2016 Audi R8 Engine Parts

This table covers the Camshaft plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

One part is listed for the 2016 Audi R8 — FEL-PRO TCS46263.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: AJUSA 01567100.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

KING ENGINE BEARINGS supplies both parts for the 2016 Audi R8. All of them fit every engine offered in the 2016 R8.

Part numbers include KING ENGINE BEARINGS CR227XPC and KING ENGINE BEARINGS CR227XPCX.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

AJUSA supplies both parts for the 2016 Audi R8.

This group includes AJUSA 54330300 and AJUSA 54332200.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

2 Crankshaft Main Bearing parts for the 2016 Audi R8 come from KING ENGINE BEARINGS. Every part fits both the 4.2L V8 and the 5.2L V10.

Listed part numbers: KING ENGINE BEARINGS MB1322XPC and KING ENGINE BEARINGS MB1322XPCX.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Crankshaft Seal parts for the 2016 Audi R8 come from 3 brands — AJUSA, ELRING and MAHLE / CLEVITE. 1 part fits every engine; the other 4 are engine-specific.

This group includes AJUSA 15101200, AJUSA 15124200 and AJUSA 15084000 and the remaining parts above.

This table covers the bolts that clamp the cylinder head to the block. Read more

AJUSA supplies both parts for the 2016 Audi R8.

Listed part numbers: AJUSA 81059900 and AJUSA 81085900.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies the 8 Cylinder Head Gasket parts for the 2016 Audi R8.

Part numbers include AJUSA 10204700, AJUSA 10204800 and AJUSA 52637000, among others listed above.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

AJUSA supplies both parts for the 2016 Audi R8.

Part numbers include AJUSA 52633800 and AJUSA 52646100.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

AJUSA supplies both parts for the 2016 Audi R8.

This group includes AJUSA 50569200 and AJUSA 50573700.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Intake Manifold Gasket parts are listed for the 2016 Audi R8, from AJUSA, FEL-PRO and MAHLE / CLEVITE.

Part numbers include AJUSA 24055200, FEL-PRO MS97524 and MAHLE / CLEVITE MS19845.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 01326600.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

5 Oil parts for the 2016 Audi R8 come from VALVOLINE. The "Popular" part is VALVOLINE 787301. Every part fits both the 4.2L V8 and the 5.2L V10.

Part numbers include VALVOLINE 787301, VALVOLINE VV966 and VALVOLINE 852518, among others listed above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

5 Oil Drain Plug Gasket parts are listed for the 2016 Audi R8, from DORMAN, AJUSA and ELRING.

Part numbers include AJUSA 22004800, DORMAN 095143 and DORMAN 095147, among others listed above.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

8 Oil Filter parts for the 2016 Audi R8 come from 8 brands — PRO-TEC, PUROLATOR, VARIOUS MFR and 5 other brands. The "Popular" part is HENGST E813H01D188. Every part fits both the 4.2L V8 and the 5.2L V10.

The Economy section lists 3 options from PRO-TEC, PUROLATOR and VARIOUS MFR — the catalog's value-priced group. PRO-TEC PXL57330 is listed in this group.

In the Standard Replacement grade, HENGST, WIX, ACDELCO and 2 other brands supply 5 parts: built to original-equipment specification. A representative part number is HENGST E813H01D188.

Listed part numbers: HENGST E813H01D188, PRO-TEC PXL57330 and PUROLATOR L35843, plus the other parts above.

This table covers the gaskets that seal the Oil Filter. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2016 Audi R8 — AJUSA 01318900.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING 030793.

This table covers the Thrust washers. Read more

This group shows a single part: KING ENGINE BEARINGS TW2027AM.

This table covers the timing chains that keep the cams in time with the crank. Read more

INA supplies the 4 Timing Chain parts for the 2016 Audi R8. All of them fit every engine offered in the 2016 R8.

This group includes INA ZC0229, INA ZC02491 and INA ZC0023 and the remaining parts above.

This table covers the guides and dampers that keep the timing chain on its path. Read more

One part is listed for the 2016 Audi R8 — ÜRO PARTS 079109470.

This table covers the tensioners that keep the timing chain taut. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

This group shows a single part: INA ZT0058.

This table covers the seals at the Timing Chain Tensioner Gasket. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

ELRING supplies both parts for the 2016 Audi R8.

Part numbers include ELRING 236070 and ELRING 174130.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Valve Cover Gasket parts for the 2016 Audi R8 come from AJUSA.

This group includes AJUSA 56052900, AJUSA 56053000 and AJUSA 56087300 and the remaining parts above.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

This group shows a single part: AJUSA 85009000.

This table covers the keepers that lock each valve-spring retainer to the stem. Read more

One part is listed for the 2016 Audi R8 — MELLING VL1098.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Valve Stem Seal parts for the 2016 Audi R8 come from 2 brands — AJUSA and ELRING.

Part numbers include AJUSA 57058000, AJUSA 57058100 and ELRING 724590, among others listed above.

This table covers the oil-control solenoids that command the cam phasers. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

5 Variable Valve Timing (VVT) Solenoid / Actuator parts for the 2016 Audi R8 come from 4 brands — DORMAN, ROSTRA, SKP and 1 other brand.

Listed part numbers: DORMAN 918061, DORMAN 918131 and ROSTRA 790047, plus the other parts above.