2010 International Transtar Engine Parts

This table covers the Camshaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 2010 International Transtar — DURA-BOND IN24.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

5 Oil parts for the 2010 International Transtar come from VALVOLINE.

The Full Synthetic section lists 1 option from VALVOLINE — full-synthetic oils. VALVOLINE 909772 is listed in this group.

The Heavy Duty / Diesel section lists 1 option from VALVOLINE — grouped under the catalog's "Heavy Duty / Diesel" designation — the notes column spells out what sets them apart. VALVOLINE 909778 is listed in this group.

The Synthetic Blend section lists 3 options from VALVOLINE — synthetic-blend oils. VALVOLINE 909766 is listed in this group.

Listed part numbers: VALVOLINE 909772, VALVOLINE 909778 and VALVOLINE 909766, plus the other parts above.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

16 Oil Filter parts for the 2010 International Transtar come from 4 brands — WIX, HASTINGS / BALDWIN, MANN and 1 other brand. The "Popular" part is WIX 57744XD.

The High Performance / Heavy Duty section lists 3 options from WIX — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. WIX 57744XD is listed in this group.

In the Standard Replacement grade, WIX, HASTINGS / BALDWIN and MANN supply 6 parts: built to original-equipment specification. A representative part number is HASTINGS / BALDWIN BD50000.

7 further parts sit outside the graded sections, with the same engine-level match.

This table covers the Oil Filter covers. Read more

One part is listed for the 2010 International Transtar — MOTORAD MO357.

This table covers the oil pans that hold the engine's oil sump. Read more

6 Oil Pan parts are listed for the 2010 International Transtar, from DORMAN, SPECTRA PREMIUM and SKP.

This group includes DORMAN 2645054, DORMAN 2645006 and DORMAN 2645104 and the remaining parts above.

This table covers the Oil Temperature senders. Read more

2 Oil Temperature Sender parts are listed for the 2010 International Transtar, from DORMAN and HOLSTEIN.

This group includes DORMAN 9047549 and HOLSTEIN 2OTS0002.

This table covers the turbochargers that compress intake air. Read more

4 Turbocharger parts for the 2010 International Transtar come from 2 brands — GPD and ROTOMASTER.

This group includes GPD 2511538, GPD 2511890 and GPD 2511990 and the remaining parts above.

This table covers the Turbocharger Boost sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

One part is listed for the 2010 International Transtar — DORMAN 9047130.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Turbocharger Gasket parts are listed for the 2010 International Transtar, from DORMAN and GPD.

Part numbers include DORMAN 6749024 and GPD 2535040.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: DORMAN 2645124.

This table covers the springs that close each intake and exhaust valve. Typical signs include a sagging corner, a broken coil, or a clunk from the spring pocket. Replace springs in axle pairs and inspect the seats. Read more

MELLING supplies both parts for the 2010 International Transtar.

Listed part numbers: MELLING VS1462 and MELLING VS1463.