1967 MG Midget Engine Parts

This table covers the Camshaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: DURA-BOND BL1.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54031500.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 1967 MG Midget — AJUSA 15015900.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 10012900.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 52055500.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 50062600.

This table covers the Intake & Exhaust Manifold gasket sets. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Intake & Exhaust Manifold Gasket Set parts for the 1967 MG Midget come from 2 brands — AJUSA and BECK/ARNLEY.

This group includes AJUSA 13005400 and BECK/ARNLEY 0370205.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

3 Motor Mount parts are listed for the 1967 MG Midget, from DEA / MARMON RIDE CONTROL and PIONEER.

Listed part numbers: DEA / MARMON RIDE CONTROL A2736, DEA / MARMON RIDE CONTROL A2735 and PIONEER 602736.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

4 Oil Filter parts are listed for the 1967 MG Midget, from PUROLATOR, HASTINGS / BALDWIN, MANN and 1 other brand.

In the Economy grade, PUROLATOR supplies 1 part: the catalog's value-priced group. A representative part number is PUROLATOR L14753.

The Standard Replacement section lists 3 options from HASTINGS / BALDWIN, MANN and WIX — built to original-equipment specification. HASTINGS / BALDWIN LF187 is listed in this group.

This group includes PUROLATOR L14753, HASTINGS / BALDWIN LF187 and MANN H8131X and the remaining parts above.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 1967 MG Midget — AJUSA 59006800.

This table covers the Timing Belt pulleys. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt. Read more

BECK/ARNLEY supplies both parts for the 1967 MG Midget.

This group includes BECK/ARNLEY 0513860 and BECK/ARNLEY 0513954.

This table covers the timing chains that keep the cams in time with the crank. Read more

This group shows a single part: ITM ENGINE COMPONENTS 2352.

This table covers the seals at the Timing Cover. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 1967 MG Midget — ITM ENGINE COMPONENTS 1504001.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Valve Cover Gasket parts are listed for the 1967 MG Midget, from AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand.

Listed part numbers: AJUSA 11005900, FEL-PRO VS21507 and MAHLE / CLEVITE VS30025, plus the other parts above.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 1967 MG Midget.

Part numbers include AJUSA 12000100 and AJUSA 57000100.