2018 Rolls-Royce Wraith Engine Parts

This table covers the sleeves used to restore a grooved crankshaft seal surface. Read more

3 Crankshaft Repair Sleeve parts are listed for the 2018 Rolls-Royce Wraith, from BCA, NATIONAL and WJB / INMOTION PARTS.

This group includes BCA NS99177, NATIONAL 99177 and WJB / INMOTION PARTS WS99177.

This table covers the front and rear seals that keep oil in at the crankshaft. Typical signs include a wet housing, a drip after sitting, or fluid flung off a rotating shaft. Fix the surface the seal rides on. A new seal on a grooved shaft will leak again. Read more

2 Crankshaft Seal parts are listed for the 2018 Rolls-Royce Wraith, from FEL-PRO and WJB / INMOTION PARTS.

Listed part numbers: FEL-PRO BS40779 and WJB / INMOTION PARTS WS710786.

This table covers the engine oils listed by grade and specification for this engine. Typical signs include a low-oil lamp, knocking after a long interval, or oil that has gone thin and black well before the next service. Match the viscosity and spec in the notes (and on the filler cap). The tables group grades — they are not interchangeable. Read more

38 Oil parts are listed for the 2018 Rolls-Royce Wraith, from LIQUI MOLY, VALVOLINE and LUCAS OIL. LIQUI MOLY 20230 carries the "Popular" badge. The notes list position, dimensions and spec qualifiers wherever the manufacturer distinguishes between variants.

This table covers the Oil Cooler mounts. Typical signs include a clunk on takeoff, a vibration at idle, or a separated rubber insert. Support the powertrain before unbolting a mount, and torque the fasteners in the notes. Read more

This group shows a single part: REIN AVM0701.

This table covers the drain plugs in the oil pan. Read more

One part is listed for the 2018 Rolls-Royce Wraith — REIN HWU0115.

This table covers the oil filters that screw onto this engine's filter mount. Typical signs include low oil pressure after a service, or a filter that will not spin off because the old gasket stayed on the block. Lube the new gasket and tighten to the spec on the box; a double-gasket install dumps the sump on the first drive. Read more

5 Oil Filter parts are listed for the 2018 Rolls-Royce Wraith, from VARIOUS MFR, CHAMP / LUBER-FINER, FAMOUS BRAND and 1 other brand. VARIOUS MFR PO5904EX carries the "Popular" badge.

This group includes VARIOUS MFR PO5904EX, CHAMP / LUBER-FINER P987 and FAMOUS BRAND 84189 and the remaining parts above.

This table covers the Oil Filter covers. Read more

4 Oil Filter Cover parts for the 2018 Rolls-Royce Wraith come from 4 brands — DORMAN, REIN, SKP and 1 other brand.

Part numbers include DORMAN 921111, REIN CPL0071 and SKP SK121443, among others listed above.

This table covers the Oil Level Sensor Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

One part is listed for the 2018 Rolls-Royce Wraith — AJUSA 16078850.

This table covers the Turbocharger Boost sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

2 Turbocharger Boost Sensor parts for the 2018 Rolls-Royce Wraith come from 2 brands — NTK and WELLS.

This group includes NTK MA0055 and WELLS 5S13386.

This table covers the gaskets that seal the Turbocharger. Typical signs include seepage at the joint, a burnt-oil smell, or a leak that appears only after a long drive. Clean both flanges and torque in the sequence the notes or the manual call for. Read more

This group shows a single part: AJUSA 01158200.

This table covers the Turbocharger Oil Line Gasket O-rings. Typical signs include a seep at a fitting or a housing that weeps after a service. Lube the new O-ring with the fluid it will see, and do not roll it into the groove. Read more

One part is listed for the 2018 Rolls-Royce Wraith — AJUSA 01335200.