2011 Acura TSX Steering Parts

This table covers the steering knuckles that carry the hub, caliper and ball joints. Read more

5 Knuckle parts are listed for the 2011 Acura TSX, from DORMAN, SKP and ULTRA-POWER. ULTRA-POWER 698047 carries the "Popular" badge.

This group includes ULTRA-POWER 698047 and DORMAN 698046 and the remaining parts above.

This table covers the Power Steering pressure sensors. Typical signs include a check-engine light for MAP or fuel-rail pressure, or a limp mode under load. A vacuum leak or a clogged reference line will fake a bad pressure sensor. Read more

One part is listed for the 2011 Acura TSX — LARES 450.

This table covers the Power Steering Reservoir (Suction) hoses. Typical signs include swelling, cracks, a soft spot, or a leak at a clamp. Replace adjacent aged hoses while the system is drained — they share the same heat cycle. Read more

This group shows a single part: SUNSONG 3404603.

This table covers the steering gear assemblies that turn the tie rods. Typical signs include fluid at a torn boot, a growl when you turn, or play that the inner tie rods do not explain. Flush the old power-steering fluid with the rack — grit in the old fluid is the usual cause of a repeat leak. Read more

One part is listed for the 2011 Acura TSX — TERREPOWER 2050127E.

This table covers the rubber boots that seal the inner tie-rod joints on the rack. Read more

6 Rack and Pinion Bellow parts for the 2011 Acura TSX come from 5 brands — DELPHI, MOOG, BECK/ARNLEY and 2 other brands. The "Popular" part is DELPHI TBR5114.

Listed part numbers: DELPHI TBR5114, MOOG K150282 and BECK/ARNLEY 1033094, plus the other parts above.

This table covers the Steering Wheel position sensors. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor. Read more

2 Steering Wheel Position Sensor parts are listed for the 2011 Acura TSX, from STANDARD MOTOR PRODUCTS and WELLS.

Part numbers include STANDARD MOTOR PRODUCTS SWS60 and WELLS 5S16766.

This table covers the inner and outer tie-rod ends that steer each front knuckle. Typical signs include play on center, a feathered front tire, or a boot that has split and packed with grit. Replace inner and outer ends together on a high-mileage axle, then get an alignment. Read more

37 Tie Rod End parts for the 2011 Acura TSX come from 14 brands — MEVOTECH, BECK/ARNLEY, DELPHI and 11 other brands. The "Popular" part is DELPHI TA2783. Grades run from Daily Driver through Economy; Economy is the most populated section, led by BECK/ARNLEY, DORMAN, MEVOTECH and 4 other brands.