2012 Chrysler 200 Electrical Parts

This table covers the alternators that charge the battery and run the electrical load. Typical signs include dim lights at idle, a battery lamp, or a growl from the charging pulley. Load-test the battery and inspect the belt and grounds — a bad ground mimics a failed alternator. Read more

41 Alternator / Generator parts are listed for the 2012 Chrysler 200, from WAI GLOBAL, FVP, PURE ENERGY and 7 other brands. FVP 11580N carries the "Popular" badge. New and Remanufactured are all represented, and Remanufactured alone accounts for 25 parts.

This table covers the pulleys on the alternator shaft. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt. Read more

7 Alternator / Generator Pulley parts for the 2012 Chrysler 200 come from 5 brands — CONTINENTAL, LITENS, AUTOTECNICA and 2 other brands.

Listed part numbers: AUTOTECNICA CY1416794, CONTINENTAL 49915 and CONTINENTAL 49937, plus the other parts above.

This table covers the Alternator / Generator stators. Read more

This group shows a single part: BOSCH 1986AE0679.

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery. Read more

2 Battery parts for the 2012 Chrysler 200 come from 2 brands — BOSCH and FULLRIVER. Every part fits both the 2.4L L4 and the 3.6L V6.

In the AGM (Extended Life) grade, BOSCH supplies 1 part: grouped under the catalog's "AGM (Extended Life)" designation — the notes column spells out what sets them apart. A representative part number is BOSCH S675DT.

In the Performance AGM (Extended Life + Increased Power) grade, FULLRIVER supplies 1 part: grouped under the catalog's "Performance AGM (Extended Life + Increased Power)" designation — the notes column spells out what sets them apart. A representative part number is FULLRIVER FT82534.

This group includes BOSCH S675DT and FULLRIVER FT82534.

This table covers the positive and ground cables that run from the battery. Typical signs include a stretched or frayed cable, or a control that no longer reaches the end of its travel. Route the new cable through the same clips. A kinked cable binds and fails early. Read more

4 Battery Cable parts are listed for the 2012 Chrysler 200, from MOPAR and STANDARD MOTOR PRODUCTS. All of them fit every engine offered in the 2012 200.

Part numbers include MOPAR 4795599AJ, MOPAR 4672334AA and STANDARD MOTOR PRODUCTS A304T, among others listed above.

This table covers the clamps and brackets that secure the battery. Read more

5 Battery Hold Down parts are listed for the 2012 Chrysler 200, from DORMAN and SKP. DORMAN 00083 carries the "Popular" badge. All of them fit every engine offered in the 2012 200.

This group includes DORMAN 00083, DORMAN 00082 and DORMAN 00081 and the remaining parts above.

This table covers the terminals and clamps that connect cables to the battery posts. Read more

This group shows a single part: MOPAR 68358319AA.

This table covers the covers that protect battery terminals. Read more

This group shows a single part: MOPAR 68358318AA.

This table covers the trays the battery sits in. Read more

2 Battery Tray parts for the 2012 Chrysler 200 come from 2 brands — DORMAN and MOPAR. Every part fits both the 2.4L L4 and the 3.6L V6.

Listed part numbers: DORMAN 00071 and MOPAR 5155731AA.

This table covers the Door control modules. Read more

2 Door Control Module parts for the 2012 Chrysler 200 come from MOPAR. Every part fits both the 2.4L L4 and the 3.6L V6.

Part numbers include MOPAR 4602922AF and MOPAR 68051931AB.

This table covers the replacement fuses for this vehicle's fuse boxes. Typical signs include one circuit dead while its neighbor still works, or a fuse that blows again as soon as you replace it. Match amperage and fuse type. A repeat blow means a short — find it before the next fuse. Read more

18 Fuse parts for the 2012 Chrysler 200 come from 2 brands — BUSSMANN and MOPAR. The "Popular" part is BUSSMANN ATM10. Every part fits both the 2.4L L4 and the 3.6L V6.

In the 10 Amp grade, BUSSMANN and MOPAR supply 3 parts: grouped under the catalog's "10 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM10.

The 15 Amp section lists 3 options from BUSSMANN and MOPAR — grouped under the catalog's "15 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM15 is listed in this group.

The 20 Amp section lists 3 options from BUSSMANN and MOPAR — grouped under the catalog's "20 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM20 is listed in this group.

In the 25 Amp grade, BUSSMANN and MOPAR supply 3 parts: grouped under the catalog's "25 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM25.

In the 30 Amp grade, BUSSMANN supplies 4 parts: grouped under the catalog's "30 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM30.

The 40 Amp section lists 2 options from BUSSMANN — grouped under the catalog's "40 Amp" designation — the notes column spells out what sets them apart. BUSSMANN FMX40 is listed in this group.

This table covers the Fuse Box covers. Read more

2 Fuse Box Cover parts for the 2012 Chrysler 200 come from MOPAR. 1 part fits every engine; the other 1 is engine-specific.

Part numbers include MOPAR 68197366AA and MOPAR 68224787AA.

This table covers the horns mounted in the front of the vehicle. Read more

15 Horn parts for the 2012 Chrysler 200 come from 2 brands — FIAMM and MOPAR. The "Popular" part is FIAMM 7210223. Every part fits both the 2.4L L4 and the 3.6L V6.

The Accessory Replacement section lists 7 options from FIAMM — grouped under the catalog's "Accessory Replacement" designation — the notes column spells out what sets them apart. FIAMM 7210223 is listed in this group.

In the Standard Replacement grade, FIAMM and MOPAR supply 8 parts: built to original-equipment specification. A representative part number is FIAMM 7201223.

This table covers the receivers that pick up the key-fob unlock signal. Read more

One part is listed for the 2012 Chrysler 200 — MOPAR 5026165AS.

This table covers the key fobs that lock, unlock and start the vehicle. Read more

DORMAN supplies the 3 Keyless Entry Remote parts for the 2012 Chrysler 200. All of them fit every engine offered in the 2012 200.

Part numbers include DORMAN 99173, DORMAN 99173ST and DORMAN 99269ST.

This table covers the Mobile Phone Hands Free control modules. Read more

This group shows a single part: MOPAR 82212499.

This table covers the totally-integrated power modules that distribute body electrical power. Typical signs include a cluster of unrelated faults, a no-communication code, or a module that will not sleep. Confirm power, ground and programming compatibility in the notes. Modules are rarely plug-and-play across years. Read more

2 Power Supply Module (TIPM) parts for the 2012 Chrysler 200 come from 2 brands — DORMAN and MOPAR. Every part fits both the 2.4L L4 and the 3.6L V6.

Part numbers include DORMAN 598711 and MOPAR R4692346AE.

This table covers the powertrain-control modules that run engine and transmission. Read more

7 Powertrain Control Module (PCM) parts for the 2012 Chrysler 200 come from MOPAR.

Part numbers include MOPAR 5150652AA, MOPAR 5150655AA and MOPAR R5150542AE, among others listed above.

This table covers the capacitors that suppress radio noise. Read more

This group shows a single part: STANDARD MOTOR PRODUCTS RC33.

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

45 Speed Sensor parts for the 2012 Chrysler 200 come from 15 brands — WALKER PRODUCTS, GPD, HOLSTEIN and 12 other brands. The "Popular" part is ATP TE8. Grades run from Economy through Standard Replacement; Standard Replacement is the most populated section, led by NTK, DELPHI, WELLS and 5 other brands.

This table covers the Starter armatures. Read more

One part is listed for the 2012 Chrysler 200 — BOSCH 1986SE0331.

This table covers the Starter Brush Holder assemblies. Read more

This group shows a single part: BOSCH 1986SE0274.

This table covers the starter motors that crank the engine. Typical signs include no motion, a squeal, or a motor that only runs on one speed. Confirm power, ground and the control module before replacing the motor. Read more

27 Starter Motor parts are listed for the 2012 Chrysler 200, from TERREPOWER, PURE ENERGY, REMY and 6 other brands. PURE ENERGY 19616N carries the "Popular" badge. Grades run from New through Remanufactured; Remanufactured is the most populated section, led by PURE ENERGY, REMY, TERREPOWER and 5 other brands.

This table covers the Starter solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

One part is listed for the 2012 Chrysler 200 — BOSCH 1986SE0300.

This table covers the Yaw sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: MOPAR 56038983AA.