2011 Nissan Cabstar Engine Parts

This table covers the camshafts that open the valves. Read more

AJUSA supplies both parts for the 2011 Nissan Cabstar.

Part numbers include AJUSA 93144800 and AJUSA 93144900.

This table covers the bearings in the connecting-rod big ends. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

One part is listed for the 2011 Nissan Cabstar — KING ENGINE BEARINGS CR4500CA.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

3 Conversion / Lower Gasket Set parts are listed for the 2011 Nissan Cabstar, from ELRING and AJUSA.

This group includes AJUSA 54157800, ELRING 903790 and ELRING 903780.

This table covers the main bearings that support the crankshaft in the block. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

This group shows a single part: KING ENGINE BEARINGS MB5429SI.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Crankshaft Seal parts for the 2011 Nissan Cabstar come from 2 brands — ELRING and AJUSA. The "Popular" part is AJUSA 15060100.

Part numbers include AJUSA 15060100, AJUSA 15079100 and ELRING 902980, among others listed above.

This table covers the bolts that clamp the cylinder head to the block. Read more

2 Cylinder Head Bolt parts are listed for the 2011 Nissan Cabstar, from AJUSA and ELRING.

This group includes AJUSA 81031000 and ELRING 331520.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

ELRING supplies the 6 Cylinder Head Gasket parts for the 2011 Nissan Cabstar. ELRING 715100 carries the "Popular" badge.

This group includes ELRING 715100, ELRING 715130 and ELRING 715170 and the remaining parts above.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

6 Cylinder Head Gasket Set parts are listed for the 2011 Nissan Cabstar, from ELRING and AJUSA. ELRING 372550 carries the "Popular" badge.

This group includes ELRING 372550, ELRING 496050 and AJUSA 53026400 and the remaining parts above.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

4 Engine Kit Gasket Set parts are listed for the 2011 Nissan Cabstar, from ELRING and AJUSA.

Part numbers include AJUSA 51032100, ELRING 383680 and ELRING 518670, among others listed above.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

This group shows a single part: QUALCAST 1030113.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Intake Manifold Gasket parts are listed for the 2011 Nissan Cabstar, from ELRING and AJUSA.

Listed part numbers: AJUSA 13220800, ELRING 900230 and ELRING 517600, plus the other parts above.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

This group shows a single part: QUALCAST 1030112.

This table covers the Oil Cooler Mounting kits. Read more

HAYDEN supplies both parts for the 2011 Nissan Cabstar.

This group includes HAYDEN 238 and HAYDEN 153.

This table covers the drain plugs in the oil pan. Read more

This group shows a single part: ELRING 587290.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Oil Drain Plug Gasket parts are listed for the 2011 Nissan Cabstar, from AJUSA and ELRING.

This group includes AJUSA 21011400 and ELRING 776327.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

6 Oil Filter parts for the 2011 Nissan Cabstar come from 4 brands — VARIOUS MFR, MANN, PRO-TEC and 1 other brand. The "Popular" part is VARIOUS MFR PG4670.

The Economy section lists 2 options from VARIOUS MFR and PRO-TEC — the catalog's value-priced group. VARIOUS MFR PG4670 is listed in this group.

In the Standard Replacement grade, MANN, WIX and VARIOUS MFR supply 4 parts: built to original-equipment specification. A representative part number is WIX 51521.

Listed part numbers: VARIOUS MFR PG4670, PRO-TEC PXL51521 and WIX 51521, plus the other parts above.

This table covers the Thrust washers. Read more

This group shows a single part: MAHLE / CLEVITE TW716S.

This table covers kits that group a timing chain with the related tensioners and guides. Read more

This group shows a single part: INA ZC0117K.

This table covers the gaskets that seal the Timing Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Timing Cover Gasket parts for the 2011 Nissan Cabstar come from ELRING.

This group includes ELRING 469280, ELRING 902990 and ELRING 902970.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Turbocharger Gasket parts are listed for the 2011 Nissan Cabstar, from AJUSA and ELRING.

This group includes AJUSA JTC12101, AJUSA JTC11623 and ELRING 941850 and the remaining parts above.

This table covers the fasteners that mount the turbocharger. Read more

ELRING supplies both parts for the 2011 Nissan Cabstar.

This group includes ELRING 964480 and ELRING 964490.

This table covers the Turbocharger Oil lines. Typical signs include a wet fitting, a rusted pipe, or a pressure loss in this circuit. Flare or thread the new line the way the notes specify; a kinked replacement will fail early. Read more

2 Turbocharger Oil Line parts for the 2011 Nissan Cabstar come from AJUSA.

Part numbers include AJUSA OP10412 and AJUSA OP11095.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

5 Valve Cover Gasket parts for the 2011 Nissan Cabstar come from 2 brands — ELRING and AJUSA. The "Popular" part is ELRING 547310.

Listed part numbers: ELRING 547310, AJUSA 11092000 and ELRING 903030, plus the other parts above.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Valve Stem Seal parts for the 2011 Nissan Cabstar come from 2 brands — AJUSA and ELRING.

Part numbers include AJUSA 12012100, AJUSA 57024800 and ELRING 012410.