1993 Asuna Se Engine Parts

This table covers the wear sleeves used to restore a Camshaft seal surface. Read more

4 Camshaft Repair Sleeve parts for the 1993 Asuna Se come from 4 brands — BCA, NATIONAL, SCHAEFFLER and 1 other brand.

Listed part numbers: BCA NS99139, NATIONAL 99139 and SCHAEFFLER SR3472, plus the other parts above.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

8 Camshaft Seal parts for the 1993 Asuna Se come from 7 brands — SCHAEFFLER, NATIONAL, SKF and 4 other brands. The "Popular" part is NATIONAL 714436.

Part numbers include NATIONAL 714436, SKF 13709 and BCA NS714436, among others listed above.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 1993 Asuna Se — SEALED POWER 44210CP.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1993 Asuna Se — FEL-PRO CS9553.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: SEALED POWER 7218M.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

8 Crankshaft Repair Sleeve parts for the 1993 Asuna Se come from 6 brands — BCA, WJB / INMOTION PARTS, FEL-PRO and 3 other brands. The "Popular" part is BCA NS99315.

Listed part numbers: BCA NS99315, WJB / INMOTION PARTS WS99166 and BCA NS99166, plus the other parts above.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

12 Crankshaft Seal parts for the 1993 Asuna Se come from 8 brands — FEL-PRO, NATIONAL, BCA and 5 other brands. The "Popular" part is FEL-PRO BS40535.

This table covers the cylinder heads that close the top of the block. Read more

This group shows a single part: CYLINDER HEAD EXPRESS GM1601V.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Cylinder Head Gasket parts are listed for the 1993 Asuna Se, from FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

Part numbers include FEL-PRO 9553PT, MAHLE / CLEVITE 5867 and VICTOR REINZ 611119300.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Intake Manifold Gasket parts are listed for the 1993 Asuna Se, from FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

This group includes FEL-PRO MS94021, MAHLE / CLEVITE MS15632 and VICTOR REINZ 111098601.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

4 Motor Mount parts for the 1993 Asuna Se come from 3 brands — ANCHOR, DEA / MARMON RIDE CONTROL and PIONEER.

This group includes ANCHOR 2657, ANCHOR 2658 and DEA / MARMON RIDE CONTROL A6827 and the remaining parts above.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

11 Oil parts for the 1993 Asuna Se come from MOBIL. The "Popular" part is MOBIL 125195.

The Full Synthetic section lists 5 options from MOBIL — full-synthetic oils. MOBIL 125195 is listed in this group.

In the High Mileage (>75,000 Miles) grade, MOBIL supplies 4 parts: oils grouped for high-mileage engines. A representative part number is MOBIL 125201.

The Synthetic Blend section lists 2 options from MOBIL — synthetic-blend oils. MOBIL 124406 is listed in this group.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Drain Plug Gasket parts are listed for the 1993 Asuna Se, from FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

Part numbers include FEL-PRO 70822, MAHLE / CLEVITE 2051 and VICTOR REINZ 711346200.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

15 Oil Filter parts for the 1993 Asuna Se come from 10 brands — CHAMP / LUBER-FINER, BOSCH, VARIOUS MFR and 7 other brands. The "Popular" part is CHAMP / LUBER-FINER PH47.

The Economy section lists 5 options from CHAMP / LUBER-FINER, BOSCH, FVP and 2 other brands — the catalog's value-priced group. CHAMP / LUBER-FINER PH47 is listed in this group.

The High Performance / Heavy Duty section lists 3 options from ACDELCO, MOBIL and WIX — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. ACDELCO UPF47R is listed in this group.

In the Standard Replacement grade, ACDELCO, WIX, BOSCH and 4 other brands supply 7 parts: built to original-equipment specification. A representative part number is ACDELCO PF47E.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Pan Gasket parts for the 1993 Asuna Se come from 3 brands — FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

Listed part numbers: FEL-PRO OS30590C, MAHLE / CLEVITE OS32083TC and VICTOR REINZ 101040301.

This table covers the pistons that travel in each cylinder. Typical signs include knock, blow-by, or a cylinder that will not hold compression. Piston work is a short-block job. Match bore, pin and ring pack in the notes — not the photo. Read more

One part is listed for the 1993 Asuna Se — SILV-O-LITE 3414H.

This table covers the rings that seal each piston to the cylinder wall. Read more

One part is listed for the 1993 Asuna Se — MAHLE / CLEVITE 41612.

This table covers the Timing belts. Typical signs include squeal on cold start, cracked ribs, or glazing. Spin the tensioner and idlers by hand while the belt is off. Read more

2 Timing Belt parts are listed for the 1993 Asuna Se, from CONTINENTAL and DAYCO.

Economy: 1 part, from CONTINENTAL. A representative part number is CONTINENTAL CD203.

The Standard Replacement section: 1 option from DAYCO. DAYCO 95203 is listed in this group.

This group includes CONTINENTAL CD203 and DAYCO 95203.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: FEL-PRO VS50322C.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

This group shows a single part: SEALED POWER HT2056.