1992 Eagle Vista Engine Parts

This table covers the Camshaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 1992 Eagle Vista — DURA-BOND MIA3.

This table covers the wear sleeves used to restore a Camshaft seal surface. Read more

4 Camshaft Repair Sleeve parts for the 1992 Eagle Vista come from 4 brands — BCA, NATIONAL, SKF and 1 other brand.

This group includes BCA NS99139 and NATIONAL 99139 and the remaining parts above.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

7 Camshaft Seal parts for the 1992 Eagle Vista come from 7 brands — FEL-PRO, NATIONAL, AJUSA and 4 other brands. The "Popular" part is FEL-PRO TCS45483.

This group includes FEL-PRO TCS45483, NATIONAL 3771 and AJUSA 15013300 and the remaining parts above.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

3 Conversion / Lower Gasket Set parts are listed for the 1992 Eagle Vista, from AJUSA, FEL-PRO and VICTOR REINZ.

Part numbers include AJUSA 54041100, FEL-PRO CS87671 and VICTOR REINZ 081252201.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: SEALED POWER 6630M.

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

5 Crankshaft Repair Sleeve parts for the 1992 Eagle Vista come from 5 brands — NATIONAL, FEL-PRO, MAHLE / CLEVITE and 2 other brands. The "Popular" part is NATIONAL 99114.

Listed part numbers: NATIONAL 99114, FEL-PRO 16275 and MAHLE / CLEVITE A354, plus the other parts above.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Crankshaft Seal parts for the 1992 Eagle Vista come from 5 brands — FEL-PRO, NATIONAL, BCA and 2 other brands. The "Popular" part is FEL-PRO BS400971.

This group includes FEL-PRO BS400971, NATIONAL 223018 and BCA NS223018 and the remaining parts above.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts are listed for the 1992 Eagle Vista, from FEL-PRO and VICTOR REINZ.

Part numbers include FEL-PRO 9758PT and VICTOR REINZ 611059300.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

3 Cylinder Head Gasket Set parts are listed for the 1992 Eagle Vista, from FEL-PRO and VICTOR REINZ.

Part numbers include FEL-PRO HIS9758PT, FEL-PRO HS9758PT and VICTOR REINZ 021030701.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 1992 Eagle Vista — AJUSA 50121000.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

2 Exhaust Valve parts for the 1992 Eagle Vista come from 2 brands — QUALCAST and SBI.

This group includes QUALCAST 1010497 and SBI 10497.

This table covers the Expansion plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

One part is listed for the 1992 Eagle Vista — PIONEER EPC224.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

3 Harmonic Balancer parts are listed for the 1992 Eagle Vista, from ATP, DORMAN and PIONEER.

Listed part numbers: ATP 102304, DORMAN 594876 and PIONEER DA152.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Intake Manifold Gasket parts are listed for the 1992 Eagle Vista, from AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand.

This group includes AJUSA 13088500, FEL-PRO MS94789 and MAHLE / CLEVITE MS15983 and the remaining parts above.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

2 Intake Valve parts for the 1992 Eagle Vista come from SBI.

Listed part numbers: SBI 10496 and SBI 10495.

This table covers the Oil Cooler Mounting kits. Read more

HAYDEN supplies both parts for the 1992 Eagle Vista.

This group includes HAYDEN 238 and HAYDEN 153.

This table covers the drain plugs in the oil pan. Read more

5 Oil Drain Plug parts for the 1992 Eagle Vista come from 3 brands — DORMAN, AGS and SKP. The "Popular" part is DORMAN 090053.

Listed part numbers: DORMAN 090053, AGS ODP00007 and DORMAN 090075, plus the other parts above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 1992 Eagle Vista — AJUSA 18001000.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

14 Oil Filter parts for the 1992 Eagle Vista come from 11 brands — VARIOUS MFR, BOSCH, WIX and 8 other brands. The "Popular" part is VARIOUS MFR PG4612.

The Economy section lists 4 options from VARIOUS MFR, BOSCH, FVP and 1 other brand — the catalog's value-priced group. VARIOUS MFR PG4612 is listed in this group.

The High Performance / Heavy Duty section lists 2 options from MOBIL and WIX — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. MOBIL M1110A is listed in this group.

In the Standard Replacement grade, BOSCH, HASTINGS / BALDWIN, HENGST and 5 other brands supply 8 parts: built to original-equipment specification. A representative part number is BOSCH 3312.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Pan Gasket parts for the 1992 Eagle Vista come from 3 brands — AJUSA, FEL-PRO and VICTOR REINZ.

Listed part numbers: AJUSA 14027300, FEL-PRO OS30414C and VICTOR REINZ 715222300.

This table covers the rings that seal each piston to the cylinder wall. Read more

One part is listed for the 1992 Eagle Vista — SEALED POWER E619KC.

This table covers the Timing belts. Typical signs include squeal on cold start, cracked ribs, or glazing. Spin the tensioner and idlers by hand while the belt is off. Read more

3 Timing Belt parts are listed for the 1992 Eagle Vista, from ACDELCO, DAYCO and GATES.

This group includes ACDELCO TB191, DAYCO 95128 and GATES T191.

This table covers the Timing Belt & component kits. Read more

3 Timing Belt & Component Kit parts for the 1992 Eagle Vista come from 3 brands — ACDELCO, GATES and GMB.

Listed part numbers: ACDELCO TCK191 and GMB 24480191, plus the other parts above.

This table covers the Timing Belt tensioners. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

2 Timing Belt Tensioner parts for the 1992 Eagle Vista come from 2 brands — ACDELCO and GMB.

Part numbers include ACDELCO T41051 and GMB 4488090.

This table covers the wear sleeves used to restore a Timing Cover seal surface. Read more

This group shows a single part: SKF 99114.

This table covers the seals at the Timing Cover. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: SKF 11671.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Valve Cover Gasket parts for the 1992 Eagle Vista come from 4 brands — AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand.

This group includes AJUSA 11048200, FEL-PRO VS50382R and MAHLE / CLEVITE VS50151 and the remaining parts above.

This table covers the pressed-in bronze and cast-iron guides that align valve stems. Typical signs include oil smoke on startup, a guide that has gone oval, or a valve that no longer seats quietly. Guides are a machine-shop fit. Confirm stem diameter in the notes before ordering. Read more

2 Valve Guide parts for the 1992 Eagle Vista come from 2 brands — QUALCAST and SBI.

Part numbers include QUALCAST 307578 and SBI 1407589.

This table covers the Valve seats. Read more

5 Valve Seat parts are listed for the 1992 Eagle Vista, from SBI, QUALCAST and DURA-BOND. QUALCAST 21112552 carries the "Popular" badge.

Listed part numbers: QUALCAST 21112552, DURA-BOND 31048 and SBI SB112552, plus the other parts above.

This table covers the keepers that lock each valve-spring retainer to the stem. Read more

2 Valve Spring Retainer Keeper parts are listed for the 1992 Eagle Vista, from PIONEER and SBI.

Part numbers include PIONEER PF234 and SBI 1211031.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Valve Stem Seal parts for the 1992 Eagle Vista come from 5 brands — AJUSA, FEL-PRO, SBI and 2 other brands. The "Popular" part is FEL-PRO SS72805.

This group includes FEL-PRO SS72805, SBI 1221114 and AJUSA 12015100 and the remaining parts above.