2004 Chrysler Sebring Electrical Parts

This table covers the alternators that charge the battery and run the electrical load. Typical signs include dim lights at idle, a battery lamp, or a growl from the charging pulley. Load-test the battery and inspect the belt and grounds — a bad ground mimics a failed alternator. Read more

24 Alternator / Generator parts for the 2004 Chrysler Sebring come from 11 brands — PURE ENERGY, ACDELCO, FVP and 8 other brands. The "Popular" part is SKP SK13886.

The New section lists 11 options from WAI GLOBAL, PURE ENERGY, SKP and 6 other brands — brand-new units rather than rebuilt ones. SKP SK13886 is listed in this group.

The Remanufactured section lists 13 options from ACDELCO, FVP, PURE ENERGY and 5 other brands — factory-rebuilt units with new wear components. DENSO 2101057 is listed in this group.

This table covers the rectifier diode packs in the alternator. Read more

2 Alternator / Generator Diode Rectifier parts for the 2004 Chrysler Sebring come from 2 brands — BOSCH and WELLS.

This group includes BOSCH 1986AE0609 and WELLS 2D3092.

This table covers the bearings in the alternator housing. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 2004 Chrysler Sebring — WELLS 7D1094.

This table covers the Alternator / Generator stators. Read more

One part is listed for the 2004 Chrysler Sebring — BOSCH 1986AE0684.

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery. Read more

FULLRIVER supplies both parts for the 2004 Chrysler Sebring.

This group includes FULLRIVER FT82534 and FULLRIVER FT61047.

This table covers the positive and ground cables that run from the battery. Typical signs include a stretched or frayed cable, or a control that no longer reaches the end of its travel. Route the new cable through the same clips. A kinked cable binds and fails early. Read more

2 Battery Cable parts for the 2004 Chrysler Sebring come from 2 brands — MOPAR and STANDARD MOTOR PRODUCTS.

Listed part numbers: MOPAR 4608620AD and STANDARD MOTOR PRODUCTS A456HD.

This table covers the Battery covers. Read more

This group shows a single part: MOPAR MR958697.

This table covers the terminals and clamps that connect cables to the battery posts. Read more

DEKA supplies both parts for the 2004 Chrysler Sebring.

Part numbers include DEKA 00350 and DEKA 01056.

This table covers the covers that protect battery terminals. Read more

One part is listed for the 2004 Chrysler Sebring — MOPAR 5083072AA.

This table covers the trays the battery sits in. Read more

3 Battery Tray parts are listed for the 2004 Chrysler Sebring, from DORMAN, MOPAR and SKP.

Part numbers include DORMAN 00077, MOPAR 4646511AC and SKP SK00077.

This table covers the body-control modules that run lighting, locks and wipers. Read more

2 Body Control Module (BCM) parts for the 2004 Chrysler Sebring come from MOPAR.

Part numbers include MOPAR 4602368AJ and MOPAR 4602379AJ.

This table covers the resettable circuit breakers in this vehicle's electrical system. Read more

5 Circuit Breaker parts are listed for the 2004 Chrysler Sebring, from BUSSMANN and LITTELFUSE. BUSSMANN CBB30 carries the "Popular" badge.

In the 20 Amp grade, BUSSMANN and LITTELFUSE supply 2 parts: grouped under the catalog's "20 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ACB20.

The 30 Amp section lists 2 options from BUSSMANN and LITTELFUSE — grouped under the catalog's "30 Amp" designation — the notes column spells out what sets them apart. BUSSMANN CBB30 is listed in this group.

1 ungrouped part is not assigned to a grade, with the same engine-level match.

Listed part numbers: BUSSMANN CBB30 and BUSSMANN ACB20, plus the other parts above.

This table covers the engine-control modules that run fuel, spark and emissions. Read more

This group shows a single part: DORMAN 318317.

This table covers the flasher units that blink the turn signals and hazards. Read more

5 Flasher parts are listed for the 2004 Chrysler Sebring, from BUSSMANN, FAMOUS BRAND, STANDARD MOTOR PRODUCTS and 2 other brands. BUSSMANN 727 carries the "Popular" badge.

Part numbers include BUSSMANN 727, FAMOUS BRAND FCA1023 and STANDARD MOTOR PRODUCTS EFL95, among others listed above.

This table covers the replacement fuses for this vehicle's fuse boxes. Typical signs include one circuit dead while its neighbor still works, or a fuse that blows again as soon as you replace it. Match amperage and fuse type. A repeat blow means a short — find it before the next fuse. Read more

40 Fuse parts are listed for the 2004 Chrysler Sebring, from BUSSMANN, LITTELFUSE, MOPAR and 1 other brand. BUSSMANN ATM10 carries the "Popular" badge. Grades run from 10 Amp through 7.5 Amp; 30 Amp is the most populated section, led by BUSSMANN and LITTELFUSE.

This table covers the Fuse pullers. This is a service tool. Confirm the application in the notes before ordering. Read more

One part is listed for the 2004 Chrysler Sebring — MOPAR MR172647.

This table covers the horns mounted in the front of the vehicle. Read more

FIAMM supplies the 11 Horn parts for the 2004 Chrysler Sebring. FIAMM 72112 carries the "Popular" badge.

In the Accessory Replacement grade, FIAMM supplies 5 parts: grouped under the catalog's "Accessory Replacement" designation — the notes column spells out what sets them apart. A representative part number is FIAMM 72112.

The Standard Replacement section lists 6 options from FIAMM — built to original-equipment specification. FIAMM 7421122 is listed in this group.

This table covers the key fobs that lock, unlock and start the vehicle. Read more

This group shows a single part: DORMAN 13776.

This table covers the replacement shells for the key fob. Read more

This group shows a single part: DORMAN 13609.

This table covers the powertrain-control modules that run engine and transmission. Read more

MOPAR supplies the 4 Powertrain Control Module (PCM) parts for the 2004 Chrysler Sebring.

This group includes MOPAR 4606812AB, MOPAR 4896102AE and MOPAR 4896107AF and the remaining parts above.

This table covers the capacitors that suppress radio noise. Read more

2 Radio Capacitor parts are listed for the 2004 Chrysler Sebring, from STANDARD MOTOR PRODUCTS and WELLS.

Listed part numbers: STANDARD MOTOR PRODUCTS RC34 and WELLS 1B1019.

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

48 Speed Sensor parts are listed for the 2004 Chrysler Sebring, from STANDARD MOTOR PRODUCTS, WELLS, GPD and 13 other brands. SKP SK917610 carries the "Popular" badge. Economy, Full Service Kit and Standard Replacement are all represented, and Standard Replacement alone accounts for 26 parts.

This table covers the starter motors that crank the engine. Typical signs include no motion, a squeal, or a motor that only runs on one speed. Confirm power, ground and the control module before replacing the motor. Read more

13 Starter Motor parts for the 2004 Chrysler Sebring come from 9 brands — TYC, PURE ENERGY, REMY and 6 other brands. The "Popular" part is TYC 117795.

The New section: 7 options from TYC, ACDELCO, PURE ENERGY and 3 other brands. TYC 117795 is listed in this group.

The Remanufactured section: 6 options from PURE ENERGY, BOSCH, DENSO and 3 other brands. PURE ENERGY 19462 is listed in this group.

This table covers the Starter Motor Heat shields. Typical signs include a bent shield rubbing a rotor, or rust-through that leaves the backing open. A rubbing shield will eat a new rotor. Straighten or replace it before the wheel goes back on. Read more

MOPAR supplies the 3 Starter Motor Heat Shield parts for the 2004 Chrysler Sebring.

This group includes MOPAR 4593529AC, MOPAR 4593529AD and MOPAR 4861621AA.