2008 Fiat Strada Engine Parts

Engine:
1.8L L4

8 Engine parts are listed for the 2008 Fiat Strada, in 5 part types, covering the 1.8L L4 engine. Each one has a brand, a manufacturer part number and notes that say where it fits.

On the 2008 Fiat Strada, the engine covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components. 6 parts of the 8 listed are Camshaft Seal (2 parts), Crankshaft Seal (2 parts) and Cylinder Head Bolt (2 parts). The other 2 part types cover the remaining 2 parts.

Camshaft Seal

Brand Part Number Markets Notes Buy
AJUSA 15012600
🇲🇽 MX
35 X 48 X 7Clockwise
Fitment notes — AJUSA 15012600
35 X 48 X 7ClockwiseEngine # OHC
View on
Amazon
ELRING 702269
🇲🇽 MX
Inner Diameter [MM]: 35Radial Shaft Seal Design: AwithBS
Fitment notes — ELRING 702269
Inner Diameter [MM]: 35Radial Shaft Seal Design: AwithBSSwirl Type: Right-hand Twist
View on
Amazon

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.

Conversion / Lower Gasket Set

Brand Part Number Markets Notes Buy
AJUSA 54077800
🇲🇽 MX
Engine # OHC
View on
Amazon

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration.

Crankshaft Seal

Brand Part Number Markets Notes Buy
AJUSA 15035700
🇲🇽 MX
RearCounter Clockwise
Fitment notes — AJUSA 15035700
RearCounter ClockwiseEngine # OHC
View on
Amazon
AJUSA 15008300
🇲🇽 MX
FrontClockwise or Counter Clockwise
Fitment notes — AJUSA 15008300
FrontClockwise or Counter ClockwiseEngine # OHC
View on
Amazon

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.

Cylinder Head Bolt

Brand Part Number Markets Notes Buy
AJUSA 81004800
🇲🇽 MX
Engine # OHC
View on
Amazon
ELRING 820262
🇲🇽 MX
SetBolt Head-/Nut Design: Male Torx
Fitment notes — ELRING 820262
SetBolt Head-/Nut Design: Male TorxThread Size: M10X1,25x140
View on
Amazon

This table covers the bolts that clamp the cylinder head to the block.

Cylinder Head Gasket

Brand Part Number Markets Notes Buy
AJUSA 10158300
🇲🇽 MX
Multi Layered Steel
Fitment notes — AJUSA 10158300
Multi Layered Steel
82 Bore DiameterEngine # OHC
View on
Amazon

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.

Buying Engine Parts for a 2008 Fiat Strada

On this vehicle, the engine covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components.

  • Confirm you have the 1.8L L4 engine — every part on this page is matched to it.
  • Read the notes on each row for position, trim and spec qualifiers before you order.
  • Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.
  • Cross-reference the manufacturer part number against your old part or a service-manual listing.

Start with the largest groups on this page: Camshaft Seal and Crankshaft Seal .

Frequently Asked Questions

How many engine parts fit the 2008 Fiat Strada?

Our catalog currently lists 8 engine parts for the 2008 Fiat Strada across 5 subcategories and 2 brands, covering the 1.8L L4 engine. Each part is matched to the engine(s) it fits.

What are the signs of engine problems on a 2008 Fiat Strada?

Common symptoms include oil spots under the vehicle, blue or white exhaust smoke, ticking from the valvetrain, or coolant mysteriously disappearing. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.

What should I replace at the same time?

Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.

What do the market flags (US, CA, MX) on each part mean?

They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2008 Fiat Strada was originally sold in the US, the safest choice is a part marked for the US market.

How do I make sure a part fits my 2008 Fiat Strada?

Every part on this page is matched to the 1.8L L4 engine. Then engine hard parts are unforgiving of guesswork — confirm the casting or engine code before ordering, because one model year can hide two different blocks. The notes column carries position and trim qualifiers where they apply.

Other Parts for the 2008 Fiat Strada

Engine Parts for Other Fiat Strada Years

Switch vehicle or jump to a subcategory

Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.