2010 Peugeot 207 Compact Engine Parts

This table covers the camshafts that open the valves. Read more

AJUSA supplies both parts for the 2010 Peugeot 207 Compact.

Part numbers include AJUSA 93123500 and AJUSA 93123600.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: AJUSA 15091700.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2010 Peugeot 207 Compact — AJUSA 54164100.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Crankshaft Seal parts for the 2010 Peugeot 207 Compact come from AJUSA.

Part numbers include AJUSA 15094100 and AJUSA 15094200.

This table covers the bolts that clamp the cylinder head to the block. Read more

One part is listed for the 2010 Peugeot 207 Compact — AJUSA 81044200.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2010 Peugeot 207 Compact — AJUSA 10155800.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2010 Peugeot 207 Compact — AJUSA 52451100.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2010 Peugeot 207 Compact — AJUSA 50371200.

This table covers the Intake manifolds. Typical signs include an exhaust tick, a vacuum leak, or a gasket that has burned through. Replace the gaskets and hardware; a warped flange will leak with a new gasket alone. Read more

2 Intake Manifold parts for the 2010 Peugeot 207 Compact come from LARES.

Part numbers include LARES 33075 and LARES 33080.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2010 Peugeot 207 Compact — AJUSA 24023100.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2010 Peugeot 207 Compact — AJUSA 20003300.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

7 Oil Filter parts for the 2010 Peugeot 207 Compact come from 7 brands — FVP, PRO-TEC, PUROLATOR and 4 other brands. The "Popular" part is MANN HU71151X. Every part fits both the 1.4L L4 and the 1.6L L4.

The Economy section lists 4 options from FVP, PRO-TEC, PUROLATOR and 1 other brand — the catalog's value-priced group. FVP G7512 is listed in this group.

In the Standard Replacement grade, MANN, WIX and MAHLE / CLEVITE supply 3 parts: built to original-equipment specification. A representative part number is MANN HU71151X.

Listed part numbers: MANN HU71151X, FVP G7512 and PRO-TEC PXL57512, plus the other parts above.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 11117200.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

This group shows a single part: AJUSA 85014300.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: AJUSA 57023600.