This page lists 6 electrical parts for the 1958 Morris Oxford, across 2 part types, covering the 1.5L L4 engine. Every part shows its brand, manufacturer part number and fitment notes.
On the 1958 Morris Oxford, the electrical system covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors. All 6 listed parts are Alternator / Generator End Bearing (4 parts) and Battery Cable (2 parts).
Every part on this page is matched to the 1.5L L4 — the only engine offered in the 1958 Morris Oxford.
The most listed brands for 1958 Morris Oxford electrical parts are SCHAEFFLER (2 parts), SKF (2 parts) and STANDARD MOTOR PRODUCTS (2 parts).
Each part number listed for the 1958 Morris Oxford opens a page with every vehicle that part fits.
Alternator / Generator End Bearing
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| SCHAEFFLER | 6202 | 🇺🇸 US | Front35 mm Outside Diameter | View on Amazon |
| SCHAEFFLER | 6203C3 | 🇺🇸 US | Rear12 MM Width | View on Amazon |
| SKF | 6203J | 🇺🇸 US | Rear | View on Amazon |
| SKF | 6202J | 🇺🇸 US | Front | View on Amazon |
This table covers the bearings in the alternator housing. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly.
4 Alternator / Generator End Bearing parts for the 1958 Morris Oxford come from 2 brands — SCHAEFFLER and SKF.
Part numbers include SCHAEFFLER 6202, SCHAEFFLER 6203C3 and SKF 6203J, among others listed above.
Battery Cable
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| STANDARD MOTOR PRODUCTS | A126 | 🇺🇸 US | PositiveBATTERY TO SWITCH | View on Amazon |
| STANDARD MOTOR PRODUCTS | B14 | 🇺🇸 US | NegativeBATTERY TO GROUND | View on Amazon |
This table covers the positive and ground cables that run from the battery. Typical signs include a stretched or frayed cable, or a control that no longer reaches the end of its travel. Route the new cable through the same clips. A kinked cable binds and fails early.
STANDARD MOTOR PRODUCTS supplies both parts for the 1958 Morris Oxford.
Part numbers include STANDARD MOTOR PRODUCTS A126 and STANDARD MOTOR PRODUCTS B14.
Buying Electrical Parts for a 1958 Morris Oxford
On this vehicle, the electrical system covers charging, starting and the sensors and modules the vehicle relies on, from alternator and starter to oxygen sensors.
- Confirm you have the 1.5L L4 engine — every part on this page is matched to it.
- Read the notes on each row for position, trim and spec qualifiers before you order.
- Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.
- Cross-reference the manufacturer part number against your old part or a service-manual listing.
Start with the largest groups on this page: Alternator / Generator End Bearing and Battery Cable .
Frequently Asked Questions
How many electrical parts fit the 1958 Morris Oxford?
Our catalog currently lists 6 electrical parts for the 1958 Morris Oxford across 2 subcategories and 3 brands, covering the 1.5L L4 engine. Each part is matched to the engine(s) it fits.
What are the signs of electrical problems on a 1958 Morris Oxford?
Common symptoms include slow cranking on cold mornings, a battery light that flickers, dim lights at idle, or a check-engine code pointing at a sensor circuit. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.
What should I replace at the same time?
Where labor overlaps, clean or renew the battery terminals and grounds with any charging-system repair.
What do the market flags (US, CA, MX) on each part mean?
They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 1958 Morris Oxford was originally sold in the US, the safest choice is a part marked for the US market.
How do I make sure a part fits my 1958 Morris Oxford?
Every part on this page is matched to the 1.5L L4 engine. Then test before replacing — a failed alternator and a bad ground can look identical, and sensors are frequently condemned for wiring faults. The notes column carries position and trim qualifiers where they apply.
Other Parts for the 1958 Morris Oxford
Electrical Parts for Other Morris Oxford Years
Switch vehicle or jump to a subcategory
Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.