1978 Triumph TR7 Engine Parts

Engine:
2.0L L4

The 1978 Triumph TR7 has 20 engine parts with verified fitment on this page — 11 part types and 12 brands, covering the 2.0L L4 engine. Each part includes a manufacturer part number and application notes.

The engine on the 1978 Triumph TR7 covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components. The largest groups are Oil Filter (5 parts), Crankshaft Repair Sleeve (4 parts) and Circular / Semi-Circular Plug (2 parts). The other 8 part types cover the remaining 9 parts.

Circular / Semi-Circular Plug

Brand Part Number Markets Notes Buy
FEL-PRO CP75013
🇺🇸 US 🇨🇦 CA
RearValve Cover Camshaft Bore Plug
View on
Amazon
VICTOR REINZ 711349400
🇺🇸 US 🇨🇦 CA
Valve Cover
View on
Amazon

This table covers the Circular / Semi-Circular plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes.

Conversion / Lower Gasket Set

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS 0925605
🇺🇸 US 🇨🇦 CA
Set does Not contain engine Oil seals
View on
Amazon

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration.

Crankshaft Repair Sleeve

Brand Part Number Markets Notes Buy
NATIONAL 99179
🇺🇸 US 🇨🇦 CA
Front
View on
Amazon
SCHAEFFLER SR3500
🇺🇸 US 🇨🇦 CA
Front20.32 mm Width
Fitment notes — SCHAEFFLER SR3500
Front20.32 mm Widthwith Flange53.98 mm Outside Diameter
View on
Amazon
TIMKEN KWK99179
🇺🇸 US 🇨🇦 CA
Kwik-Sleeve
Fitment notes — TIMKEN KWK99179
Kwik-Sleeve
Front
View on
Amazon
WJB / INMOTION PARTS WS99179
🇺🇸 US 🇨🇦 CA
Front
View on
Amazon

This table covers the sleeves used to restore a grooved crankshaft seal surface.

Crankshaft Seal

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS 1559819
🇺🇸 US 🇨🇦 CA
Rear
View on
Amazon
TIMKEN 50266
🇺🇸 US 🇨🇦 CA
Front
View on
Amazon

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.

Cylinder Head Gasket

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS 0945605
🇺🇸 US 🇨🇦 CA
Graphite Composite Head Gasket
View on
Amazon

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.

Exhaust Valve

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS RX34477
🇺🇸 US 🇨🇦 CA
View on
Amazon

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one.

Intake Valve

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS RV9171
🇺🇸 US 🇨🇦 CA
View on
Amazon

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one.

Oil Filter

Economy

Brand Part Number Markets Notes Buy
FAMOUS BRAND 85184
🇺🇸 US 🇨🇦 CA
View on
Amazon
PUROLATOR L14753
🇺🇸 US 🇨🇦 CA
View on
Amazon

Standard Replacement

Brand Part Number Markets Notes Buy
WIX Popular 51184
🇺🇸 US 🇨🇦 CA
View on
Amazon
HASTINGS / BALDWIN LF187
🇺🇸 US 🇨🇦 CA
View on
Amazon
MANN H8131X
🇺🇸 US 🇨🇦 CA
View on
Amazon

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive.

Oil Pan Gasket

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS 0995605
🇺🇸 US 🇨🇦 CA
View on
Amazon

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.

Piston

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS RY6363
🇺🇸 US 🇨🇦 CA
Compression Ratio 8:1-3.5546 Inch (Size: 0.020" Oversize)
View on
Amazon

This table covers the pistons that travel in each cylinder. Typical signs include knock, blow-by, or a cylinder that will not hold compression. Piston work is a short-block job. Match bore, pin and ring pack in the notes — not the photo.

Piston Ring

Brand Part Number Markets Notes Buy
ITM ENGINE COMPONENTS 0216065
🇺🇸 US 🇨🇦 CA
1.75 X 1.75 X 4mmSet
Fitment notes — ITM ENGINE COMPONENTS 0216065
1.75 X 1.75 X 4mmSet
(Size: Standard)
View on
Amazon

This table covers the rings that seal each piston to the cylinder wall.

Buying Engine Parts for a 1978 Triumph TR7

On this vehicle, the engine covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components.

  • Confirm you have the 2.0L L4 engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Oil Filter and Crankshaft Repair Sleeve .

Frequently Asked Questions

How many engine parts fit the 1978 Triumph TR7?

Our catalog currently lists 20 engine parts for the 1978 Triumph TR7 across 11 subcategories and 12 brands, covering the 2.0L L4 engine. Each part is matched to the engine(s) it fits.

What are the signs of engine problems on a 1978 Triumph TR7?

Common symptoms include oil spots under the vehicle, blue or white exhaust smoke, ticking from the valvetrain, or coolant mysteriously disappearing. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1978 Triumph TR7 was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 1978 Triumph TR7?

Every part on this page is matched to the 2.0L L4 engine. Then engine hard parts are unforgiving of guesswork — confirm the casting or engine code before ordering, because one model year can hide two different blocks. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 1978 Triumph TR7

Engine Parts for Other Triumph TR7 Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.