This page lists one electrical connector part for the 2008 Peugeot 607: an On-Board Diagnostic (OBD) Port Connector from WELLS, matched to the 2.9L V6 — the only engine offered in the 2008 Peugeot 607.
On the 2008 Peugeot 607, the connector system supplies the pigtails and connector bodies that terminate the vehicle harness at lamps, sensors and modules.
The part number opens a page with every vehicle that part fits.
On-Board Diagnostic (OBD) Port Connector
| Brand | Part Number | Markets | Notes | Buy |
|---|---|---|---|---|
| WELLS | 1P1474 | 🇲🇽 MX | Universal Type | View on Amazon |
This table covers the harness connectors at the On-Board Diagnostic (OBD) Port. Typical signs include an intermittent fault that moves when you wiggle the plug, green corrosion, or a melted housing. Match terminal count and keyway, not just color. Many families look identical and will not lock.
This group shows a single part: WELLS 1P1474.
Buying Electrical Connector Parts for a 2008 Peugeot 607
On this vehicle, the connector system supplies the pigtails and connector bodies that terminate the vehicle harness at lamps, sensors and modules.
- Confirm you have the 2.9L V6 engine — every part on this page is matched to it.
- Read the notes on each row for position, trim and spec qualifiers before you order.
- Where labor overlaps, use heat-shrink crimp connectors rather than twist-and-tape for any pigtail splice, especially outside the cabin.
- Cross-reference the manufacturer part number against your old part or a service-manual listing.
Start with the largest groups on this page: On-Board Diagnostic (OBD) Port Connector .
Frequently Asked Questions
How many electrical connector parts fit the 2008 Peugeot 607?
This page lists one electrical connector part for the 2008 Peugeot 607: an On-Board Diagnostic (OBD) Port Connector from WELLS, covering the 2.9L V6 engine.
What are the signs of electrical connector problems on a 2008 Peugeot 607?
Common symptoms include intermittent faults that move when the harness is wiggled, green corrosion inside a plug, or melted connector housings near heat sources. If you notice any of these, identify the affected subcategory above and cross-reference the part numbers listed.
What should I replace at the same time?
Where labor overlaps, use heat-shrink crimp connectors rather than twist-and-tape for any pigtail splice, especially outside the cabin.
What do the market flags (US, CA, MX) on each part mean?
They show the market for which the manufacturer published application data for that part — where the vehicle was first sold, not where the part was made. If your 2008 Peugeot 607 was originally sold in the US, the safest choice is a part marked for the US market.
How do I make sure a part fits my 2008 Peugeot 607?
Every part on this page is matched to the 2.9L V6 engine. Then match the connector by terminal count and keyway, not just appearance — many families look identical but will not lock. The notes column carries position and trim qualifiers where they apply.
Other Parts for the 2008 Peugeot 607
Switch vehicle or jump to a subcategory
Manufacturer names, model designations and part numbers are used for identification and fitment reference only. AutoFactsDB is an independent catalog and is not affiliated with, endorsed by, or sponsored by any vehicle manufacturer displayed on this page.