2013 Toyota Prius Electrical Parts

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery. Read more

5 Battery parts for the 2013 Toyota Prius come from 5 brands — FVP, ACDELCO, BOSCH and 2 other brands. The "Popular" part is FVP PS46B24RAGM.

This group includes FVP PS46B24RAGM, ACDELCO B24RAGM and BOSCH S6535B and the remaining parts above.

This table covers the positive and ground cables that run from the battery. Typical signs include a stretched or frayed cable, or a control that no longer reaches the end of its travel. Route the new cable through the same clips. A kinked cable binds and fails early. Read more

One part is listed for the 2013 Toyota Prius — STANDARD MOTOR PRODUCTS A136T.

This table covers the Battery Cooling fans. Typical signs include overheating at idle, a fan that never comes on, or a blade that hits the shroud. Confirm the fan command and the relay before replacing the assembly. Read more

This group shows a single part: GPD 2312065.

This table covers the Battery Current sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

WELLS supplies both parts for the 2013 Toyota Prius.

Listed part numbers: WELLS 5S16146 and WELLS 5S16145.

This table covers the Cruise Control Distance sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

2 Cruise Control Distance Sensor parts for the 2013 Toyota Prius come from 2 brands — DORMAN and WELLS.

Listed part numbers: DORMAN 601937 and WELLS 5S17193.

This table covers the inverters that power a hybrid or EV drive motor. Read more

One part is listed for the 2013 Toyota Prius — VEMO V70170001.

This table covers the EV Charging cables. Typical signs include a stretched or frayed cable, or a control that no longer reaches the end of its travel. Route the new cable through the same clips. A kinked cable binds and fails early. Read more

This group shows a single part: STANDARD MOTOR PRODUCTS EVB004.

This table covers the flasher units that blink the turn signals and hazards. Read more

4 Flasher parts for the 2013 Toyota Prius come from 3 brands — WELLS, STANDARD MOTOR PRODUCTS and TRIDON / NOVITA.

Part numbers include STANDARD MOTOR PRODUCTS EFL47, TRIDON / NOVITA LM449 and WELLS 1R2224, among others listed above.

This table covers the replacement fuses for this vehicle's fuse boxes. Typical signs include one circuit dead while its neighbor still works, or a fuse that blows again as soon as you replace it. Match amperage and fuse type. A repeat blow means a short — find it before the next fuse. Read more

11 Fuse parts for the 2013 Toyota Prius come from BUSSMANN. The "Popular" part is BUSSMANN ATM20LP.

In the 10 Amp grade, BUSSMANN supplies 1 part: grouped under the catalog's "10 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM10LP.

In the 140 Amp grade, BUSSMANN supplies 1 part: grouped under the catalog's "140 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN FLM140.

The 15 Amp section lists 1 option from BUSSMANN — grouped under the catalog's "15 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM15LP is listed in this group.

The 20 Amp section lists 1 option from BUSSMANN — grouped under the catalog's "20 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM20LP is listed in this group.

In the 25 Amp grade, BUSSMANN supplies 1 part: grouped under the catalog's "25 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM25LP.

In the 30 Amp grade, BUSSMANN supplies 2 parts: grouped under the catalog's "30 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM30LP.

In the 5 Amp grade, BUSSMANN supplies 1 part: grouped under the catalog's "5 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM5LP.

The 60 Amp section lists 1 option from BUSSMANN — grouped under the catalog's "60 Amp" designation — the notes column spells out what sets them apart. BUSSMANN FLG60 is listed in this group.

2 further parts sit outside the graded sections, with the same engine-level match.

This table covers the horns mounted in the front of the vehicle. Read more

14 Horn parts for the 2013 Toyota Prius come from 2 brands — FIAMM and HELLA. The "Popular" part is FIAMM 7210223.

The Accessory Replacement section lists 7 options from FIAMM — grouped under the catalog's "Accessory Replacement" designation — the notes column spells out what sets them apart. FIAMM 7210223 is listed in this group.

In the Standard Replacement grade, FIAMM and HELLA supply 7 parts: built to original-equipment specification. A representative part number is FIAMM 7200223.

This table covers the Hybrid Battery Voltage sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: STANDARD MOTOR PRODUCTS BSC25.

This table covers the brackets that mount the Parking Aid Sensor. Typical signs include a cracked mount, a rattle, or a bracket that no longer holds alignment. Confirm position in the notes. Many brackets look alike and bolt to different corners. Read more

One part is listed for the 2013 Toyota Prius — TECHPRO TO1074100.

This table covers the Yaw sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: WELLS 5S16911.