Block Heater parts for the 2008 Kia Rondo.

Part numbers include KAT'S HEATERS 11411, KAT'S HEATERS 11812 and KAT'S HEATERS 28812, among others listed above.

This table covers the Engine covers. Read more

6 Engine Cover parts for the 2008 Kia Rondo come from 3 brands — TECHPRO, KIA and VARIOUS MFR. The "Popular" part is TECHPRO KI1228116. 5 parts fit every engine; the other 1 is engine-specific.

Listed part numbers: TECHPRO KI1228116, TECHPRO KI1228117 and KIA 292403E450, plus the other parts above.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

4 Engine Kit Gasket Set parts for the 2008 Kia Rondo come from 3 brands — ENGINETECH, AJUSA and TOPLINE.

Part numbers include AJUSA 50577700, ENGINETECH HY24K1 and ENGINETECH HY27K1, among others listed above.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

11 Exhaust Valve parts are listed for the 2008 Kia Rondo, from MELLING, QUALCAST, TOPLINE and 5 other brands. AUTO 7 6130089 carries the "Popular" badge.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

13 Harmonic Balancer parts for the 2008 Kia Rondo come from 7 brands — SKP, HYUNDAI, ATP and 4 other brands. The "Popular" part is SKP SK594341. 1 part fits every engine; the other 12 are engine-specific.

The Economy section lists 2 options from SKP — the catalog's value-priced group. SKP SK594341 is listed in this group.

Standard Replacement: 9 parts, from ATP, DAYCO, DORMAN and 2 other brands. A representative part number is HYUNDAI 231243E020.

2 further parts sit outside the graded sections, with the same engine-level match.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

14 Intake Manifold Gasket parts for the 2008 Kia Rondo come from 7 brands — FEL-PRO, APEX, MAHLE / CLEVITE and 4 other brands. The "Popular" part is APEX AMS2890.

This table covers the Intake Manifold Runner Control Valve solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

6 Intake Manifold Runner Control Valve / Solenoid parts for the 2008 Kia Rondo come from 5 brands — SKP, ACKOJA, DORMAN and 2 other brands.

This group includes ACKOJA A52630011, DORMAN 911834 and SKP SK913182 and the remaining parts above.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

6 Intake Plenum Gasket parts are listed for the 2008 Kia Rondo, from FEL-PRO, HYUNDAI, AJUSA and 3 other brands. FEL-PRO MS96864 carries the "Popular" badge.

Part numbers include FEL-PRO MS96864, HYUNDAI 292153E000 and AJUSA 01233200, among others listed above.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

9 Intake Valve parts are listed for the 2008 Kia Rondo, from QUALCAST, TOPLINE, SBI and 4 other brands. SBI 13255 carries the "Popular" badge.

Listed part numbers: SBI 13255, AUTO 7 6120081 and ENGINETECH IM4436, plus the other parts above.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

20 Motor Mount parts are listed for the 2008 Kia Rondo, from DEA / MARMON RIDE CONTROL, SKP, WESTAR and 3 other brands. SKP SKM9323 carries the "Popular" badge. 10 parts fit every engine; the other 10 are engine-specific.

Economy: 4 parts, from SKP. A representative part number is SKP SKM9323.

The Standard Replacement section: 16 options from DEA / MARMON RIDE CONTROL, WESTAR, ANCHOR and 2 other brands. ANCHOR 9323 is listed in this group.

This table covers the Motor Mount kits. Read more

One part is listed for the 2008 Kia Rondo — ANCHOR 300380.