1993 Asuna Se Cooling System Parts

This table covers the engine coolants and antifreeze formulations specified for this cooling system. Typical signs include a rising temperature gauge, rusty or sludged coolant, or a heater that blows cold. Use the chemistry named in the notes. Mixing silicate, OAT and HOAT formulas can gel in the radiator. Read more

18 Coolant / Antifreeze parts for the 1993 Asuna Se come from 4 brands — PEAK, PRESTONE, FVP and 1 other brand. The "Popular" part is FVP MV5050GAL.

In the Compatible With All Colors grade, PRESTONE supplies 1 part: grouped under the catalog's "Compatible With All Colors" designation — the notes column spells out what sets them apart. A representative part number is PRESTONE AF3055.

The Economy section lists 4 options from FVP, PRESTONE, PEAK and 1 other brand — the catalog's value-priced group. FVP MV5050GAL is listed in this group.

In the Heavy Duty grade, VALVOLINE supplies 1 part: rated for severe service. A representative part number is VALVOLINE 846439.

In the Premium grade, PRESTONE and PEAK supply 4 parts: a step above OE specification in materials, tolerances or warranty terms. A representative part number is PRESTONE AF2100.

In the Standard Replacement grade, PEAK, FVP, PRESTONE and 1 other brand supply 8 parts: built to original-equipment specification. A representative part number is FVP DEX5050GAL.

This table covers the radiators that dump engine heat to airflow through the core. Typical signs include overheating in traffic, a wet core, or coolant that disappears with no puddle. Replace the cap if it cannot hold the rated pressure, and bleed the system after the swap. Read more

This group shows a single part: SPECTRA PREMIUM CU781.

This table covers the caps that hold system pressure at the radiator or reservoir neck. Typical signs include a leak at the neck, a cap that will not hold pressure, or a missing tether. Match the pressure rating or thread in the notes — radiator, reservoir and fuel caps are not interchangeable. Read more

This group shows a single part: GATES 31548.

This table covers the upper, lower and connecting hoses between radiator, engine and reservoir. Typical signs include swelling, cracks, a soft spot, or a leak at a clamp. Replace adjacent aged hoses while the system is drained — they share the same heat cycle. Read more

DAYCO supplies both parts for the 1993 Asuna Se.

Part numbers include DAYCO 71300 and DAYCO 71363.

This table covers the senders that report coolant temperature to the gauge or ECU. Typical signs include a gauge that sits on empty or overheat, or a lamp that does not match what the engine is doing. Rule out the cluster and the wiring before replacing the sender. Read more

11 Temperature Sender / Sensor parts for the 1993 Asuna Se come from 8 brands — STANDARD MOTOR PRODUCTS, WELLS, SKP and 5 other brands. The "Popular" part is SKP SKTX89.

The Economy section: 3 options from SKP, HOLSTEIN and STANDARD MOTOR PRODUCTS. SKP SKTX89 is listed in this group.

Standard Replacement: 8 parts, from STANDARD MOTOR PRODUCTS, WELLS, ACDELCO and 3 other brands. A representative part number is ACDELCO 2134514.

This table covers the seals at the thermostat housing and water outlet. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Thermostat / Thermostat Housing / Water Outlet Seal parts for the 1993 Asuna Se come from 4 brands — GATES, FEL-PRO, JAPANESE OE and 1 other brand. The "Popular" part is GATES 33644.

Part numbers include GATES 33644, FEL-PRO 35410 and GATES 33611, among others listed above.

This table covers the gaskets between the water pump and the block or housing. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: VICTOR REINZ 711416500.

This table covers the Water Pump Seal O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

One part is listed for the 1993 Asuna Se — FEL-PRO 35411.