2008 Fiat Panda Engine Parts

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Camshaft Seal parts for the 2008 Fiat Panda come from 2 brands — ELRING and AJUSA.

Part numbers include AJUSA 15063900, ELRING 505838 and ELRING 688580.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Conversion / Lower Gasket Set parts are listed for the 2008 Fiat Panda, from AJUSA and ELRING.

Part numbers include AJUSA 54152400 and ELRING 431560.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Crankshaft Seal parts for the 2008 Fiat Panda come from 2 brands — ELRING and AJUSA. The "Popular" part is ELRING 069540.

This group includes ELRING 069540, AJUSA 15066800 and AJUSA 15081900 and the remaining parts above.

This table covers the bolts that clamp the cylinder head to the block. Read more

2 Cylinder Head Bolt parts are listed for the 2008 Fiat Panda, from AJUSA and ELRING.

Listed part numbers: AJUSA 81007600 and ELRING 760720.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts are listed for the 2008 Fiat Panda, from AJUSA and ELRING.

Part numbers include AJUSA 10175600 and ELRING 040554.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

4 Cylinder Head Gasket Set parts are listed for the 2008 Fiat Panda, from ELRING and AJUSA.

Part numbers include AJUSA 52255600, ELRING 505730 and ELRING 431470, among others listed above.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2008 Fiat Panda — AJUSA 50274200.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2008 Fiat Panda — AJUSA 24032600.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING 728670.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

2 Motor Mount parts for the 2008 Fiat Panda come from 2 brands — ANCHOR and DEA / MARMON RIDE CONTROL.

Part numbers include ANCHOR 9893 and DEA / MARMON RIDE CONTROL A5639.

This table covers the drain plugs in the oil pan. Read more

This group shows a single part: ELRING 587100.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

4 Oil Filter parts for the 2008 Fiat Panda come from 4 brands — MOBIL, MAHLE / CLEVITE, MANN and 1 other brand.

The High Performance / Heavy Duty section lists 1 option from MOBIL — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. MOBIL M1110A is listed in this group.

In the Standard Replacement grade, MAHLE / CLEVITE, MANN and WIX supply 3 parts: built to original-equipment specification. A representative part number is MAHLE / CLEVITE OC272.

This group includes MOBIL M1110A, MAHLE / CLEVITE OC272 and MANN W6103 and the remaining parts above.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING 030793.

This table covers the gaskets that seal the Oil Pump. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2008 Fiat Panda — ELRING 435550.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Valve Cover Gasket parts for the 2008 Fiat Panda come from 2 brands — ELRING and AJUSA.

This group includes AJUSA 56060900, ELRING 399570 and ELRING 505060 and the remaining parts above.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Valve Stem Seal parts for the 2008 Fiat Panda come from 2 brands — ELRING and AJUSA. The "Popular" part is ELRING 701289.

This group includes ELRING 701289, ELRING 825042 and AJUSA 12012700 and the remaining parts above.