2008 Peugeot 307 Engine Parts

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Camshaft Seal parts are listed for the 2008 Peugeot 307, from AJUSA and ELRING.

This group includes AJUSA 15091600, AJUSA 15014700 and ELRING 655190 and the remaining parts above.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54153100.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Crankshaft Seal parts are listed for the 2008 Peugeot 307, from AJUSA, ELRING and VICTOR REINZ.

Part numbers include AJUSA 15044900, AJUSA 15088400 and ELRING 508209, among others listed above.

This table covers the bolts that clamp the cylinder head to the block. Read more

This group shows a single part: AJUSA 81039600.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 10176700.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 52258100.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 50276200.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2008 Peugeot 307 — AJUSA 13215900.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

DEA / MARMON RIDE CONTROL supplies both parts for the 2008 Peugeot 307.

Listed part numbers: DEA / MARMON RIDE CONTROL AM705 and DEA / MARMON RIDE CONTROL AM716.

This table covers the gaskets that seal the Oil Cooler. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING 687640.

This table covers the drain plugs in the oil pan. Read more

One part is listed for the 2008 Peugeot 307 — ELRING 587240.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Drain Plug Gasket parts for the 2008 Peugeot 307 come from 2 brands — AJUSA and ELRING.

Part numbers include AJUSA 18001000 and ELRING 813036.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

9 Oil Filter parts are listed for the 2008 Peugeot 307, from CHAMP / LUBER-FINER, FVP, PRO-TEC and 6 other brands. MANN HU71151X carries the "Popular" badge.

In the Economy grade, CHAMP / LUBER-FINER, FVP, PRO-TEC and 2 other brands supply 5 parts: the catalog's value-priced group. A representative part number is CHAMP / LUBER-FINER P978.

The Standard Replacement section lists 4 options from MANN, WIX, ACDELCO and 1 other brand — built to original-equipment specification. MANN HU71151X is listed in this group.

Part numbers include MANN HU71151X, CHAMP / LUBER-FINER P978 and FVP G7512, among others listed above.

This table covers the rings that seal each piston to the cylinder wall. Read more

2 Piston Ring parts for the 2008 Peugeot 307 come from HASTINGS MANUFACTURING.

This group includes HASTINGS MANUFACTURING 2C4106 and HASTINGS MANUFACTURING 2C4106S.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

One part is listed for the 2008 Peugeot 307 — AJUSA 85005800.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Valve Stem Seal parts are listed for the 2008 Peugeot 307, from AJUSA, ELRING and VICTOR REINZ. VICTOR REINZ 123130607 carries the "Popular" badge.

Part numbers include VICTOR REINZ 123130607, AJUSA 12014800 and AJUSA 57030900, among others listed above.