The 2016 Audi R8 has one listed steering part: a Steering Wheel Position Sensor from VEMO, covering both the 4.2L V8 and the 5.2L V10. It includes a manufacturer part number and application notes.
On the 2016 Audi R8, the steering system connects driver to road through the rack, pump, tie rods, and column components.
The 2016 Audi R8 was sold with both the 4.2L V8 and the 5.2L V10. The single part on this page fits every engine.
The part number opens a page with every vehicle that part fits.
Steering Wheel Position Sensor
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| VEMO Fits: all 2016 R8 engines | V10721264 | 🇲🇽 MX | Angle Sensor | View on Amazon |
This table covers the Steering Wheel position sensors. Typical signs include a stall, a no-start, or a code for cam or crank correlation. Check the connector and the reluctor gap before replacing the sensor.
This group shows a single part: VEMO V10721264.
Buying Steering Parts for a 2016 Audi R8
On this vehicle, the steering system connects driver to road through the rack, pump, tie rods, and column components.
- You do not need to pick an engine: every steering part on this page fits both the 4.2L V8 and the 5.2L V10.
- Read the notes on each row for position, trim and spec qualifiers before you order.
- Where labor overlaps, replace the inner and outer tie-rod ends together on higher-mileage vehicles, then get an alignment.
- Cross-reference the manufacturer part number against your old part or a service-manual listing.
Start with the largest groups on this page: Steering Wheel Position Sensor .
Frequently Asked Questions
How many steering parts fit the 2016 Audi R8?
This page lists one steering part for the 2016 Audi R8: a Steering Wheel Position Sensor from VEMO, covering both the 4.2L V8 and the 5.2L V10.
Do steering parts differ between 2016 Audi R8 engines?
No. On this page every steering part fits both the 4.2L V8 and the 5.2L V10. You do not need to pick an engine to choose the right row — use the notes for position and trim.
What are the signs of steering problems on a 2016 Audi R8?
Common symptoms include play or looseness on center, a whine when turning, fluid weeping from rack boots, or uneven tire wear on the front axle. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.
What should I replace at the same time?
Where labor overlaps, replace the inner and outer tie-rod ends together on higher-mileage vehicles, then get an alignment.
What do the market flags (US, CA, MX) on each part mean?
They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2016 Audi R8 was originally sold in the US, the safest choice is a part marked for the US market.
How do I make sure a part fits my 2016 Audi R8?
Every part on this page already fits both the 4.2L V8 and the 5.2L V10. Then flush old power-steering fluid when replacing a pump or rack — grit in the old fluid is the number-one cause of repeat failure. The notes column carries position and trim qualifiers where they apply.
Other Parts for the 2016 Audi R8
Steering Parts for Other Audi R8 Years
Switch vehicle or jump to a subcategory
Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.