2018 Hyundai Creta Cooling System Parts

This table covers the engine coolants and antifreeze formulations specified for this cooling system. Typical signs include a rising temperature gauge, rusty or sludged coolant, or a heater that blows cold. Use the chemistry named in the notes. Mixing silicate, OAT and HOAT formulas can gel in the radiator. Read more

14 Coolant / Antifreeze parts for the 2018 Hyundai Creta come from 5 brands — PRESTONE, PEAK, VALVOLINE and 2 other brands. The "Popular" part is FVP MV5050GAL.

In the Compatible With All Colors grade, PRESTONE supplies 1 part: grouped under the catalog's "Compatible With All Colors" designation — the notes column spells out what sets them apart. A representative part number is PRESTONE AF3055.

The Economy section lists 3 options from FVP, PEAK and PRESTONE — the catalog's value-priced group. FVP MV5050GAL is listed in this group.

In the Heavy Duty grade, PRESTONE and VALVOLINE supply 2 parts: rated for severe service. A representative part number is PRESTONE AFC12100.

In the Premium grade, PRESTONE and PEAK supply 5 parts: a step above OE specification in materials, tolerances or warranty terms. A representative part number is PRESTONE AF2100.

In the Standard Replacement grade, VALVOLINE, AISIN and PEAK supply 3 parts: built to original-equipment specification. A representative part number is VALVOLINE 861398.

This table covers the radiators that dump engine heat to airflow through the core. Typical signs include overheating in traffic, a wet core, or coolant that disappears with no puddle. Replace the cap if it cannot hold the rated pressure, and bleed the system after the swap. Read more

3 Radiator parts for the 2018 Hyundai Creta come from 3 brands — AGILITY, NISSENS and SPECTRA PREMIUM.

Part numbers include AGILITY 8013412, NISSENS 606476 and SPECTRA PREMIUM CU13412.

This table covers the caps that hold system pressure at the radiator or reservoir neck. Typical signs include a leak at the neck, a cap that will not hold pressure, or a missing tether. Match the pressure rating or thread in the notes — radiator, reservoir and fuel caps are not interchangeable. Read more

This group shows a single part: GATES 31336.

This table covers the senders that report coolant temperature to the gauge or ECU. Typical signs include a gauge that sits on empty or overheat, or a lamp that does not match what the engine is doing. Rule out the cluster and the wiring before replacing the sender. Read more

2 Temperature Sender / Sensor parts for the 2018 Hyundai Creta come from STANDARD MOTOR PRODUCTS.

The Economy section: 1 option from STANDARD MOTOR PRODUCTS. STANDARD MOTOR PRODUCTS TX122T is listed in this group.

Standard Replacement: 1 part, from STANDARD MOTOR PRODUCTS. A representative part number is STANDARD MOTOR PRODUCTS TX122.

Part numbers include STANDARD MOTOR PRODUCTS TX122T and STANDARD MOTOR PRODUCTS TX122.

This table covers the thermostats that open the coolant circuit at the specified temperature. Typical signs include slow warm-up, a gauge that climbs in traffic, or heat that never quite arrives. Replace the housing gasket with the thermostat and bleed the system so a trapped air pocket does not cook the new part. Read more

2 Thermostat parts are listed for the 2018 Hyundai Creta, from GATES and MOTORAD.

Part numbers include GATES 34802 and MOTORAD 726180.

This table covers the seals at the thermostat housing and water outlet. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: ELRING 326310.

This table covers the housings and outlets the thermostat sits in. Read more

One part is listed for the 2018 Hyundai Creta — DORMAN 9025196.

This table covers the pumps that circulate coolant through the block and radiator. Typical signs include coolant at the weep hole, pulley play, or a growl from the front of the engine. Replace the thermostat and refill with the specified coolant whenever the pump comes off. Read more

3 Water Pump parts are listed for the 2018 Hyundai Creta, from FVP, US MOTOR WORKS and GATES.

Economy: 2 parts, from FVP and US MOTOR WORKS. A representative part number is FVP US6247.

The Standard Replacement section: 1 option from GATES. GATES 41100 is listed in this group.

This group includes FVP US6247 and GATES 41100 and the remaining parts above.

This table covers the gaskets between the water pump and the block or housing. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: ELRING 316180.