1974 Bricklin SV-1 Engine Parts

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 1974 Bricklin SV-1 — KING ENGINE BEARINGS CR818SI.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: KING ENGINE BEARINGS MB5518AM.

This table covers the wear sleeves used to restore a Crankshaft Main Bearing seal surface. Read more

One part is listed for the 1974 Bricklin SV-1 — MAHLE / CLEVITE A222.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Crankshaft Seal parts for the 1974 Bricklin SV-1 come from 6 brands — FEL-PRO, NATIONAL, BCA and 3 other brands. The "Popular" part is FEL-PRO BS40003.

Part numbers include FEL-PRO BS40003, NATIONAL 710447 and BCA NS710447, among others listed above.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts are listed for the 1974 Bricklin SV-1, from FEL-PRO and MAHLE / CLEVITE.

This group includes FEL-PRO 8266PT1 and MAHLE / CLEVITE 3467.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

3 Cylinder Head Gasket Set parts are listed for the 1974 Bricklin SV-1, from FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

Part numbers include FEL-PRO HS8266PT4, MAHLE / CLEVITE HS3467 and VICTOR REINZ 021032401.

This table covers the block heaters that warm the coolant or oil in cold weather. Read more

This group shows a single part: KAT'S HEATERS 11610.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

4 Engine Kit Gasket Set parts are listed for the 1974 Bricklin SV-1, from ENGINE PRO, FEL-PRO, MAHLE / CLEVITE and 1 other brand.

Part numbers include ENGINE PRO 301151, FEL-PRO FS8266PT4 and MAHLE / CLEVITE 953339, among others listed above.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Intake Manifold Gasket parts are listed for the 1974 Bricklin SV-1, from FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

This group includes FEL-PRO MS96011, MAHLE / CLEVITE MS15922 and VICTOR REINZ 101004201.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

2 Oil Filter parts for the 1974 Bricklin SV-1 come from 2 brands — VARIOUS MFR and WIX.

The Economy section lists 1 option from VARIOUS MFR — the catalog's value-priced group. VARIOUS MFR PG33 is listed in this group.

In the Standard Replacement grade, WIX supplies 1 part: built to original-equipment specification. A representative part number is WIX 51049.

Listed part numbers: VARIOUS MFR PG33 and WIX 51049.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Pan Gasket parts for the 1974 Bricklin SV-1 come from 3 brands — FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

This group includes FEL-PRO OS30187C, MAHLE / CLEVITE OS30538 and VICTOR REINZ 101016401.

This table covers the pistons that travel in each cylinder. Typical signs include knock, blow-by, or a cylinder that will not hold compression. Piston work is a short-block job. Match bore, pin and ring pack in the notes — not the photo. Read more

SILV-O-LITE supplies both parts for the 1974 Bricklin SV-1.

This group includes SILV-O-LITE 2225C and SILV-O-LITE 2225CK1.

This table covers the gaskets that seal the Timing Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

5 Timing Cover Gasket parts for the 1974 Bricklin SV-1 come from 3 brands — FEL-PRO, VICTOR REINZ and MAHLE / CLEVITE. The "Popular" part is FEL-PRO TCS45003.

Part numbers include FEL-PRO TCS45003, FEL-PRO TCS45271 and MAHLE / CLEVITE JV870, among others listed above.

This table covers the wear sleeves used to restore a Timing Cover seal surface. Read more

This group shows a single part: VICTOR REINZ 711450500.

This table covers the Timing Cover Repair Sleeve tools. This is a service tool, not a wear part — match the application in the notes. Read more

This group shows a single part: VICTOR REINZ 711647000.

This table covers the seals at the Timing Cover. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: MAHLE / CLEVITE 46483.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Valve Cover Gasket parts for the 1974 Bricklin SV-1 come from 3 brands — FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

This group includes FEL-PRO VS50001C, MAHLE / CLEVITE VS28317 and VICTOR REINZ 151041901.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Valve Stem Seal parts for the 1974 Bricklin SV-1 come from 3 brands — FEL-PRO, MAHLE / CLEVITE and VICTOR REINZ.

This group includes FEL-PRO SS70529, MAHLE / CLEVITE SS45298 and VICTOR REINZ 121008001.