This page lists 5 ignition parts for the 1959 Austin-Healey Sprite, across 3 part types, covering the 948cc L4 engine. Every part shows its brand, manufacturer part number and fitment notes.
On the 1959 Austin-Healey Sprite, the ignition system delivers spark at the right moment — plugs, coils, wires, distributors and ignition modules. All 5 listed parts are Condenser / Capacitor (3 parts), Distributor Cap (1 part) and Distributor Rotor (1 part).
Every part on this page is matched to the 948cc L4 — the only engine offered in the 1959 Austin-Healey Sprite.
The most listed brands for 1959 Austin-Healey Sprite ignition parts are STANDARD MOTOR PRODUCTS (4 parts) and WELLS (1 part). Quality grades include Standard Replacement and Economy.
Each part number listed for the 1959 Austin-Healey Sprite opens a page with every vehicle that part fits.
Condenser / Capacitor
Economy
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| STANDARD MOTOR PRODUCTS | LU206T | 🇺🇸 US | T-Series | View on Amazon |
Standard Replacement
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| STANDARD MOTOR PRODUCTS | LU206 | 🇺🇸 US | View on Amazon | |
| WELLS | 5H1011 | 🇺🇸 US | with Lucas Distributor | View on Amazon |
This table covers the capacitors used in this electrical or A/C circuit.
3 Condenser / Capacitor parts are listed for the 1959 Austin-Healey Sprite, from STANDARD MOTOR PRODUCTS and WELLS.
In the Economy grade, STANDARD MOTOR PRODUCTS supplies 1 part: the catalog's value-priced group. A representative part number is STANDARD MOTOR PRODUCTS LU206T.
The Standard Replacement section lists 2 options from STANDARD MOTOR PRODUCTS and WELLS — built to original-equipment specification. STANDARD MOTOR PRODUCTS LU206 is listed in this group.
Listed part numbers: STANDARD MOTOR PRODUCTS LU206T, STANDARD MOTOR PRODUCTS LU206 and WELLS 5H1011.
Distributor Cap
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| STANDARD MOTOR PRODUCTS | LU420 | 🇺🇸 US | View on Amazon |
This table covers the Distributor caps. Typical signs include a leak at the neck, a cap that will not hold pressure, or a missing tether. Match the pressure rating or thread in the notes — radiator, reservoir and fuel caps are not interchangeable.
This group shows a single part: STANDARD MOTOR PRODUCTS LU420.
Distributor Rotor
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| STANDARD MOTOR PRODUCTS | LU300 | 🇺🇸 US | View on Amazon |
This table covers the Distributor rotors. Typical signs include shudder under braking, or a lip at the outer edge. Do not put new pads on a rotor that is below minimum thickness.
This group shows a single part: STANDARD MOTOR PRODUCTS LU300.
Buying Ignition Parts for a 1959 Austin-Healey Sprite
On this vehicle, the ignition system delivers spark at the right moment — plugs, coils, wires, distributors and ignition modules.
- Confirm you have the 948cc L4 engine — every part on this page is matched to it.
- Read the notes on each row for position, trim and spec qualifiers before you order.
- Where labor overlaps, replace plugs and wires (or coil boots) as a set — one weak cylinder makes the whole set feel bad.
- Cross-reference the manufacturer part number against your old part or a service-manual listing.
Start with the largest groups on this page: Condenser / Capacitor and Distributor Cap .
Frequently Asked Questions
How many ignition parts fit the 1959 Austin-Healey Sprite?
Our catalog currently lists 5 ignition parts for the 1959 Austin-Healey Sprite across 3 subcategories and 2 brands, covering the 948cc L4 engine. Each part is matched to the engine(s) it fits.
What are the signs of ignition problems on a 1959 Austin-Healey Sprite?
Common symptoms include misfires under load, rough idle, flashing check-engine light, or poor starting in damp weather. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.
What should I replace at the same time?
Where labor overlaps, replace plugs and wires (or coil boots) as a set — one weak cylinder makes the whole set feel bad.
What do the market flags (US, CA, MX) on each part mean?
They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1959 Austin-Healey Sprite was originally sold in the US, the safest choice is a part marked for the US market.
How do I make sure a part fits my 1959 Austin-Healey Sprite?
Every part on this page is matched to the 948cc L4 engine. Then gap matters even on “pre-gapped” plugs — verify against spec, and replace coil boots when they come off a high-mileage engine. The notes column carries position and trim qualifiers where they apply.
Other Parts for the 1959 Austin-Healey Sprite
Ignition Parts for Other Austin-Healey Sprite Years
Switch vehicle or jump to a subcategory
Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.