2025 Kia Sorento Engine Parts

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 2025 Kia Sorento — TOPLINE RBHY22T.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2025 Kia Sorento — TOPLINE CBSHY26.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

2 Crankshaft Main Bearing parts for the 2025 Kia Sorento come from TOPLINE.

Part numbers include TOPLINE MBHY26 and TOPLINE TWHY26.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Crankshaft Seal parts for the 2025 Kia Sorento come from 2 brands — ELRING and FEL-PRO.

Part numbers include ELRING B06520 and FEL-PRO BS40740.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2025 Kia Sorento — ELRING B06610.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Cylinder Head Gasket Set parts are listed for the 2025 Kia Sorento, from ELRING and TOPLINE.

This group includes ELRING B06600 and TOPLINE HSHY26G.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2025 Kia Sorento — TOPLINE CGSHY26G.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

This group shows a single part: TOPLINE EVHY26.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

This group shows a single part: TOPLINE IVHY26.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

4 Motor Mount parts for the 2025 Kia Sorento come from 2 brands — ANCHOR and WESTAR.

Listed part numbers: ANCHOR 10291, ANCHOR 10251 and WESTAR EM7705, plus the other parts above.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

41 Oil parts for the 2025 Kia Sorento come from 6 brands — LIQUI MOLY, VALVOLINE, MOBIL and 3 other brands. The "Popular" part is LIQUI MOLY 22044. They are grouped as Full Synthetic and High Mileage (>75,000 Miles), with Full Synthetic the largest group at 26 parts from LIQUI MOLY, VALVOLINE, MOBIL and 2 other brands.

This table covers the heat exchangers that cool engine oil. Typical signs include oil at the cooler fittings, or coolant that looks like a milkshake. Pressure-test both circuits after a cooler swap — a leak here mixes oil and coolant. Read more

This group shows a single part: DORMAN 918141.

This table covers the drain plugs in the oil pan. Read more

3 Oil Drain Plug parts for the 2025 Kia Sorento come from 2 brands — DORMAN and REIN. Every part fits all 3 engine options (1.6L L4 ELECTRIC/GAS Turbocharged, 2.5L L4 and 2.5L L4 Turbocharged).

Listed part numbers: DORMAN 090033, DORMAN 090053 and REIN HWU0110.

This table covers the caps on the oil filler neck. Read more

2 Oil Filler Cap parts for the 2025 Kia Sorento come from MOTORAD.

Part numbers include MOTORAD MO151 and MOTORAD MO223.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

18 Oil Filter parts for the 2025 Kia Sorento come from 11 brands — CHAMP / LUBER-FINER, PRO-TEC, FRAM and 8 other brands. The "Popular" part is CHAMP / LUBER-FINER P1086.

The Economy section lists 7 options from CHAMP / LUBER-FINER, PRO-TEC, FVP and 1 other brand — the catalog's value-priced group. CHAMP / LUBER-FINER P1086 is listed in this group.

The High Performance / Heavy Duty section lists 1 option from MOBIL — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. MOBIL M1C158A is listed in this group.

In the Standard Replacement grade, VARIOUS MFR, WIX, HYUNDAI and 4 other brands supply 10 parts: built to original-equipment specification. A representative part number is VARIOUS MFR PO99527EX.

This table covers the Oil Filter covers. Read more

3 Oil Filter Cover parts are listed for the 2025 Kia Sorento, from MOTORAD and HYUNDAI.

Listed part numbers: HYUNDAI 263152J000, MOTORAD MO387 and MOTORAD MO371.

This table covers the Oil Filter housings. Read more

One part is listed for the 2025 Kia Sorento — ACKOJA A520952.

This table covers the seals at the Oil Filter Housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Oil Filter Housing Seal parts for the 2025 Kia Sorento come from ELRING.

This group includes ELRING B06530 and ELRING B07000.

This table covers the Oil Level sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: KIA 215902S000.

This table covers the Oil pumps. Typical signs include noise from the pump, no pressure, or fluid that never arrives at the outlet. Prime or fill the pump as the notes require. A dry start is a common way to kill a new unit. Read more

This group shows a single part: TOPLINE OPHY26G.

This table covers the chains that drive the oil pump. Read more

One part is listed for the 2025 Kia Sorento — MELLING 1102.

This table covers the Oil Pump Chain guides. Read more

One part is listed for the 2025 Kia Sorento — MELLING BG7063.

This table covers the gaskets that seal the Oil Pump. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2025 Kia Sorento — ELRING B07160.

This table covers the timing chains that keep the cams in time with the crank. Read more

One part is listed for the 2025 Kia Sorento — MELLING 1101.

This table covers the guides and dampers that keep the timing chain on its path. Read more

MELLING supplies the 3 Timing Chain Guide / Damper parts for the 2025 Kia Sorento.

Part numbers include MELLING BG7062, MELLING BG7061 and MELLING BT7073.

This table covers the tensioners that keep the timing chain taut. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

This group shows a single part: MELLING BT7072.

This table covers the crankshaft sprockets that drive the timing chain or belt. Read more

This group shows a single part: MELLING S1330.

This table covers the Torque Strut mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

ANCHOR supplies both parts for the 2025 Kia Sorento.

This group includes ANCHOR 10250 and ANCHOR 10371.

This table covers the Turbocharger Coolant lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

This group shows a single part: SUNSONG 5804242.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2025 Kia Sorento — ELRING B06680.

This table covers the fasteners that mount the turbocharger. Read more

One part is listed for the 2025 Kia Sorento — ELRING B06710.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

This group shows a single part: SUNSONG 5804235.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING B06620.

This table covers the pressed-in bronze and cast-iron guides that align valve stems. Typical signs include oil smoke on startup, a guide that has gone oval, or a valve that no longer seats quietly. Guides are a machine-shop fit. Confirm stem diameter in the notes before ordering. Read more

2 Valve Guide parts for the 2025 Kia Sorento come from TOPLINE.

Part numbers include TOPLINE EVGHY26 and TOPLINE IVGHY26.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

This group shows a single part: TOPLINE LIFHY23.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: TOPLINE VSSSU16.

This table covers the oil-control solenoids that command the cam phasers. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

2 Variable Valve Timing (VVT) Solenoid / Actuator parts for the 2025 Kia Sorento come from HYUNDAI.

This group includes HYUNDAI 2435508000 and HYUNDAI 243572M000.

This table covers the cam phaser sprockets used by the variable-valve-timing system. Read more

2 Variable Valve Timing (VVT) Sprocket parts for the 2025 Kia Sorento come from HYUNDAI.

Part numbers include HYUNDAI 243702M800 and HYUNDAI 243502M800.