1967 MG Magnette Ignition Parts

Engine:
1.6L L4

20 Ignition parts are listed for the 1967 MG Magnette, in 4 part types, covering the 1.6L L4 engine. Each one has a brand, a manufacturer part number and notes that say where it fits.

On the 1967 MG Magnette, the ignition system delivers spark at the right moment — plugs, coils, wires, distributors and ignition modules. Most of the listed parts are Ignition Coil (9 parts), Spark Plug (7 parts) and Distributor Cap (2 parts). The other 1 part type covers the remaining 2 parts.

Distributor Cap

Brand Part Number Markets Notes Buy
STANDARD MOTOR PRODUCTS LU420
🇺🇸 US
View on
Amazon
WELLS 5D1040
🇺🇸 US
View on
Amazon

This table covers the Distributor caps. Typical signs include a leak at the neck, a cap that will not hold pressure, or a missing tether. Match the pressure rating or thread in the notes — radiator, reservoir and fuel caps are not interchangeable.

Distributor Rotor

Brand Part Number Markets Notes Buy
STANDARD MOTOR PRODUCTS LU300
🇺🇸 US
View on
Amazon
WELLS 4R1187
🇺🇸 US
View on
Amazon

This table covers the Distributor rotors. Typical signs include shudder under braking, or a lip at the outer edge. Do not put new pads on a rotor that is below minimum thickness.

Ignition Coil

Economy

Brand Part Number Markets Notes Buy
STANDARD MOTOR PRODUCTS Popular UC15T
🇺🇸 US
T-Series
View on
Amazon
FVP UC15F
🇺🇸 US
View on
Amazon
HOLSTEIN 2IGC0058
🇺🇸 US
View on
Amazon
SKP SKUC15T
🇺🇸 US
Coil Pack
View on
Amazon
SPECTRA PREMIUM C622
🇺🇸 US
Pack
View on
Amazon

Standard Replacement

Brand Part Number Markets Notes Buy
NGK Popular 48863
🇺🇸 US
12 VoltInternal Resistor Coil
Fitment notes — NGK 48863
12 VoltInternal Resistor CoilConnections May be Eyelet or Spade
View on
Amazon
STANDARD MOTOR PRODUCTS UC15
🇺🇸 US
View on
Amazon
UNITED MOTOR PRODUCTS C15
🇺🇸 US
View on
Amazon
WELLS 5C1019
🇺🇸 US
Used on most import products with 12 Volt system with Internal resistorUniversal 12 Volt Coil
Fitment notes — WELLS 5C1019
Used on most import products with 12 Volt system with Internal resistorUniversal 12 Volt Coil
12 Voltwith Lucas Ignition
View on
Amazon

This table covers the coils that fire each spark plug. Typical signs include a misfire that follows one cylinder, a snap in damp weather, or a coil that is swollen or cracked. Swap a suspect coil with a neighbor to confirm, then replace boots that tore on the way off.

Spark Plug

Summary: Notes include pre-set gaps of 0.025", 0.026", 0.035" and 0.039". Replacement brands in this table include CHAMPION, MOTORCRAFT and AUTOLITE.

Copper / Nickel

Brand Part Number Markets Notes Buy
ACDELCO Popular R44XLS
🇺🇸 US 🇨🇦 CA
ProfessionalConventional
Fitment notes — ACDELCO R44XLS
ProfessionalConventionalPre-Set Gap: 0.039"
Original Equipment-Recommended Gap: .025
View on
Amazon
CHAMPION Popular 120
🇺🇸 US
Copper PlusPre-Set Gap: 0.026"
Fitment notes — CHAMPION 120
Copper PlusPre-Set Gap: 0.026"
OE-Recommended Gap: 0.025"Non-Resistor Plug
View on
Amazon
CHAMPION 123
🇺🇸 US
Copper PlusPre-Set Gap: 0.025"
Fitment notes — CHAMPION 123
Copper PlusPre-Set Gap: 0.025"
OE-Recommended Gap: 0.025"Resistor Plug
View on
Amazon
MOTORCRAFT SP416A
🇺🇸 US
Copper
Fitment notes — MOTORCRAFT SP416A
Copper
OE Style.025"/0.6mm
View on
Amazon
MOTORCRAFT SP416X
🇺🇸 US
Copper
Fitment notes — MOTORCRAFT SP416X
Copper
OE Style.025"/0.6mm
View on
Amazon

Double Platinum (lasts up to 3x longer than Copper / Nickel)

Brand Part Number Markets Notes Buy
AUTOLITE APP65
🇺🇸 US
Double PlatinumPre-Set Gap: 0.035"
Fitment notes — AUTOLITE APP65
Double PlatinumPre-Set Gap: 0.035"
Gap .025 (In) 0.6 (mm)
View on
Amazon

Platinum (lasts up to 2x longer than Copper / Nickel)

Brand Part Number Markets Notes Buy
AUTOLITE AP65
🇺🇸 US
Platinum Spark PlugDisplay Pack
Fitment notes — AUTOLITE AP65
Platinum Spark PlugDisplay PackQTY2Pre-Set Gap: 0.035"
Gap .025 (In) 0.6 (mm)
View on
Amazon

This table covers the spark plugs for this engine. Typical signs include misfire under load, rough idle, or a flashing check-engine light. Verify the gap even on pre-gapped plugs, and replace coil boots that come off a high-mileage engine.

Buying Ignition Parts for a 1967 MG Magnette

On this vehicle, the ignition system delivers spark at the right moment — plugs, coils, wires, distributors and ignition modules.

  • Confirm you have the 1.6L L4 engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, replace plugs and wires (or coil boots) as a set — one weak cylinder makes the whole set feel bad.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Ignition Coil and Spark Plug .

Frequently Asked Questions

How many ignition parts fit the 1967 MG Magnette?

Our catalog currently lists 20 ignition parts for the 1967 MG Magnette across 4 subcategories and 12 brands, covering the 1.6L L4 engine. Each part is matched to the engine(s) it fits.

What are the signs of ignition problems on a 1967 MG Magnette?

Common symptoms include misfires under load, rough idle, flashing check-engine light, or poor starting in damp weather. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What spark-plug gap is listed for the 1967 MG Magnette?

Notes on this page include pre-set gaps of 0.025", 0.026", 0.035" and 0.039". Still verify against spec — even “pre-gapped” plugs should be checked before they go in.

What should I replace at the same time?

Where labor overlaps, replace plugs and wires (or coil boots) as a set — one weak cylinder makes the whole set feel bad.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1967 MG Magnette was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 1967 MG Magnette?

Every part on this page is matched to the 1.6L L4 engine. Then gap matters even on “pre-gapped” plugs — verify against spec, and replace coil boots when they come off a high-mileage engine. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 1967 MG Magnette

Ignition Parts for Other MG Magnette Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.