2000 Peugeot 206 Engine Parts

This table covers the camshafts that open the valves. Read more

This group shows a single part: AJUSA 93123000.

This table covers the seals at each camshaft end. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Camshaft Seal parts are listed for the 2000 Peugeot 206, from AJUSA and ELRING.

This group includes AJUSA 15014700 and ELRING 505100.

This table covers lower / conversion gasket sets for oil-pan and related joints. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

This group shows a single part: AJUSA 54131300.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

AJUSA supplies both parts for the 2000 Peugeot 206.

Listed part numbers: AJUSA 15084700 and AJUSA 15084800.

This table covers the bolts that clamp the cylinder head to the block. Read more

This group shows a single part: AJUSA 81006700.

This table covers the head gaskets that seal the block to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

2 Cylinder Head Gasket parts for the 2000 Peugeot 206 come from AJUSA.

Part numbers include AJUSA 10155600 and AJUSA 10155610.

This table covers multi-piece gasket sets for a cylinder-head job. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

3 Cylinder Head Gasket Set parts for the 2000 Peugeot 206 come from 2 brands — ELRING and AJUSA.

This group includes AJUSA 52216500, ELRING 380290 and ELRING 374650.

This table covers the wear sleeves used to restore a Cylinder seal surface. Read more

This group shows a single part: AJUSA 60002600.

This table covers full gasket kits covering the joints opened in an engine rebuild. Typical signs include the leaks that sent the engine or gearbox to the bench. Use every gasket the set is meant for that opening — leftover unused pieces usually belong to another configuration. Read more

2 Engine Kit Gasket Set parts for the 2000 Peugeot 206 come from 2 brands — AJUSA and ELRING.

Listed part numbers: AJUSA 50232400 and ELRING 867540.

This table covers the exhaust valves that let combustion gas out of the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

One part is listed for the 2000 Peugeot 206 — QUALCAST 1030117.

This table covers the gaskets between the intake manifold and the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 77013200.

This table covers the gaskets that seal the Intake Plenum. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2000 Peugeot 206 — AJUSA 28006000.

This table covers the intake valves that let air (and fuel, on port-injected engines) into the cylinder. Typical signs include a circuit that will not hold, a whistle, or a code for this valve. A stuck valve is often debris. Clean the ports before installing the new one. Read more

One part is listed for the 2000 Peugeot 206 — QUALCAST 1030116.

This table covers the mounts that hold the engine to the chassis. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

DEA / MARMON RIDE CONTROL supplies the 4 Motor Mount parts for the 2000 Peugeot 206.

Part numbers include DEA / MARMON RIDE CONTROL AM704, DEA / MARMON RIDE CONTROL AM700 and DEA / MARMON RIDE CONTROL AM701, among others listed above.

This table covers the crush washers and gaskets under the oil drain plug. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 00502300.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

9 Oil Filter parts are listed for the 2000 Peugeot 206, from MANN, WIX, FVP and 4 other brands. MANN HU71151X carries the "Popular" badge.

In the Economy grade, FVP, PRO-TEC, PUROLATOR and 1 other brand supply 4 parts: the catalog's value-priced group. A representative part number is FVP G7512.

The Standard Replacement section lists 5 options from MANN, WIX and MAHLE / CLEVITE — built to original-equipment specification. MANN HU71151X is listed in this group.

This group includes MANN HU71151X, FVP G7512 and PRO-TEC PXL57512 and the remaining parts above.

This table covers the rings that seal each piston to the cylinder wall. Read more

2 Piston Ring parts for the 2000 Peugeot 206 come from HASTINGS MANUFACTURING.

Listed part numbers: HASTINGS MANUFACTURING 2C9372S and HASTINGS MANUFACTURING 2C9372.

This table covers the gaskets that seal the Timing Cover. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2000 Peugeot 206 — AJUSA 77099200.

This table covers the gaskets that seal the valve cover to the cylinder head. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

One part is listed for the 2000 Peugeot 206 — AJUSA 11023900.

This table covers the seals on each valve stem that control oil into the guides. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

One part is listed for the 2000 Peugeot 206 — AJUSA 57013400.