1962 MG Magnette Engine Parts

This table covers the Camshaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: DURA-BOND DA2.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Conversion / Lower Gasket Set parts for the 1962 MG Magnette come from AJUSA.

Listed part numbers: AJUSA 54032100 and AJUSA 54031800.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 1962 MG Magnette.

Listed part numbers: AJUSA 15015900 and AJUSA 15038800.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts for the 1962 MG Magnette come from AJUSA.

This group includes AJUSA 10034600 and AJUSA 10023200.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Cylinder Head Gasket Set parts for the 1962 MG Magnette come from AJUSA.

Listed part numbers: AJUSA 52055900 and AJUSA 52055600.

This table covers the wear sleeves used to restore a Cylinder seal surface. Read more

4 Cylinder Repair Sleeve parts for the 1962 MG Magnette come from MELLING.

Part numbers include MELLING CSL720, MELLING CSL620 and MELLING CSL250, among others listed above.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Engine Kit Gasket Set parts for the 1962 MG Magnette come from AJUSA.

Listed part numbers: AJUSA 50063300 and AJUSA 50062900.

This table covers the Intake & Exhaust Manifold gasket sets. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

5 Intake & Exhaust Manifold Gasket Set parts for the 1962 MG Magnette come from 4 brands — AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand. 3 parts fit every engine; the other 2 are engine-specific.

This group includes AJUSA 13050800, AJUSA 13017700 and FEL-PRO MS22506B and the remaining parts above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 18000900.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

One part is listed for the 1962 MG Magnette — FAMOUS BRAND 85300.

This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

AJUSA supplies both parts for the 1962 MG Magnette.

Listed part numbers: AJUSA 59007000 and AJUSA 14041100.

This table covers the Timing Belt pulleys. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt. Read more

BECK/ARNLEY supplies both parts for the 1962 MG Magnette. All of them fit every engine offered in the 1962 Magnette.

Part numbers include BECK/ARNLEY 0513860 and BECK/ARNLEY 0513954.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

6 Valve Cover Gasket parts are listed for the 1962 MG Magnette, from AJUSA, FEL-PRO, BECK/ARNLEY and 2 other brands. FEL-PRO VS215091 carries the "Popular" badge. 3 parts fit every engine; the other 3 are engine-specific.

Listed part numbers: FEL-PRO VS215091, AJUSA 11027700 and AJUSA 11016000, plus the other parts above.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies the 4 Valve Stem Seal parts for the 1962 MG Magnette.

This group includes AJUSA 12006300, AJUSA 57014400 and AJUSA 16001000 and the remaining parts above.