2023 Nissan Z Engine Parts

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54338500.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Crankshaft Seal parts are listed for the 2023 Nissan Z, from AJUSA, FEL-PRO and SKF.

This group includes AJUSA 15060100, AJUSA 15092900 and FEL-PRO BS40694 and the remaining parts above.

This table covers the bolts that clamp the cylinder head to the block. Read more

This group shows a single part: AJUSA 81086100.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Cylinder Head Gasket parts for the 2023 Nissan Z come from AJUSA.

This group includes AJUSA 10275500, AJUSA 10275600 and AJUSA 52654300 and the remaining parts above.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 52654200.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 50582500.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Intake Manifold Gasket parts for the 2023 Nissan Z come from AJUSA.

This group includes AJUSA 13347100 and AJUSA 13347200.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

4 Motor Mount parts are listed for the 2023 Nissan Z, from SKP, ANCHOR, DEA / MARMON RIDE CONTROL and 1 other brand.

In the Economy grade, SKP supplies 1 part: the catalog's value-priced group. A representative part number is SKP SKM9774.

The Standard Replacement section lists 3 options from ANCHOR, DEA / MARMON RIDE CONTROL and PIONEER — built to original-equipment specification. ANCHOR 9774 is listed in this group.

This group includes SKP SKM9774, ANCHOR 9774 and DEA / MARMON RIDE CONTROL A4379 and the remaining parts above.

This table covers the Motor Mount kits. Read more

One part is listed for the 2023 Nissan Z — ANCHOR 300171.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

30 Oil parts are listed for the 2023 Nissan Z, from VALVOLINE, LIQUI MOLY, MOBIL and 2 other brands. LIQUI MOLY 2208 carries the "Popular" badge. Full Synthetic and High Mileage (>75,000 Miles) are all represented, and Full Synthetic alone accounts for 23 parts.

This table covers the heat exchangers that cool engine oil. Typical signs include oil at the cooler fittings, or coolant that looks like a milkshake. Pressure-test both circuits after a cooler swap — a leak here mixes oil and coolant. Read more

One part is listed for the 2023 Nissan Z — STANDARD MOTOR PRODUCTS OCK113.

This table covers the Oil Cooler lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

One part is listed for the 2023 Nissan Z — SUNSONG 5801894.

This table covers the drain plugs in the oil pan. Read more

4 Oil Drain Plug parts are listed for the 2023 Nissan Z, from DORMAN, BECK/ARNLEY and REIN.

This group includes BECK/ARNLEY 0160116, DORMAN 090038 and DORMAN 090049 and the remaining parts above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Oil Drain Plug Gasket parts for the 2023 Nissan Z come from 3 brands — DORMAN, AJUSA and FEL-PRO.

This group includes AJUSA 01140600, DORMAN 097134 and DORMAN 997134CD and the remaining parts above.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

16 Oil Filter parts are listed for the 2023 Nissan Z, from BOSCH, VARIOUS MFR, WIX and 10 other brands. CHAMP / LUBER-FINER PH2876 carries the "Popular" badge.

Economy: 6 parts, from CHAMP / LUBER-FINER, BOSCH, FRAM and 3 other brands. A representative part number is CHAMP / LUBER-FINER PH2876.

In the High Performance / Heavy Duty grade, MOBIL and WIX supply 2 parts: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is MOBIL M1108A.

The Standard Replacement section: 8 options from BOSCH, ACDELCO, BECK/ARNLEY and 5 other brands. BOSCH 3300 is listed in this group.

This table covers the oil pans that hold the engine's oil sump. Read more

2 Oil Pan parts for the 2023 Nissan Z come from 2 brands — DORMAN and SPECTRA PREMIUM.

Listed part numbers: DORMAN 264864 and SPECTRA PREMIUM NSP48A.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2023 Nissan Z — AJUSA 14122900.

This table covers the seals at the Timing Cover. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2023 Nissan Z — SKF 18857.

This table covers the Turbocharger Boost sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: WELLS 5S15745.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA JTC12789.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

AJUSA supplies both parts for the 2023 Nissan Z.

Part numbers include AJUSA OP11415 and AJUSA OP11465.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies both parts for the 2023 Nissan Z.

This group includes AJUSA 11181700 and AJUSA 11181800.

This table covers the keepers that lock each valve-spring retainer to the stem. Read more

This group shows a single part: MELLING VL730.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 2023 Nissan Z.

This group includes AJUSA 12009100 and AJUSA 57097900.

This table covers the oil-control solenoids that command the cam phasers. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

4 Variable Valve Timing (VVT) Solenoid / Actuator parts are listed for the 2023 Nissan Z, from GATES, HOLSTEIN, WELLS and 1 other brand.

Economy: 3 parts, from GATES, HOLSTEIN and WELLS. A representative part number is GATES VVS247.

The Standard Replacement section: 1 option from CLOYES. CLOYES VTS204 is listed in this group.

Listed part numbers: GATES VVS247, HOLSTEIN 2VTS0279 and WELLS 2T1172, plus the other parts above.