2014 Nissan Tsuru Engine Parts

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

This group shows a single part: SCHAEFFLER SS2377.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2014 Nissan Tsuru — AJUSA 54125200.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

4 Crankshaft Seal parts for the 2014 Nissan Tsuru come from 3 brands — AJUSA, ELRING and VICTOR REINZ.

This group includes AJUSA 15016900, AJUSA 15060100 and ELRING 151510 and the remaining parts above.

This table covers the bolts that clamp the cylinder head to the block. Read more

One part is listed for the 2014 Nissan Tsuru — AJUSA 81002600.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2014 Nissan Tsuru — AJUSA 10068000.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2014 Nissan Tsuru — AJUSA 52208600.

This table covers the wear sleeves used to restore a Cylinder seal surface. Read more

MELLING supplies both parts for the 2014 Nissan Tsuru.

Listed part numbers: MELLING CSL250 and MELLING CSL150.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

One part is listed for the 2014 Nissan Tsuru — AJUSA 50223500.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

3 Harmonic Balancer parts are listed for the 2014 Nissan Tsuru, from PIONEER and ATP.

Part numbers include ATP 102477, PIONEER DA6024 and PIONEER DA7047.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2014 Nissan Tsuru — AJUSA 13132100.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

5 Motor Mount parts for the 2014 Nissan Tsuru come from 2 brands — ANCHOR and DEA / MARMON RIDE CONTROL. The "Popular" part is DEA / MARMON RIDE CONTROL A6331.

This group includes DEA / MARMON RIDE CONTROL A6331, ANCHOR 8427 and ANCHOR 8701 and the remaining parts above.

This table covers the Motor Mount bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

This group shows a single part: DEA / MARMON RIDE CONTROL AM331.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

2 Oil parts for the 2014 Nissan Tsuru come from VALVOLINE.

Part numbers include VALVOLINE VV935 and VALVOLINE 881165.

This table covers the Oil Cooler Mounting kits. Read more

HAYDEN supplies both parts for the 2014 Nissan Tsuru.

Listed part numbers: HAYDEN 238 and HAYDEN 153.

This table covers the drain plugs in the oil pan. Read more

3 Oil Drain Plug parts for the 2014 Nissan Tsuru come from 2 brands — DORMAN and AGS.

Listed part numbers: AGS ODP00011, DORMAN 090038 and DORMAN 090049.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

3 Oil Drain Plug Gasket parts are listed for the 2014 Nissan Tsuru, from DORMAN and AJUSA.

Listed part numbers: AJUSA 18000900, DORMAN 097134 and DORMAN 997134CD.

This table covers the caps on the oil filler neck. Read more

2 Oil Filler Cap parts for the 2014 Nissan Tsuru come from 2 brands — GATES and MOTORAD.

Part numbers include GATES 31115 and MOTORAD MO107.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

12 Oil Filter parts for the 2014 Nissan Tsuru come from 9 brands — PUROLATOR, VARIOUS MFR, FVP and 6 other brands. The "Popular" part is VARIOUS MFR PG4476.

The Economy section lists 6 options from PUROLATOR, VARIOUS MFR, FVP and 1 other brand — the catalog's value-priced group. VARIOUS MFR PG4476 is listed in this group.

The High Performance / Heavy Duty section lists 1 option from MOBIL — grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. MOBIL M1103A is listed in this group.

In the Standard Replacement grade, MAHLE / CLEVITE, ACDELCO, HASTINGS / BALDWIN and 2 other brands supply 5 parts: built to original-equipment specification. A representative part number is MAHLE / CLEVITE OC707.

This table covers the oil pans that hold the engine's oil sump. Read more

3 Oil Pan parts are listed for the 2014 Nissan Tsuru, from DORMAN, SKP and SPECTRA PREMIUM.

Part numbers include DORMAN 264500, SKP SK264500 and SPECTRA PREMIUM NSP01A.

This table covers the rings that seal each piston to the cylinder wall. Read more

HASTINGS MANUFACTURING supplies both parts for the 2014 Nissan Tsuru.

Listed part numbers: HASTINGS MANUFACTURING 2C4659 and HASTINGS MANUFACTURING 2C4659S.

This table covers the timing chains that keep the cams in time with the crank. Read more

4 Timing Chain parts are listed for the 2014 Nissan Tsuru, from CLOYES and FVP.

Listed part numbers: CLOYES 94174 and CLOYES 94175, plus the other parts above.

This table covers kits that group a timing chain with the related tensioners and guides. Read more

This group shows a single part: INA ZC94174S.

This table covers the guides and dampers that keep the timing chain on its path. Read more

2 Timing Chain Guide / Damper parts are listed for the 2014 Nissan Tsuru, from CLOYES and FVP.

This group includes CLOYES 95347 and the remaining parts above.

This table covers the tensioners that keep the timing chain taut. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

2 Timing Chain Tensioner parts for the 2014 Nissan Tsuru come from 2 brands — CLOYES and FVP.

This group includes CLOYES 95230 and the remaining parts above.

This table covers the Torque Strut mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

One part is listed for the 2014 Nissan Tsuru — ANCHOR 8130.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 56022000.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Valve Stem Seal parts for the 2014 Nissan Tsuru come from AJUSA.

Listed part numbers: AJUSA 57017900 and AJUSA 12009100.