24 Engine parts are listed for the 1965 MG Magnette, in 13 part types, covering the 1.6L L4 engine. Each one has a brand, a manufacturer part number and notes that say where it fits.
On the 1965 MG Magnette, the engine covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components. Most of the listed parts are Valve Cover Gasket (5 parts), Intake & Exhaust Manifold Gasket Set (4 parts) and Crankshaft Seal (2 parts). The other 10 part types cover the remaining 13 parts.
The 1965 MG Magnette came with a single engine, the 1.6L L4, and every part is verified against it.
7 brands supply engine parts for the 1965 MG Magnette, led by AJUSA (12 parts), BECK/ARNLEY (3 parts) and MELLING (2 parts), plus 4 more brands.
A "Popular" badge means the source catalog flagged the part as frequently chosen for the 1965 MG Magnette. 1 part has it: FEL-PRO VS215091 (Valve Cover Gasket). Each part number opens a page with every vehicle that part fits.
Camshaft Bearing
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| DURA-BOND | DA2 | 🇺🇸 US | Standard | View on Amazon |
This table covers the Camshaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly.
One part is listed for the 1965 MG Magnette — DURA-BOND DA2.
Conversion / Lower Gasket Set
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 54031800 | 🇺🇸 US | Engine # 16AA,16GF | View on Amazon |
This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration.
One part is listed for the 1965 MG Magnette — AJUSA 54031800.
Crankshaft Seal
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 15015900 | 🇺🇸 US | Front38 x 58.9 x 8.3/9.5 | View on Amazon |
| AJUSA | 15038800 | 🇺🇸 US | Rear88.9 x 104.7 x 9.5 | View on Amazon |
This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.
2 Crankshaft Seal parts for the 1965 MG Magnette come from AJUSA.
This group includes AJUSA 15015900 and AJUSA 15038800.
Cylinder Head Gasket
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 10023200 | 🇺🇸 US | 82.5 Bore DiameterEngine # 16AA,16GF | View on Amazon |
This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.
One part is listed for the 1965 MG Magnette — AJUSA 10023200.
Cylinder Head Gasket Set
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 52055600 | 🇺🇸 US | Engine # 16AA,16GF | View on Amazon |
This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration.
One part is listed for the 1965 MG Magnette — AJUSA 52055600.
Cylinder Repair Sleeve
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| MELLING | CSL250 | 🇺🇸 US | 1/8 IN Wall Thickness | View on Amazon |
| MELLING | CSL150 | 🇺🇸 US | 3/32 IN Wall Thickness | View on Amazon |
This table covers the wear sleeves used to restore a Cylinder seal surface.
MELLING supplies both parts for the 1965 MG Magnette.
Listed part numbers: MELLING CSL250 and MELLING CSL150.
Engine Kit Gasket Set
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 50062900 | 🇺🇸 US | Engine # 16AA,16GF | View on Amazon |
This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration.
One part is listed for the 1965 MG Magnette — AJUSA 50062900.
Intake & Exhaust Manifold Gasket Set
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 13017700 | 🇺🇸 US | Engine # 16AA,16GF | View on Amazon |
| FEL-PRO | MS22506B | 🇺🇸 US | View on Amazon | |
| MAHLE / CLEVITE | MS15234 | 🇺🇸 US | Composite | View on Amazon |
| VICTOR REINZ | 111076901 | 🇺🇸 US | View on Amazon |
This table covers the Intake & Exhaust Manifold gasket sets. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration.
4 Intake & Exhaust Manifold Gasket Set parts are listed for the 1965 MG Magnette, from AJUSA, FEL-PRO, MAHLE / CLEVITE and 1 other brand.
Listed part numbers: AJUSA 13017700, FEL-PRO MS22506B and MAHLE / CLEVITE MS15234, plus the other parts above.
Oil Drain Plug Gasket
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 18000900 | 🇺🇸 US | Engine # 16AA,16GFwith Original Equipment (OE) # 11026-01N02 | View on Amazon |
This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.
One part is listed for the 1965 MG Magnette — AJUSA 18000900.
Oil Pan Gasket
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 14041100 | 🇺🇸 US | Engine # 16AA,16GF | View on Amazon |
This table covers the gaskets between the oil pan and the block. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.
This group shows a single part: AJUSA 14041100.
Timing Belt Pulley
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| BECK/ARNLEY | 0513860 | 🇺🇸 US | Bearing Only | View on Amazon |
| BECK/ARNLEY | 0513954 | 🇺🇸 US | Bearing Only | View on Amazon |
This table covers the Timing Belt pulleys. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt.
2 Timing Belt Pulley parts for the 1965 MG Magnette come from BECK/ARNLEY.
Part numbers include BECK/ARNLEY 0513860 and BECK/ARNLEY 0513954.
Valve Cover Gasket
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| FEL-PRO Popular | VS215091 | 🇺🇸 US | View on Amazon | |
| AJUSA | 11016000 | 🇺🇸 US | Engine # 16AA,16GF | View on Amazon |
| BECK/ARNLEY | 0360081 | 🇺🇸 US | View on Amazon | |
| MAHLE / CLEVITE | VS30026 | 🇺🇸 US | Cork-Rubber | View on Amazon |
| VICTOR REINZ | 151079001 | 🇺🇸 US | Set | View on Amazon |
This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for.
5 Valve Cover Gasket parts for the 1965 MG Magnette come from 5 brands — FEL-PRO, AJUSA, BECK/ARNLEY and 2 other brands. The "Popular" part is FEL-PRO VS215091.
Listed part numbers: FEL-PRO VS215091, AJUSA 11016000 and BECK/ARNLEY 0360081, plus the other parts above.
Valve Stem Seal
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| AJUSA | 16001000 | 🇺🇸 US | Engine # 16AA,16GFSize- 4 x 3 | View on Amazon |
| AJUSA | 57001100 | 🇺🇸 US | Engine # 16AA,16GF | View on Amazon |
This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again.
2 Valve Stem Seal parts for the 1965 MG Magnette come from AJUSA.
Listed part numbers: AJUSA 16001000 and AJUSA 57001100.
Buying Engine Parts for a 1965 MG Magnette
On this vehicle, the engine covers the internals and hard parts that build compression and keep oil where it belongs — gaskets, bearings, camshafts, lifters, seals and timing components.
- Confirm you have the 1.6L L4 engine — every part on this page is matched to it.
- Read the notes on each row for position, trim and spec qualifiers before you order.
- Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.
- Cross-reference the manufacturer part number against your old part or a service-manual listing.
Start with the largest groups on this page: Valve Cover Gasket and Intake & Exhaust Manifold Gasket Set .
Frequently Asked Questions
How many engine parts fit the 1965 MG Magnette?
Our catalog currently lists 24 engine parts for the 1965 MG Magnette across 13 subcategories and 7 brands, covering the 1.6L L4 engine. Each part is matched to the engine(s) it fits.
What are the signs of engine problems on a 1965 MG Magnette?
Common symptoms include oil spots under the vehicle, blue or white exhaust smoke, ticking from the valvetrain, or coolant mysteriously disappearing. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.
What should I replace at the same time?
Where labor overlaps, replace the seals and gaskets for anything you open up; a timing job should always include the tensioner and guides, not just the belt or chain.
What do the market flags (US, CA, MX) on each part mean?
They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1965 MG Magnette was originally sold in the US, the safest choice is a part marked for the US market.
How do I make sure a part fits my 1965 MG Magnette?
Every part on this page is matched to the 1.6L L4 engine. Then engine hard parts are unforgiving of guesswork — confirm the casting or engine code before ordering, because one model year can hide two different blocks. The notes column carries position and trim qualifiers where they apply.
Other Parts for the 1965 MG Magnette
Engine Parts for Other MG Magnette Years
Switch vehicle or jump to a subcategory
Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.