2020 BMW 120I Engine Parts

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2020 BMW 120I — AJUSA 54263900.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Crankshaft Seal parts for the 2020 BMW 120I come from AJUSA.

Part numbers include AJUSA 15075200 and AJUSA 15107900.

This table covers the bolts that clamp the cylinder head to the block. Read more

One part is listed for the 2020 BMW 120I — AJUSA 81065000.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies both parts for the 2020 BMW 120I.

Listed part numbers: AJUSA 10220600 and AJUSA 10220610.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2020 BMW 120I — AJUSA 52503900.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2020 BMW 120I — AJUSA 50453600.

This table covers the gaskets that seal the Oil Cooler. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies both parts for the 2020 BMW 120I.

Listed part numbers: AJUSA 77005900 and AJUSA 77006000.

This table covers the drain plugs in the oil pan. Read more

2 Oil Drain Plug parts for the 2020 BMW 120I come from 2 brands — AGS and DORMAN.

Listed part numbers: AGS ODP00010 and DORMAN 090088.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2020 BMW 120I — AJUSA 21010400.

This table covers the caps on the oil filler neck. Read more

This group shows a single part: MOTORAD MO156.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

This group shows a single part: VARIOUS MFR PO99521EX.

This table covers the gaskets that seal the Timing Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 77090600.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Turbocharger Gasket parts are listed for the 2020 BMW 120I, from AJUSA and ELRING.

Listed part numbers: AJUSA JTC11993 and ELRING 094830.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

This group shows a single part: AJUSA OP10925.

This table covers the Turbocharger Oil Line Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

This group shows a single part: AJUSA 16006101.

This table covers the Turbocharger Wastegate Solenoid actuators. Typical signs include a door or range that will not move, or a click with no motion. Confirm the command signal before replacing the actuator — a failed module looks the same. Read more

This group shows a single part: DORMAN 667845.

This table covers the Valve covers. Read more

2 Valve Cover parts are listed for the 2020 BMW 120I, from DORMAN and SKP.

Listed part numbers: DORMAN 264772 and SKP SK743462.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 11140100.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

This group shows a single part: AJUSA 85022300.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Valve Stem Seal parts for the 2020 BMW 120I come from AJUSA.

Listed part numbers: AJUSA 57067700, AJUSA 12027900 and AJUSA 12028200.