2021 BMW 440I Engine Parts

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2021 BMW 440I — AJUSA 54265400.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: KING ENGINE BEARINGS MB7779SM.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Crankshaft Seal parts for the 2021 BMW 440I come from 2 brands — AJUSA and VICTOR REINZ.

This group includes AJUSA 15075200, AJUSA 15107900 and VICTOR REINZ 813700200 and the remaining parts above.

This table covers the bolts that clamp the cylinder head to the block. Read more

2 Cylinder Head Bolt parts are listed for the 2021 BMW 440I, from AJUSA and VICTOR REINZ.

Listed part numbers: AJUSA 81069200 and VICTOR REINZ 141226103.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Cylinder Head Gasket parts are listed for the 2021 BMW 440I, from AJUSA and VICTOR REINZ.

Part numbers include AJUSA 10230610, AJUSA 10230600 and VICTOR REINZ 611021500, among others listed above.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2021 BMW 440I — AJUSA 52505800.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2021 BMW 440I — AJUSA 50455400.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2021 BMW 440I — VICTOR REINZ 711243900.

This table covers the gaskets that seal the Oil Cooler. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2021 BMW 440I — AJUSA 77010300.

This table covers the drain plugs in the oil pan. Read more

This group shows a single part: DORMAN 090088.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Drain Plug Gasket parts are listed for the 2021 BMW 440I, from AJUSA and VICTOR REINZ.

Listed part numbers: AJUSA 21010400 and VICTOR REINZ 417005800.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

3 Oil Filter parts for the 2021 BMW 440I come from 3 brands — MOBIL, MAHLE / CLEVITE and VARIOUS MFR.

The High Performance / Heavy Duty section lists 1 option from MOBIL — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. MOBIL M1C457A is listed in this group.

In the Standard Replacement grade, MAHLE / CLEVITE and VARIOUS MFR supply 2 parts: built to original-equipment specification. A representative part number is MAHLE / CLEVITE OX1146D.

Listed part numbers: MOBIL M1C457A, MAHLE / CLEVITE OX1146D and VARIOUS MFR PG99256EX.

This table covers the Oil Filter housings. Read more

One part is listed for the 2021 BMW 440I — HENGST H811H.

This table covers the Oil Level Sensor Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

This group shows a single part: AJUSA 01311200.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: VICTOR REINZ 703141410.

This table covers the Turbocharger Coolant lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

5 Turbocharger Coolant Line parts for the 2021 BMW 440I come from REIN. The "Popular" part is REIN CHT0962.

Part numbers include REIN CHT0962, REIN CHT0963 and REIN CHT0964, among others listed above.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2021 BMW 440I — AJUSA JTC12328.

This table covers the fasteners that mount the turbocharger. Read more

One part is listed for the 2021 BMW 440I — REIN TRK0025.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

3 Turbocharger Oil Line parts for the 2021 BMW 440I come from 2 brands — REIN and AJUSA.

This group includes AJUSA OP10964, REIN TFP0390 and REIN TRP0391.

This table covers the Turbocharger Oil Line Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

This group shows a single part: AJUSA 16007800.

This table covers the Valve covers. Read more

3 Valve Cover parts are listed for the 2021 BMW 440I, from REIN and SKP.

Listed part numbers: REIN VCE0113, REIN VCK0113 and SKP SK743462.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Valve Cover Gasket parts for the 2021 BMW 440I come from 2 brands — AJUSA and VICTOR REINZ.

Listed part numbers: AJUSA 56068700 and VICTOR REINZ 151248001.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

This group shows a single part: AJUSA 85022300.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Valve Stem Seal parts for the 2021 BMW 440I come from 2 brands — AJUSA and VICTOR REINZ. The "Popular" part is VICTOR REINZ 123686601.

This group includes VICTOR REINZ 123686601, AJUSA 57051500 and AJUSA 12027900 and the remaining parts above.

This table covers the seals at the Variable Valve Timing (VVT) Solenoid Gasket. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2021 BMW 440I — AJUSA 01907000.