2020 BMW 220I Engine Parts

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Conversion / Lower Gasket Set parts for the 2020 BMW 220I come from AJUSA.

Listed part numbers: AJUSA 54228800 and AJUSA 54263900.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 2020 BMW 220I.

Listed part numbers: AJUSA 15075200 and AJUSA 15107900.

This table covers the bolts that clamp the cylinder head to the block. Read more

This group shows a single part: AJUSA 81065000.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts for the 2020 BMW 220I come from AJUSA.

Part numbers include AJUSA 10220600 and AJUSA 10220610.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Cylinder Head Gasket Set parts for the 2020 BMW 220I come from AJUSA.

Listed part numbers: AJUSA 52438900 and AJUSA 52503900.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Engine Kit Gasket Set parts for the 2020 BMW 220I come from AJUSA.

Listed part numbers: AJUSA 50400500 and AJUSA 50453600.

This table covers the high-pressure oil pumps that fire HEUI diesel injectors. Typical signs include noise from the pump, no pressure, or fluid that never arrives at the outlet. Prime or fill the pump as the notes require. A dry start is a common way to kill a new unit. Read more

One part is listed for the 2020 BMW 220I — MARELLI PHP1013.

This table covers the Intake manifolds. Typical signs include an exhaust tick, a vacuum leak, or a gasket that has burned through. Replace the gaskets and hardware; a warped flange will leak with a new gasket alone. Read more

One part is listed for the 2020 BMW 220I — MARELLI CAB501.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 24039500.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

9 Motor Mount parts are listed for the 2020 BMW 220I, from ANCHOR, DEA / MARMON RIDE CONTROL, PIONEER and 2 other brands. ANCHOR 9983 carries the "Popular" badge.

In the Economy grade, VAICO supplies 1 part: the catalog's value-priced group. A representative part number is VAICO V204315.

The Standard Replacement section lists 8 options from ANCHOR, DEA / MARMON RIDE CONTROL, PIONEER and 1 other brand — built to original-equipment specification. ANCHOR 9983 is listed in this group.

Part numbers include ANCHOR 9983, VAICO V204315 and DEA / MARMON RIDE CONTROL A4082, among others listed above.

This table covers the Motor Mount kits. Read more

One part is listed for the 2020 BMW 220I — ANCHOR 300955.

This table covers the heat exchangers that cool engine oil. Typical signs include oil at the cooler fittings, or coolant that looks like a milkshake. Pressure-test both circuits after a cooler swap — a leak here mixes oil and coolant. Read more

One part is listed for the 2020 BMW 220I — MARELLI RO0044.

This table covers the gaskets that seal the Oil Cooler. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Cooler Gasket parts for the 2020 BMW 220I come from AJUSA.

Listed part numbers: AJUSA 77005900 and AJUSA 77005800.

This table covers the drain plugs in the oil pan. Read more

2 Oil Drain Plug parts are listed for the 2020 BMW 220I, from AGS and DORMAN.

This group includes AGS ODP00010 and DORMAN 090088.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 21010400.

This table covers the caps on the oil filler neck. Read more

One part is listed for the 2020 BMW 220I — MOTORAD MO214.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

One part is listed for the 2020 BMW 220I — VARIOUS MFR PO99521EX.

This table covers the Oil Filter covers. Read more

2 Oil Filter Cover parts for the 2020 BMW 220I come from 2 brands — DORMAN and SKP.

This group includes DORMAN 921115 and SKP SK921115.

This table covers the gaskets that seal the Timing Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2020 BMW 220I — AJUSA 77090600.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Turbocharger Gasket parts for the 2020 BMW 220I come from 2 brands — ELRING and AJUSA.

This group includes AJUSA JTC11993, ELRING 087320 and ELRING 074140.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

One part is listed for the 2020 BMW 220I — AJUSA OP10925.

This table covers the Turbocharger Oil Line Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

One part is listed for the 2020 BMW 220I — AJUSA 16006101.

This table covers the Valve covers. Read more

2 Valve Cover parts for the 2020 BMW 220I come from 2 brands — DORMAN and SKP.

This group includes DORMAN 264772 and SKP SK743462.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2020 BMW 220I — AJUSA 11140100.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

AJUSA supplies both parts for the 2020 BMW 220I.

This group includes AJUSA 85009300 and AJUSA 85022300.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies the 3 Valve Stem Seal parts for the 2020 BMW 220I.

Listed part numbers: AJUSA 57067700, AJUSA 12027900 and AJUSA 12028200.