1987 Acura Integra Ignition Parts

This table covers the sensors that report crankshaft position and engine speed. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

This group shows a single part: WALKER PRODUCTS 2351828.

This table covers the distributors that route spark. Read more

One part is listed for the 1987 Acura Integra — AUTOLINE D8012.

This table covers the Distributor caps. Typical signs include a leak at the neck, a cap that will not hold pressure, or a missing tether. Match the pressure rating or thread in the notes — radiator, reservoir and fuel caps are not interchangeable. Read more

5 Distributor Cap parts are listed for the 1987 Acura Integra, from STANDARD MOTOR PRODUCTS, ULTRA-POWER, FAMOUS BRAND and 1 other brand. ULTRA-POWER JH101 carries the "Popular" badge.

In the Economy grade, ULTRA-POWER, FAMOUS BRAND, STANDARD MOTOR PRODUCTS and 1 other brand supply 4 parts: the catalog's value-priced group. A representative part number is ULTRA-POWER JH101.

The Standard Replacement section lists 1 option from STANDARD MOTOR PRODUCTS — built to original-equipment specification. STANDARD MOTOR PRODUCTS JH101 is listed in this group.

Listed part numbers: ULTRA-POWER JH101, FAMOUS BRAND 250437541 and STANDARD MOTOR PRODUCTS JH101T, plus the other parts above.

This table covers the gaskets that seal the Distributor Mounting. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Distributor Mounting Gasket parts are listed for the 1987 Acura Integra, from AJUSA, FEL-PRO and VICTOR REINZ.

This group includes AJUSA 16019000, FEL-PRO 72454 and VICTOR REINZ 711535200.

This table covers the Distributor Pickup coils. Typical signs include a misfire that follows one cylinder, or a snap in damp weather. Swap with a neighbor to confirm, and replace a torn boot with the coil. Read more

This group shows a single part: WELLS 4P1183.

This table covers the Distributor reluctors. Read more

One part is listed for the 1987 Acura Integra — WELLS 1A4000.

This table covers the Distributor rotors. Typical signs include shudder under braking, or a lip at the outer edge. Do not put new pads on a rotor that is below minimum thickness. Read more

6 Distributor Rotor parts are listed for the 1987 Acura Integra, from STANDARD MOTOR PRODUCTS, UNITED MOTOR PRODUCTS and WELLS. WELLS 4R1125A carries the "Popular" badge.

Economy: 3 parts, from UNITED MOTOR PRODUCTS and STANDARD MOTOR PRODUCTS. A representative part number is STANDARD MOTOR PRODUCTS JR89T.

The Premium section lists 1 option from WELLS — a step above OE specification in materials, tolerances or warranty terms. WELLS 4R1125A is listed in this group.

The Standard Replacement section: 2 options from STANDARD MOTOR PRODUCTS and WELLS. STANDARD MOTOR PRODUCTS JR89 is listed in this group.

Part numbers include WELLS 4R1125A, STANDARD MOTOR PRODUCTS JR89T and UNITED MOTOR PRODUCTS IR4015, among others listed above.

This table covers the coils that fire each spark plug. Typical signs include a misfire that follows one cylinder, a snap in damp weather, or a coil that is swollen or cracked. Swap a suspect coil with a neighbor to confirm, then replace boots that tore on the way off. Read more

6 Ignition Coil parts for the 1987 Acura Integra come from 6 brands — B&B, DELPHI, WELLS and 3 other brands. The "Popular" part is DELPHI GN10544.

The Economy section: 1 option from B&B. B&B BB5062 is listed in this group.

Premium: 1 part, from DELPHI. A representative part number is DELPHI GN10544.

Standard Replacement: 4 parts, from WELLS, BECK/ARNLEY, STANDARD MOTOR PRODUCTS and 1 other brand. A representative part number is WELLS 5C1001.

This group includes DELPHI GN10544, B&B BB5062 and WELLS 5C1001 and the remaining parts above.

This table covers the Ignition control modules. Read more

3 Ignition Control Module (ICM) parts for the 1987 Acura Integra come from 3 brands — STANDARD MOTOR PRODUCTS, WAI GLOBAL and WELLS.

Listed part numbers: STANDARD MOTOR PRODUCTS LX539, WAI GLOBAL NM412 and WELLS 6H1000.

This table covers the lock cylinders in the ignition switch. Read more

3 Ignition Lock Cylinder parts for the 1987 Acura Integra come from 3 brands — LOCKSMART, STANDARD MOTOR PRODUCTS and WELLS.

The Economy section: 1 option from LOCKSMART. LOCKSMART LC14950 is listed in this group.

Standard Replacement: 2 parts, from STANDARD MOTOR PRODUCTS and WELLS. A representative part number is STANDARD MOTOR PRODUCTS US120L.

This group includes LOCKSMART LC14950, STANDARD MOTOR PRODUCTS US120L and WELLS 4H1000.

This table covers the spark plugs for this engine. Typical signs include misfire under load, rough idle, or a flashing check-engine light. Verify the gap even on pre-gapped plugs, and replace coil boots that come off a high-mileage engine. Read more

23 Spark Plug parts are listed for the 1987 Acura Integra, from CHAMPION, NGK, AUTOLITE and 5 other brands. NGK 6779 carries the "Popular" badge.

In the Copper / Nickel grade, NGK, CHAMPION, AUTOLITE and 3 other brands supply 8 parts: grouped under the catalog's "Copper / Nickel" designation — the notes column spells out what sets them apart. A representative part number is NGK 6779.

In the Double Platinum (lasts up to 3x longer than Copper / Nickel) grade, ACDELCO, AUTOLITE and CHAMPION supply 3 parts: grouped under the catalog's "Double Platinum (lasts up to 3x longer than Copper / Nickel)" designation — the notes column spells out what sets them apart. A representative part number is ACDELCO 41801.

The Iridium (lasts up to 4x longer than Copper / Nickel) section lists 7 options from DENSO, NGK, AUTOLITE and 3 other brands — grouped under the catalog's "Iridium (lasts up to 4x longer than Copper / Nickel)" designation — the notes column spells out what sets them apart. NGK 4919 is listed in this group.

In the Platinum (lasts up to 2x longer than Copper / Nickel) grade, CHAMPION, NGK, ACDELCO and 2 other brands supply 5 parts: grouped under the catalog's "Platinum (lasts up to 2x longer than Copper / Nickel)" designation — the notes column spells out what sets them apart. A representative part number is CHAMPION 3344.

This table covers the non-foulers that space a spark plug away from oil fouling. Read more

This group shows a single part: DORMAN 42004.

This table covers the seals at the Spark Plug Tube. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

8 Spark Plug Tube Seal parts for the 1987 Acura Integra come from 8 brands — FEL-PRO, MAHLE / CLEVITE, APEX and 5 other brands. The "Popular" part is FEL-PRO ES72179.

Part numbers include FEL-PRO ES72179, MAHLE / CLEVITE B31691 and APEX AES104, among others listed above.

This table covers the Spark Plug wires. Read more

10 Spark Plug Wire parts for the 1987 Acura Integra come from 9 brands — B&B, BELDEN, BORG-WARNER and 6 other brands. The "Popular" part is BELDEN 700453.

The Economy section: 4 options from BELDEN, B&B, BORG-WARNER and 1 other brand. BELDEN 700453 is listed in this group.

Premium: 3 parts, from NGK, STANDARD MOTOR PRODUCTS and UNITED MOTOR PRODUCTS. A representative part number is NGK 9624.

Standard Replacement: 3 parts, from B&B, BECK/ARNLEY and WALKER PRODUCTS. A representative part number is B&B M428921.