2013 Nissan Tsuru Engine Parts

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Camshaft Seal parts are listed for the 2013 Nissan Tsuru, from ELRING and SCHAEFFLER.

Part numbers include ELRING 151510 and SCHAEFFLER SS2377.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54125200.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Crankshaft Seal parts are listed for the 2013 Nissan Tsuru, from AJUSA, ELRING and VICTOR REINZ. AJUSA 15060100 carries the "Popular" badge.

This group includes AJUSA 15060100, AJUSA 15016900 and ELRING 151510 and the remaining parts above.

This table covers the bolts that clamp the cylinder head to the block. Read more

2 Cylinder Head Bolt parts for the 2013 Nissan Tsuru come from 2 brands — AJUSA and ELRING.

Part numbers include AJUSA 81002600 and ELRING 709940.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts for the 2013 Nissan Tsuru come from 2 brands — AJUSA and ELRING.

Listed part numbers: AJUSA 10068000 and ELRING 920178.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 52208600.

This table covers the wear sleeves used to restore a Cylinder seal surface. Read more

2 Cylinder Repair Sleeve parts for the 2013 Nissan Tsuru come from MELLING.

Listed part numbers: MELLING CSL250 and MELLING CSL150.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 50223500.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

One part is listed for the 2013 Nissan Tsuru — QUALCAST 1010225.

This table covers the Expansion plugs. Typical signs include a leak at the drain or glow-plug hole, or a plug that has rounded off. Replace the crush washer and torque to the spec in the notes. Read more

2 Expansion Plug parts for the 2013 Nissan Tsuru come from QUALCAST.

Part numbers include QUALCAST 970236 and QUALCAST 970236B.

This table covers the crankshaft pulleys / harmonic balancers at the front of the engine. Read more

3 Harmonic Balancer parts for the 2013 Nissan Tsuru come from 2 brands — PIONEER and ATP.

Listed part numbers: ATP 102477, PIONEER DA6024 and PIONEER DA7047.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Intake Manifold Gasket parts for the 2013 Nissan Tsuru come from 2 brands — AJUSA and ELRING.

This group includes AJUSA 13132100 and ELRING 071440.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

One part is listed for the 2013 Nissan Tsuru — QUALCAST 1010224.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

9 Motor Mount parts are listed for the 2013 Nissan Tsuru, from WESTAR, ANCHOR and DEA / MARMON RIDE CONTROL. ANCHOR 8122 carries the "Popular" badge.

Listed part numbers: ANCHOR 8122, DEA / MARMON RIDE CONTROL A6331 and ANCHOR 8427, plus the other parts above.

This table covers the Motor Mount bushings. Typical signs include a clunk over bumps, or a torn or walked-out bushing you can see. Press the new bushing square. A cocked bushing will tear in a few thousand miles. Read more

2 Motor Mount Bushing parts are listed for the 2013 Nissan Tsuru, from DEA / MARMON RIDE CONTROL and WESTAR.

This group includes DEA / MARMON RIDE CONTROL AM331 and WESTAR EM7119.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

VALVOLINE supplies both parts for the 2013 Nissan Tsuru.

This group includes VALVOLINE VV935 and VALVOLINE 881165.

This table covers the Oil Cooler Mounting kits. Read more

2 Oil Cooler Mounting Kit parts for the 2013 Nissan Tsuru come from HAYDEN.

Part numbers include HAYDEN 238 and HAYDEN 153.

This table covers the drain plugs in the oil pan. Read more

4 Oil Drain Plug parts are listed for the 2013 Nissan Tsuru, from DORMAN, AGS and ELRING.

Part numbers include AGS ODP00011, DORMAN 090038 and DORMAN 090049, among others listed above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Oil Drain Plug Gasket parts for the 2013 Nissan Tsuru come from 3 brands — DORMAN, AJUSA and ELRING.

This group includes AJUSA 18000900, DORMAN 097134 and DORMAN 997134CD and the remaining parts above.

This table covers the caps on the oil filler neck. Read more

2 Oil Filler Cap parts are listed for the 2013 Nissan Tsuru, from GATES and MOTORAD.

This group includes GATES 31115 and MOTORAD MO107.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

11 Oil Filter parts are listed for the 2013 Nissan Tsuru, from PUROLATOR, VARIOUS MFR, FVP and 5 other brands. VARIOUS MFR PG4476 carries the "Popular" badge.

In the Economy grade, PUROLATOR, VARIOUS MFR, FVP and 1 other brand supply 6 parts: the catalog's value-priced group. A representative part number is VARIOUS MFR PG4476.

In the High Performance / Heavy Duty grade, MOBIL supplies 1 part: grouped under the catalog's "High Performance / Heavy Duty" designation — the notes column spells out what sets them apart. A representative part number is MOBIL M1103A.

The Standard Replacement section lists 4 options from MAHLE / CLEVITE, ACDELCO, VARIOUS MFR and 1 other brand — built to original-equipment specification. MAHLE / CLEVITE OC707 is listed in this group.

This table covers the oil pans that hold the engine's oil sump. Read more

3 Oil Pan parts for the 2013 Nissan Tsuru come from 3 brands — DORMAN, SKP and SPECTRA PREMIUM.

This group includes DORMAN 264500, SKP SK264500 and SPECTRA PREMIUM NSP01A.

This table covers the rings that seal each piston to the cylinder wall. Read more

This group shows a single part: HASTINGS MANUFACTURING 2C4659S.

This table covers the timing chains that keep the cams in time with the crank. Read more

4 Timing Chain parts for the 2013 Nissan Tsuru come from 2 brands — CLOYES and FVP.

This group includes CLOYES 94174 and CLOYES 94175 and the remaining parts above.

This table covers kits that group a timing chain with the related tensioners and guides. Read more

One part is listed for the 2013 Nissan Tsuru — INA ZC94174S.

This table covers the guides and dampers that keep the timing chain on its path. Read more

2 Timing Chain Guide / Damper parts for the 2013 Nissan Tsuru come from 2 brands — CLOYES and FVP.

Listed part numbers: CLOYES 95347, plus the other parts above.

This table covers the tensioners that keep the timing chain taut. Typical signs include belt flutter, a chirp that returns after a new belt, or an arm that no longer damps. Replace the tensioner with the belt at higher mileage. Read more

2 Timing Chain Tensioner parts are listed for the 2013 Nissan Tsuru, from CLOYES and FVP.

Listed part numbers: CLOYES 95230, plus the other parts above.

This table covers the Torque Strut mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

This group shows a single part: ANCHOR 8130.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

4 Valve Cover Gasket parts are listed for the 2013 Nissan Tsuru, from ELRING and AJUSA.

Part numbers include AJUSA 56022000, ELRING 056790 and ELRING 389330, among others listed above.

This table covers the pressed-in bronze and cast-iron guides that align valve stems. Typical signs include oil smoke on startup, a guide that has gone oval, or a valve that no longer seats quietly. Guides are a machine-shop fit. Confirm stem diameter in the notes before ordering. Read more

QUALCAST supplies both parts for the 2013 Nissan Tsuru.

Listed part numbers: QUALCAST 308213 and QUALCAST 308218.

This table covers the lifters / tappets that transfer cam motion to the valves. Read more

One part is listed for the 2013 Nissan Tsuru — QUALCAST 362284.

This table covers the Valve seats. Read more

This group shows a single part: QUALCAST 21106250.

This table covers the keepers that lock each valve-spring retainer to the stem. Read more

This group shows a single part: QUALCAST 345012.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

5 Valve Stem Seal parts are listed for the 2013 Nissan Tsuru, from QUALCAST, AJUSA and ELRING. QUALCAST 3896245 carries the "Popular" badge.

Listed part numbers: QUALCAST 3896245, AJUSA 57017900 and AJUSA 12009100, plus the other parts above.