2013 Nissan Rogue Drivetrain Parts

This table covers the seals where an axle shaft exits the housing. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Axle Shaft Seal parts are listed for the 2013 Nissan Rogue, from SCHAEFFLER and TIMKEN.

This group includes SCHAEFFLER SS6653 and TIMKEN SL260464.

This table covers the complete CV axle shafts from differential (or hub) to wheel. Typical signs include a click in tight turns, grease flung around the wheel well, or a vibration that builds with speed. A torn boot caught early is a boot kit; caught late it is the whole axle. Torque the axle nut to the method in the notes. Read more

28 CV Axle parts are listed for the 2013 Nissan Rogue, from GSP, TOP NOTCH, TRAKMOTIVE and 3 other brands. TOP NOTCH TN13237XD carries the "Popular" badge. Grades run from Economy through Standard Replacement; Standard Replacement is the most populated section, led by GSP, TRAKMOTIVE, TOP NOTCH and 2 other brands.

This table covers the brackets that mount the CV Axle Support Bearing. Typical signs include a cracked mount, a rattle, or a bracket that no longer holds alignment. Confirm position in the notes. Many brackets look alike and bolt to different corners. Read more

This group shows a single part: DORMAN 926197.

This table covers the constant-velocity joints at each end of a drive axle. Read more

5 CV Joint parts are listed for the 2013 Nissan Rogue, from NISSAN, ACKOJA and GKN. NISSAN 39771JG04C carries the "Popular" badge.

This group includes NISSAN 39771JG04C, ACKOJA A389966 and ACKOJA A389979 and the remaining parts above.

This table covers the boots that keep grease in a CV joint. Typical signs include a split boot, grease flung around the joint, or a click once grit is inside. A boot caught early is a kit. Once the joint has clicked, the joint itself is usually worn. Read more

7 CV Joint Boot parts are listed for the 2013 Nissan Rogue, from MEVOTECH, BECK/ARNLEY, GKN and 1 other brand. MEVOTECH DX655 carries the "Popular" badge.

Listed part numbers: MEVOTECH DX655, MEVOTECH DX787 and ACKOJA A389767, plus the other parts above.

This table covers the bearings and races that support the differential carrier. Read more

5 Differential Carrier Bearing / Race parts are listed for the 2013 Nissan Rogue, from WJB / INMOTION PARTS, BCA and NATIONAL. NATIONAL 32010X carries the "Popular" badge.

In the Economy grade, WJB / INMOTION PARTS supplies 2 parts: the catalog's value-priced group. A representative part number is WJB / INMOTION PARTS WT32010X.

The Standard Replacement section lists 3 options from BCA and NATIONAL — built to original-equipment specification. NATIONAL 32010X is listed in this group.

Part numbers include NATIONAL 32010X, WJB / INMOTION PARTS WT32010X and WJB / INMOTION PARTS WT30207, among others listed above.

This table covers the bearings and races on the differential pinion. Read more

7 Differential Pinion Bearing / Race parts for the 2013 Nissan Rogue come from 4 brands — SKF, WJB / INMOTION PARTS, BCA and 1 other brand. The "Popular" part is BCA NB32206.

The Economy section: 2 options from WJB / INMOTION PARTS. WJB / INMOTION PARTS WTA32 is listed in this group.

Standard Replacement: 5 parts, from SKF, BCA and SCHAEFFLER. A representative part number is BCA NB32206.

Part numbers include BCA NB32206, WJB / INMOTION PARTS WTA32 and WJB / INMOTION PARTS WT32206, among others listed above.

This table covers the seals at the differential pinion yoke. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

6 Differential Pinion Seal parts are listed for the 2013 Nissan Rogue, from SKF, TIMKEN and WJB / INMOTION PARTS. SKF 14213A carries the "Popular" badge.

This group includes SKF 14213A, SKF 19972A and TIMKEN SL260484 and the remaining parts above.

This table covers the wear sleeves used to restore a Differential seal surface. Read more

3 Differential Repair Sleeve parts for the 2013 Nissan Rogue come from 3 brands — BCA, NATIONAL and WJB / INMOTION PARTS.

Listed part numbers: BCA NS99147, NATIONAL 99147 and WJB / INMOTION PARTS WS99147.

This table covers the seals at the Differential. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Differential Seal parts for the 2013 Nissan Rogue come from 2 brands — NATIONAL and WJB / INMOTION PARTS.

This group includes NATIONAL 710986 and WJB / INMOTION PARTS WS710986.

This table covers the driveshafts that carry torque from the transmission or transfer case. Read more

8 Drive Shaft parts for the 2013 Nissan Rogue come from 8 brands — SKP, TOP NOTCH, CARDONE and 5 other brands. The "Popular" part is SKP SK946236.

Part numbers include SKP SK946236, TOP NOTCH TN5310PS and CARDONE 656000, among others listed above.

This table covers the gear oils specified for the axle or transfer case. Typical signs include a low-oil lamp, knocking, or oil that has gone thin before the next interval. Match the viscosity and spec in the notes, not just the weight on the bottle. Read more

8 Gear Oil parts are listed for the 2013 Nissan Rogue, from VALVOLINE, LUCAS OIL and MOBIL. MOBIL 104361 carries the "Popular" badge.

In the SAE 75W-90 grade, MOBIL supplies 1 part: grouped under the catalog's "SAE 75W-90" designation — the notes column spells out what sets them apart. A representative part number is MOBIL 104361.

In the SAE 80W-90 grade, VALVOLINE and LUCAS OIL supply 7 parts: grouped under the catalog's "SAE 80W-90" designation — the notes column spells out what sets them apart. A representative part number is VALVOLINE VV831.

Part numbers include MOBIL 104361, VALVOLINE VV831 and LUCAS OIL 10043, among others listed above.

This table covers the fluids specified for the transfer case. Typical signs include discolored fluid, a burnt smell, or a level that keeps dropping. Use only the specification in the notes — the tables group grades because they are not interchangeable. Read more

8 Transfer Case Fluid parts are listed for the 2013 Nissan Rogue, from VALVOLINE, LUCAS OIL and MOBIL. MOBIL 104361 carries the "Popular" badge.

SAE 75W-90: 1 part, from MOBIL. A representative part number is MOBIL 104361.

SAE 80W-90: 7 parts, from VALVOLINE and LUCAS OIL. A representative part number is VALVOLINE VV831.

Listed part numbers: MOBIL 104361, VALVOLINE VV831 and LUCAS OIL 10043, plus the other parts above.

This table covers the Transfer Case Input Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

4 Transfer Case Input Shaft Bearing parts are listed for the 2013 Nissan Rogue, from SCHAEFFLER and SKF.

Listed part numbers: SCHAEFFLER 30304A, SCHAEFFLER 32010X and SKF BR30304, plus the other parts above.

This table covers the wear sleeves used to restore a Transfer Case Input Shaft seal surface. Read more

2 Transfer Case Input Shaft Repair Sleeve parts for the 2013 Nissan Rogue come from 2 brands — BCA and WJB / INMOTION PARTS.

Part numbers include BCA NS99220 and WJB / INMOTION PARTS WS99220.

This table covers the seals at the Transfer Case Input Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

3 Transfer Case Input Shaft Seal parts for the 2013 Nissan Rogue come from 2 brands — WJB / INMOTION PARTS and SKF.

Part numbers include SKF 22135A, WJB / INMOTION PARTS WS22135A and WJB / INMOTION PARTS WS710924.

This table covers the Transfer Case Output Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

7 Transfer Case Output Shaft Bearing parts for the 2013 Nissan Rogue come from 4 brands — WJB / INMOTION PARTS, BCA, SKF and 1 other brand. The "Popular" part is BCA NB32206.

The Economy section: 2 options from WJB / INMOTION PARTS. WJB / INMOTION PARTS WT32205 is listed in this group.

Standard Replacement: 5 parts, from BCA, SKF and NATIONAL. A representative part number is BCA NB32206.

This group includes BCA NB32206, WJB / INMOTION PARTS WT32205 and WJB / INMOTION PARTS WT32206 and the remaining parts above.

This table covers the seals at the Transfer Case Output Shaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Transfer Case Output Shaft Seal parts are listed for the 2013 Nissan Rogue, from SKF and WJB / INMOTION PARTS.

Listed part numbers: SKF 13733A and WJB / INMOTION PARTS WS13733A.

This table covers the Transfer Case Pinion Shaft bearings. Typical signs include a growl that rises with speed, or play in the shaft or hub. Set preload the way the notes specify. A dry or crushed bearing fails quickly. Read more

4 Transfer Case Pinion Shaft Bearing parts for the 2013 Nissan Rogue come from 4 brands — BCA, NATIONAL, SCHAEFFLER and 1 other brand.

Part numbers include BCA NS99139, NATIONAL 99139 and SCHAEFFLER SR3472, among others listed above.