2013 Chrysler 200 Electrical Parts

This table covers the alternators that charge the battery and run the electrical load. Typical signs include dim lights at idle, a battery lamp, or a growl from the charging pulley. Load-test the battery and inspect the belt and grounds — a bad ground mimics a failed alternator. Read more

12 Alternator / Generator parts for the 2013 Chrysler 200 come from 8 brands — FVP, REMY, TERREPOWER and 5 other brands. The "Popular" part is FVP 11580N.

The New section lists 5 options from FVP, PURE ENERGY, REMY and 2 other brands — brand-new units rather than rebuilt ones. FVP 11580N is listed in this group.

The Remanufactured section lists 7 options from TERREPOWER, WAI GLOBAL, BOSCH and 4 other brands — factory-rebuilt units with new wear components. TERREPOWER 11570 is listed in this group.

This table covers the pulleys on the alternator shaft. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt. Read more

4 Alternator / Generator Pulley parts are listed for the 2013 Chrysler 200, from CONTINENTAL, DORMAN, INA and 1 other brand.

This group includes CONTINENTAL 49937, DORMAN 300888 and INA EA0257 and the remaining parts above.

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery. Read more

2 Battery parts are listed for the 2013 Chrysler 200, from BOSCH and FULLRIVER.

The AGM (Extended Life) section lists 1 option from BOSCH — grouped under the catalog's "AGM (Extended Life)" designation — the notes column spells out what sets them apart. BOSCH S675DT is listed in this group.

The Performance AGM (Extended Life + Increased Power) section lists 1 option from FULLRIVER — grouped under the catalog's "Performance AGM (Extended Life + Increased Power)" designation — the notes column spells out what sets them apart. FULLRIVER FT82534 is listed in this group.

This group includes BOSCH S675DT and FULLRIVER FT82534.

This table covers the positive and ground cables that run from the battery. Typical signs include a stretched or frayed cable, or a control that no longer reaches the end of its travel. Route the new cable through the same clips. A kinked cable binds and fails early. Read more

4 Battery Cable parts for the 2013 Chrysler 200 come from 2 brands — MOPAR and STANDARD MOTOR PRODUCTS.

This group includes MOPAR 4795599AJ, MOPAR 4672334AA and STANDARD MOTOR PRODUCTS A304T and the remaining parts above.

This table covers the clamps and brackets that secure the battery. Read more

5 Battery Hold Down parts for the 2013 Chrysler 200 come from 2 brands — DORMAN and SKP. The "Popular" part is DORMAN 00083.

This group includes DORMAN 00083, DORMAN 00082 and DORMAN 00081 and the remaining parts above.

This table covers the terminals and clamps that connect cables to the battery posts. Read more

One part is listed for the 2013 Chrysler 200 — MOPAR 68358319AA.

This table covers the covers that protect battery terminals. Read more

One part is listed for the 2013 Chrysler 200 — MOPAR 68358318AA.

This table covers the trays the battery sits in. Read more

2 Battery Tray parts are listed for the 2013 Chrysler 200, from DORMAN and MOPAR.

Listed part numbers: DORMAN 00071 and MOPAR 5155731AA.

This table covers the Door control modules. Read more

MOPAR supplies both parts for the 2013 Chrysler 200.

This group includes MOPAR 4602922AF and MOPAR 68051931AB.

This table covers the replacement fuses for this vehicle's fuse boxes. Typical signs include one circuit dead while its neighbor still works, or a fuse that blows again as soon as you replace it. Match amperage and fuse type. A repeat blow means a short — find it before the next fuse. Read more

18 Fuse parts are listed for the 2013 Chrysler 200, from BUSSMANN and MOPAR. BUSSMANN ATM10 carries the "Popular" badge.

The 10 Amp section lists 3 options from BUSSMANN and MOPAR — grouped under the catalog's "10 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM10 is listed in this group.

In the 15 Amp grade, BUSSMANN and MOPAR supply 3 parts: grouped under the catalog's "15 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM15.

In the 20 Amp grade, BUSSMANN and MOPAR supply 3 parts: grouped under the catalog's "20 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM20.

The 25 Amp section lists 3 options from BUSSMANN and MOPAR — grouped under the catalog's "25 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM25 is listed in this group.

The 30 Amp section lists 4 options from BUSSMANN — grouped under the catalog's "30 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM30 is listed in this group.

In the 40 Amp grade, BUSSMANN supplies 2 parts: grouped under the catalog's "40 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN FMX40.

This table covers the Fuse Box covers. Read more

MOPAR supplies the 3 Fuse Box Cover parts for the 2013 Chrysler 200.

Listed part numbers: MOPAR 68197366AA, MOPAR 68197367AA and MOPAR 68224787AA.

This table covers the horns mounted in the front of the vehicle. Read more

15 Horn parts are listed for the 2013 Chrysler 200, from FIAMM and MOPAR. FIAMM 7210223 carries the "Popular" badge.

In the Accessory Replacement grade, FIAMM supplies 7 parts: grouped under the catalog's "Accessory Replacement" designation — the notes column spells out what sets them apart. A representative part number is FIAMM 7210223.

The Standard Replacement section lists 8 options from FIAMM and MOPAR — built to original-equipment specification. FIAMM 7201223 is listed in this group.

This table covers the receivers that pick up the key-fob unlock signal. Read more

3 Keyless Entry Module / Receiver parts for the 2013 Chrysler 200 come from MOPAR.

Listed part numbers: MOPAR 5026162AU, MOPAR 5026157AU and MOPAR 5026165AS.

This table covers the key fobs that lock, unlock and start the vehicle. Read more

3 Keyless Entry Remote parts for the 2013 Chrysler 200 come from DORMAN.

Part numbers include DORMAN 99173, DORMAN 99173ST and DORMAN 99269ST.

This table covers the Mobile Phone Hands Free control modules. Read more

One part is listed for the 2013 Chrysler 200 — MOPAR 82212499.

This table covers the totally-integrated power modules that distribute body electrical power. Typical signs include a cluster of unrelated faults, a no-communication code, or a module that will not sleep. Confirm power, ground and programming compatibility in the notes. Modules are rarely plug-and-play across years. Read more

2 Power Supply Module (TIPM) parts are listed for the 2013 Chrysler 200, from DORMAN and MOPAR.

Part numbers include DORMAN 598711 and MOPAR R4692346AE.

This table covers the powertrain-control modules that run engine and transmission. Read more

MOPAR supplies both parts for the 2013 Chrysler 200.

Part numbers include MOPAR 5150724AC and MOPAR R5150724AC.

This table covers the capacitors that suppress radio noise. Read more

One part is listed for the 2013 Chrysler 200 — STANDARD MOTOR PRODUCTS RC33.

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

19 Speed Sensor parts are listed for the 2013 Chrysler 200, from ATP, GPD, HOLSTEIN and 7 other brands. ATP TE8 carries the "Popular" badge.

In the Economy grade, ATP, GPD and HOLSTEIN supply 6 parts: the catalog's value-priced group. A representative part number is ATP TE8.

In the Full Service Kit grade, WALKER PRODUCTS supplies 1 part: grouped under the catalog's "Full Service Kit" designation — the notes column spells out what sets them apart. A representative part number is WALKER PRODUCTS 24091147.

The Standard Replacement section: 12 options from MOPAR, NTK, DELPHI and 4 other brands. MOPAR 5078930AA is listed in this group.

This table covers the Starter armatures. Read more

This group shows a single part: BOSCH 1986SE0331.

This table covers the Starter Brush Holder assemblies. Read more

One part is listed for the 2013 Chrysler 200 — BOSCH 1986SE0274.

This table covers the starter motors that crank the engine. Typical signs include no motion, a squeal, or a motor that only runs on one speed. Confirm power, ground and the control module before replacing the motor. Read more

13 Starter Motor parts for the 2013 Chrysler 200 come from 9 brands — PURE ENERGY, MOPAR, TERREPOWER and 6 other brands. The "Popular" part is PURE ENERGY 19616N.

The New section: 5 options from PURE ENERGY, TYC, MOPAR and 2 other brands. PURE ENERGY 19616N is listed in this group.

The Remanufactured section: 8 options from PURE ENERGY, ACDELCO, BOSCH and 5 other brands. PURE ENERGY 19616 is listed in this group.

This table covers the Starter solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

This group shows a single part: BOSCH 1986SE0300.

This table covers the Yaw sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

One part is listed for the 2013 Chrysler 200 — MOPAR 56038983AA.