2000 Acura TL Automatic Transmission Parts

This table covers the clutch-plate packs inside the transmission or transfer case. Read more

RAYBESTOS POWERTRAIN supplies both parts for the 2000 Acura TL.

The Friction Plate Pack section lists 1 option from RAYBESTOS POWERTRAIN — grouped under the catalog's "Friction Plate Pack" designation — the notes column spells out what sets them apart. RAYBESTOS POWERTRAIN RCP96225 is listed in this group.

In the Steel Plate Pack grade, RAYBESTOS POWERTRAIN supplies 1 part: grouped under the catalog's "Steel Plate Pack" designation — the notes column spells out what sets them apart. A representative part number is RAYBESTOS POWERTRAIN STMHONDA34.

This group includes RAYBESTOS POWERTRAIN RCP96225 and RAYBESTOS POWERTRAIN STMHONDA34.

This table covers the replacement filters for this application — the table heading and notes say which circuit. Typical signs include restricted flow — long cranking, weak airflow, or dirty fluid after a short interval. Seat the new filter so it cannot bypass, and use the grade the notes call for. Read more

11 Filter parts are listed for the 2000 Acura TL, from ATP, PIONEER, VAICO and 5 other brands. ATP B265 carries the "Popular" badge.

In the Economy grade, FAMOUS BRAND and PA CARGO supply 2 parts: the catalog's value-priced group. A representative part number is FAMOUS BRAND 96092.

The Standard Replacement section lists 9 options from ATP, PIONEER, VAICO and 3 other brands — built to original-equipment specification. ATP B265 is listed in this group.

This table covers the flexplates that connect the crankshaft to the torque converter. Read more

2 Flexplate parts for the 2000 Acura TL come from 2 brands — ATP and PIONEER.

Listed part numbers: ATP Z611 and PIONEER FRA561.

This table covers the Fluid Pan drain plugs. Read more

This group shows a single part: DORMAN 090178.

This table covers the seals at the Fluid Pump. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Fluid Pump Seal parts for the 2000 Acura TL come from 2 brands — SCHAEFFLER and SKF.

Listed part numbers: SCHAEFFLER SS2781 and SKF 18124.

This table covers the Fluid temperature sensors. Typical signs include hard cold starts, a fan that never comes on, or a gauge that disagrees with the scan tool. A sensor that reads open or shorted is usually the part; an implausible-but-smooth reading can be wiring. Read more

3 Fluid Temperature Sensor parts are listed for the 2000 Acura TL, from NTK, ROSTRA and WELLS.

Listed part numbers: NTK AT0035, ROSTRA 501046 and WELLS 5S9598.

This table covers the seals at the Manual Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Manual Shaft Seal parts for the 2000 Acura TL come from 3 brands — BCA, NATIONAL and WJB / INMOTION PARTS.

Listed part numbers: BCA NS221207, NATIONAL 221207 and WJB / INMOTION PARTS WS221207.

This table covers the wear sleeves used to restore a Output Shaft seal surface. Read more

6 Output Shaft Repair Sleeve parts are listed for the 2000 Acura TL, from NATIONAL, WJB / INMOTION PARTS, BCA and 1 other brand. NATIONAL 99139 carries the "Popular" badge.

This group includes NATIONAL 99139, NATIONAL 99157 and BCA NS99157 and the remaining parts above.

This table covers the seals at the Output Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

11 Output Shaft Seal parts are listed for the 2000 Acura TL, from SKF, ATP, TIMKEN and 5 other brands. NATIONAL 712551 carries the "Popular" badge.

This table covers the Pinion bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

2 Pinion Bearing parts for the 2000 Acura TL come from 2 brands — SCHAEFFLER and SKF.

Part numbers include SCHAEFFLER 32207 and SKF BR32207.

This table covers the seals at the Pinion. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2000 Acura TL — SKF 22823.

This table covers the Pressure Control (EPC) solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

2 Pressure Control (EPC) Solenoid parts are listed for the 2000 Acura TL, from ATP and ROSTRA.

Listed part numbers: ATP HE22 and ROSTRA 520536.

This table covers the rebuild kits for this assembly. Read more

7 Rebuild Kit parts for the 2000 Acura TL come from 4 brands — PA CARGO, PIONEER, TRANSTEC and 1 other brand. The "Popular" part is PA CARGO K121900.

The Banner Kit (Overhaul Kit + Friction Clutch Plates) section lists 1 option from PA CARGO — grouped under the catalog's "Banner Kit (Overhaul Kit + Friction Clutch Plates)" designation — the notes column spells out what sets them apart. PA CARGO DK12100AS is listed in this group.

The Deluxe Kit (Master Kit + Filter, Band & Common Bushings) section lists 1 option from PA CARGO — grouped under the catalog's "Deluxe Kit (Master Kit + Filter, Band & Common Bushings)" designation — the notes column spells out what sets them apart. PA CARGO MRK12100A is listed in this group.

In the Master Kit (Overhaul Kit + Friction & Steel Clutch Plates) grade, PA CARGO supplies 1 part: grouped under the catalog's "Master Kit (Overhaul Kit + Friction & Steel Clutch Plates)" designation — the notes column spells out what sets them apart. A representative part number is PA CARGO DK12100A.

The Overhaul Kit (Gaskets, Seals, O-Rings & Sealing Rings) section lists 3 options from PA CARGO, PIONEER and TRANSTEC — grouped under the catalog's "Overhaul Kit (Gaskets, Seals, O-Rings & Sealing Rings)" designation — the notes column spells out what sets them apart. PA CARGO K121900 is listed in this group.

1 further part sits outside the graded sections, with the same engine-level match.

This group includes PA CARGO K121900, PA CARGO DK12100AS and PA CARGO MRK12100A and the remaining parts above.

This table covers the Shift Improvement kits. Read more

One part is listed for the 2000 Acura TL — TRANSGO HONDALK.

This table covers the wear sleeves used to restore a Shift Shaft seal surface. Read more

This group shows a single part: SKF 99049.

This table covers the seals at the Shift Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Shift Shaft Seal parts for the 2000 Acura TL come from 3 brands — ATP, PIONEER and SKF. The "Popular" part is ATP HO22.

This group includes ATP HO22, ATP HO23 and PIONEER 759172 and the remaining parts above.

This table covers the Shift solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

9 Shift Solenoid parts for the 2000 Acura TL come from 6 brands — ATP, STANDARD MOTOR PRODUCTS, WELLS and 3 other brands. The "Popular" part is STANDARD MOTOR PRODUCTS TCS121.

In the Single Solenoid grade, STANDARD MOTOR PRODUCTS, ATP and WELLS supply 5 parts: grouped under the catalog's "Single Solenoid" designation — the notes column spells out what sets them apart. A representative part number is STANDARD MOTOR PRODUCTS TCS121.

In the Solenoid Pack / Kit grade, ATP and PIONEER supply 2 parts: grouped under the catalog's "Solenoid Pack / Kit" designation — the notes column spells out what sets them apart. A representative part number is ATP HE12.

2 further parts sit outside the graded sections, with the same engine-level match.

Listed part numbers: STANDARD MOTOR PRODUCTS TCS121, WELLS 2N1226 and ATP HE10, plus the other parts above.

This table covers the Torque converters. Typical signs include a sulfur smell, rattling substrate, or an efficiency code. Confirm CARB vs Federal certification in the notes before ordering. Read more

One part is listed for the 2000 Acura TL — TC REMANUFACTURING HO21.

This table covers the wear sleeves used to restore a Torque Converter seal surface. Read more

This group shows a single part: SCHAEFFLER SR3501.

This table covers the seals at the Torque Converter Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Torque Converter Shaft Seal parts for the 2000 Acura TL come from 5 brands — NATIONAL, ATP, BCA and 2 other brands. The "Popular" part is NATIONAL 350609.

Listed part numbers: NATIONAL 350609, ATP HO20 and BCA NS350609, plus the other parts above.

This table covers the automatic-transmission fluids specified for this gearbox. Typical signs include harsh or delayed shifts, fluid that smells burnt, or a shudder at light throttle. Use exactly the specification in the notes. Automatic transmissions are unforgiving of the wrong fluid. Read more

17 Transmission Fluid parts are listed for the 2000 Acura TL, from LIQUI MOLY, VALVOLINE, LUCAS OIL and 5 other brands. ACDELCO 109243 carries the "Popular" badge.

In the Dexron grade, ACDELCO supplies 1 part: grouped under the catalog's "Dexron" designation — the notes column spells out what sets them apart. A representative part number is ACDELCO 109243.

The DW-1 section lists 1 option from AISIN — grouped under the catalog's "DW-1" designation — the notes column spells out what sets them apart. AISIN ATFDW1 is listed in this group.

In the Multi-Vehicle grade, LIQUI MOLY, VALVOLINE, LUCAS OIL and 2 other brands supply 14 parts: grouped under the catalog's "Multi-Vehicle" designation — the notes column spells out what sets them apart. A representative part number is MOBIL 126505.

In the Z-1 grade, BECK/ARNLEY supplies 1 part: grouped under the catalog's "Z-1" designation — the notes column spells out what sets them apart. A representative part number is BECK/ARNLEY 2522004.

This table covers the conditioners and additives used with this transmission fluid. Read more

8 Transmission Fluid Additive parts are listed for the 2000 Acura TL, from LUBEGARD and ATP. LUBEGARD 19610 carries the "Popular" badge.

This group includes LUBEGARD 19610, LUBEGARD 60902 and ATP AT203 and the remaining parts above.

This table covers the mounts that hold the transmission to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

12 Transmission Mount parts for the 2000 Acura TL come from 7 brands — SKP, ANCHOR, DEA / MARMON RIDE CONTROL and 4 other brands. The "Popular" part is ANCHOR 8986.

The Economy section: 3 options from SKP and FAMOUS BRAND. FAMOUS BRAND 3400312172 is listed in this group.

Standard Replacement: 9 parts, from ANCHOR, DEA / MARMON RIDE CONTROL, PIONEER and 2 other brands. A representative part number is ANCHOR 8986.