2013 Toyota Camry Electrical Parts

This table covers the alternators that charge the battery and run the electrical load. Typical signs include dim lights at idle, a battery lamp, or a growl from the charging pulley. Load-test the battery and inspect the belt and grounds — a bad ground mimics a failed alternator. Read more

24 Alternator / Generator parts for the 2013 Toyota Camry come from 10 brands — REMY, WAI GLOBAL, BOSCH and 7 other brands. The "Popular" part is REMY 94862.

The New section lists 8 options from REMY, WAI GLOBAL, SKP and 3 other brands — brand-new units rather than rebuilt ones. REMY 94862 is listed in this group.

The Remanufactured section lists 16 options from DENSO, ACDELCO, BOSCH and 5 other brands — factory-rebuilt units with new wear components. DENSO 2101159 is listed in this group.

This table covers the pulleys on the alternator shaft. Typical signs include a growl or chirp that follows engine speed, or a pulley that will not spin freely by hand. Spin each pulley with the belt off. Roughness or play means replace it with the belt. Read more

7 Alternator / Generator Pulley parts are listed for the 2013 Toyota Camry, from CONTINENTAL, LITENS, INA and 2 other brands. INA EA0209 carries the "Popular" badge.

Listed part numbers: INA EA0209, AUTOTECNICA TY1416792 and CONTINENTAL 49931, plus the other parts above.

This table covers the Automatic Headlamp sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

One part is listed for the 2013 Toyota Camry — AUTOTECNICA TY1321507.

This table covers the batteries listed by group size and specification. Typical signs include slow cranking, a battery lamp, or a no-start after the vehicle sat overnight. Confirm group size and terminal layout in the notes. Clean the posts and the ground before condemning the battery. Read more

8 Battery parts are listed for the 2013 Toyota Camry, from DEKA, BOSCH, EXIDE and 3 other brands. DEKA 9A3585 carries the "Popular" badge. 2 parts fit every engine; the other 6 are engine-specific.

Listed part numbers: DEKA 9A3585, DEKA 9A34R and BOSCH S6523B, plus the other parts above.

This table covers the positive and ground cables that run from the battery. Typical signs include a stretched or frayed cable, or a control that no longer reaches the end of its travel. Route the new cable through the same clips. A kinked cable binds and fails early. Read more

This group shows a single part: STANDARD MOTOR PRODUCTS A262L.

This table covers the Battery Cooling fans. Typical signs include overheating at idle, a fan that never comes on, or a blade that hits the shroud. Confirm the fan command and the relay before replacing the assembly. Read more

2 Battery Cooling Fan parts are listed for the 2013 Toyota Camry, from FOUR SEASONS and GPD.

Listed part numbers: FOUR SEASONS 76814 and GPD 2312067.

This table covers the Battery Current sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

This group shows a single part: WELLS 5S16841.

This table covers the clamps and brackets that secure the battery. Read more

2 Battery Hold Down parts for the 2013 Toyota Camry come from 2 brands — SKP and VARIOUS MFR. 1 part fits every engine; the other 1 is engine-specific.

This group includes SKP SK7440404K and VARIOUS MFR TO2996102.

This table covers the terminals and clamps that connect cables to the battery posts. Read more

3 Battery Terminal parts are listed for the 2013 Toyota Camry, from BECK/ARNLEY, DORMAN and STANDARD MOTOR PRODUCTS. All of them fit every engine offered in the 2013 Camry.

Part numbers include BECK/ARNLEY 2060001, DORMAN 926515 and STANDARD MOTOR PRODUCTS BP100P.

This table covers the engine-control modules that run fuel, spark and emissions. Read more

7 Engine Control Module (ECM Computer) parts for the 2013 Toyota Camry come from BSE.

This group includes BSE ECC23131M, BSE ECC23140M and BSE ECC23161M and the remaining parts above.

This table covers the replacement fuses for this vehicle's fuse boxes. Typical signs include one circuit dead while its neighbor still works, or a fuse that blows again as soon as you replace it. Match amperage and fuse type. A repeat blow means a short — find it before the next fuse. Read more

16 Fuse parts are listed for the 2013 Toyota Camry, from LITTELFUSE and BUSSMANN. LITTELFUSE LMIN10 carries the "Popular" badge. All of them fit every engine offered in the 2013 Camry.

The 10 Amp section lists 2 options from LITTELFUSE and BUSSMANN — grouped under the catalog's "10 Amp" designation — the notes column spells out what sets them apart. LITTELFUSE LMIN10 is listed in this group.

In the 15 Amp grade, BUSSMANN and LITTELFUSE supply 2 parts: grouped under the catalog's "15 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM15LP.

In the 20 Amp grade, BUSSMANN and LITTELFUSE supply 2 parts: grouped under the catalog's "20 Amp" designation — the notes column spells out what sets them apart. A representative part number is BUSSMANN ATM20LP.

The 25 Amp section lists 2 options from BUSSMANN and LITTELFUSE — grouped under the catalog's "25 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM25LP is listed in this group.

The 30 Amp section lists 4 options from LITTELFUSE and BUSSMANN — grouped under the catalog's "30 Amp" designation — the notes column spells out what sets them apart. LITTELFUSE JCAS30 is listed in this group.

The 5 Amp section lists 1 option from BUSSMANN — grouped under the catalog's "5 Amp" designation — the notes column spells out what sets them apart. BUSSMANN ATM5LP is listed in this group.

In the 7.5 Amp grade, LITTELFUSE and BUSSMANN supply 3 parts: grouped under the catalog's "7.5 Amp" designation — the notes column spells out what sets them apart. A representative part number is LITTELFUSE MIN75.

This table covers the fuse blocks that hold this vehicle's fuses. Read more

2 Fuse Block parts for the 2013 Toyota Camry come from 2 brands — STANDARD MOTOR PRODUCTS and WELLS. Every part fits all 3 engine options (2.5L L4, 2.5L L4 ELECTRIC/GAS and 3.5L V6).

This group includes STANDARD MOTOR PRODUCTS FH47 and WELLS 6G1076.

This table covers the HID Lighting ballasts. Read more

This group shows a single part: AUTOTECNICA TY1320408.

This table covers the horns mounted in the front of the vehicle. Read more

14 Horn parts are listed for the 2013 Toyota Camry, from FIAMM and HELLA. FIAMM 7210223 carries the "Popular" badge. All of them fit every engine offered in the 2013 Camry.

In the Accessory Replacement grade, FIAMM supplies 7 parts: grouped under the catalog's "Accessory Replacement" designation — the notes column spells out what sets them apart. A representative part number is FIAMM 7210223.

The Standard Replacement section lists 7 options from FIAMM and HELLA — built to original-equipment specification. FIAMM 7200223 is listed in this group.

This table covers the Hybrid Battery Voltage sensors. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

One part is listed for the 2013 Toyota Camry — STANDARD MOTOR PRODUCTS BSC78.

This table covers the key fobs that lock, unlock and start the vehicle. Read more

2 Keyless Entry Remote parts for the 2013 Toyota Camry come from DORMAN.

This group includes DORMAN 99686ST and DORMAN 99686.

This table covers the replacement shells for the key fob. Read more

2 Keyless Entry Remote Case parts for the 2013 Toyota Camry come from DORMAN. Every part fits all 3 engine options (2.5L L4, 2.5L L4 ELECTRIC/GAS and 3.5L V6).

Part numbers include DORMAN 92071 and DORMAN 92069.

This table covers the Lane Departure Camera modules. Typical signs include a cluster of unrelated faults, a no-communication code, or a module that will not sleep. Confirm power, ground and programming compatibility in the notes. Modules are rarely plug-and-play across years. Read more

This group shows a single part: STANDARD MOTOR PRODUCTS LDS16.

This table covers the ultrasonic park-aid sensors in the bumper. Typical signs include a warning lamp, a stored code, or a reading that drops out when the harness is wiggled. Inspect the connector and ground before replacing the sensor — wiring faults are often condemned as bad sensors. Read more

5 Parking Aid Sensor parts for the 2013 Toyota Camry come from 3 brands — HELLA, MARELLI and STANDARD MOTOR PRODUCTS. Every part fits all 3 engine options (2.5L L4, 2.5L L4 ELECTRIC/GAS and 3.5L V6).

Listed part numbers: HELLA 358270021, HELLA 358270151 and MARELLI SDP208, plus the other parts above.

This table covers the speed sensors on the transmission, transfer case or ABS ring. Typical signs include a dead speedometer, harsh transmission shifts, or a code for vehicle speed. Inspect the tone wheel and the connector before replacing the sensor. Read more

20 Speed Sensor parts are listed for the 2013 Toyota Camry, from DELPHI, STANDARD MOTOR PRODUCTS, WELLS and 6 other brands. ULTRA-POWER SC539 carries the "Popular" badge.

In the Economy grade, ULTRA-POWER, BECK/ARNLEY, HOLSTEIN and 2 other brands supply 9 parts: the catalog's value-priced group. A representative part number is ULTRA-POWER SC539.

The Standard Replacement section: 11 options from DELPHI, STANDARD MOTOR PRODUCTS, WELLS and 1 other brand. AISIN RST0041 is listed in this group.

This table covers the starter motors that crank the engine. Typical signs include no motion, a squeal, or a motor that only runs on one speed. Confirm power, ground and the control module before replacing the motor. Read more

16 Starter Motor parts for the 2013 Toyota Camry come from 10 brands — TERREPOWER, WAI GLOBAL, BOSCH and 7 other brands. The "Popular" part is TERREPOWER N17825. 3 parts fit every engine; the other 13 are engine-specific.

The New section: 8 options from TERREPOWER, ULTRA-POWER, WAI GLOBAL and 5 other brands. TERREPOWER N17825 is listed in this group.

The Remanufactured section: 8 options from DENSO, ACDELCO, BOSCH and 5 other brands. DENSO 2800339 is listed in this group.

This table covers the Starter solenoids. Typical signs include a harsh or missing shift, or a code for this solenoid circuit. Check resistance and the connector before dropping the pan for a solenoid. Read more

2 Starter Solenoid parts for the 2013 Toyota Camry come from 2 brands — STANDARD MOTOR PRODUCTS and WELLS. Every part fits all 3 engine options (2.5L L4, 2.5L L4 ELECTRIC/GAS and 3.5L V6).

Part numbers include STANDARD MOTOR PRODUCTS SS770 and WELLS 1M1432.